Hydrogen isotope behavior on a water–metal boundary with simultaneous transfer from and to the metal surface

2014 ◽  
Vol 89 (7-8) ◽  
pp. 1520-1523 ◽  
Author(s):  
Takumi Hayashi ◽  
Kanetsugu Isobe ◽  
Hirofumi Nakamura ◽  
Kazuhiro Kobayashi ◽  
Yasuhisa Oya ◽  
...  
2011 ◽  
Vol 60 (1) ◽  
pp. 369-372 ◽  
Author(s):  
Takumi Hayashi ◽  
Hirofumi Nakamura ◽  
Kanetsugu Isobe ◽  
Kazuhiro Kobayashi ◽  
Makoto Oyaizu ◽  
...  

1993 ◽  
Vol 70-71 ◽  
pp. 99-102 ◽  
Author(s):  
Takashi Momose ◽  
Hideo Hirayama ◽  
Hajime Ishimaru

2007 ◽  
Vol 52 (3) ◽  
pp. 687-691 ◽  
Author(s):  
T. Hayashi ◽  
H. Nakamura ◽  
K. Isobe ◽  
K. Kobayashi ◽  
T. Yamanishi ◽  
...  

2009 ◽  
Vol 56 (2) ◽  
pp. 836-840 ◽  
Author(s):  
Takumi Hayashi ◽  
Hirofumi Nakamura ◽  
Kanetsugu Isobe ◽  
Kazuhiro Kobayashi ◽  
Makoto Oyaizu ◽  
...  

Author(s):  
L.E. Murr ◽  
V. Annamalai

Georgius Agricola in 1556 in his classical book, “De Re Metallica”, mentioned a strange water drawn from a mine shaft near Schmölnitz in Hungary that eroded iron and turned it into copper. This precipitation (or cementation) of copper on iron was employed as a commercial technique for producing copper at the Rio Tinto Mines in Spain in the 16th Century, and it continues today to account for as much as 15 percent of the copper produced by several U.S. copper companies.In addition to the Cu/Fe system, many other similar heterogeneous, electrochemical reactions can occur where ions from solution are reduced to metal on a more electropositive metal surface. In the case of copper precipitation from solution, aluminum is also an interesting system because of economic, environmental (ecological) and energy considerations. In studies of copper cementation on aluminum as an alternative to the historical Cu/Fe system, it was noticed that the two systems (Cu/Fe and Cu/Al) were kinetically very different, and that this difference was due in large part to differences in the structure of the residual, cement-copper deposit.


Author(s):  
A. Elgsaeter ◽  
T. Espevik ◽  
G. Kopstad

The importance of a high rate of temperature decrease (“rapid freezing”) when freezing specimens for freeze-etching has long been recognized1. The two basic methods for achieving rapid freezing are: 1) dropping the specimen onto a metal surface at low temperature, 2) bringing the specimen instantaneously into thermal contact with a liquid at low temperature and subsequently maintaining a high relative velocity between the liquid and the specimen. Over the last couple of years the first method has received strong renewed interest, particularily as the result of a series of important studies by Heuser and coworkers 2,3. In this paper we will compare these two freezing methods theoretically and experimentally.


2004 ◽  
Vol 51 (16) ◽  
pp. 2813-2819 ◽  
Author(s):  
Karina Morgenstern ◽  
Heiko Gawronski ◽  
Michael Mehlhor ◽  
Karl-Heinz Rieder
Keyword(s):  

Author(s):  
Jack Rowbotham ◽  
Oliver Lenz ◽  
Holly Reeve ◽  
Kylie Vincent

<p></p><p>Chemicals labelled with the heavy hydrogen isotope deuterium (<sup>2</sup>H) have long been used in chemical and biochemical mechanistic studies, spectroscopy, and as analytical tracers. More recently, demonstration of selectively deuterated drug candidates that exhibit advantageous pharmacological traits has spurred innovations in metal-catalysed <sup>2</sup>H insertion at targeted sites, but asymmetric deuteration remains a key challenge. Here we demonstrate an easy-to-implement biocatalytic deuteration strategy, achieving high chemo-, enantio- and isotopic selectivity, requiring only <sup>2</sup>H<sub>2</sub>O (D<sub>2</sub>O) and unlabelled dihydrogen under ambient conditions. The vast library of enzymes established for NADH-dependent C=O, C=C, and C=N bond reductions have yet to appear in the toolbox of commonly employed <sup>2</sup>H-labelling techniques due to requirements for suitable deuterated reducing equivalents. By facilitating transfer of deuterium atoms from <sup>2</sup>H<sub>2</sub>O solvent to NAD<sup>+</sup>, with H<sub>2</sub> gas as a clean reductant, we open up biocatalysis for asymmetric reductive deuteration as part of a synthetic pathway or in late stage functionalisation. We demonstrate enantioselective deuteration via ketone and alkene reductions and reductive amination, as well as exquisite chemo-control for deuteration of compounds with multiple unsaturated sites.</p><p></p>


2007 ◽  
Vol 43 (4) ◽  
pp. 239-242
Author(s):  
S. Kh. Suleimanov ◽  
O. A. Dudko ◽  
V. G. Dyskin ◽  
Z. S. Settarova ◽  
M. U. Dzhanklych

Sign in / Sign up

Export Citation Format

Share Document