In situ measurements of the spectral emittance of coal ash deposits

2011 ◽  
Vol 112 (12) ◽  
pp. 1978-1986 ◽  
Author(s):  
Travis J. Moore ◽  
Darron P. Cundick ◽  
Matthew R. Jones ◽  
Dale R. Tree ◽  
R. Daniel Maynes ◽  
...  
Author(s):  
D. Cundick ◽  
D. Maynes ◽  
T. Moore ◽  
D. R. Tree ◽  
M. R. Jones ◽  
...  

This work presents in situ measurements of the effective thermal conductivity in particulate coal ash deposits under both reducing and oxidizing environments. Laboratory experiments generated deposits on an instrumented deposition probe of loosely-bound particulate ash from three coals generated in a down-fired flow reactor with optical access. An approach is presented for making in situ measurements of the temperature difference across the ash deposits, the thickness of the deposits, and the total heat transfer rate through the ash deposits. Using this approach, the effective thermal conductivity was determined for coal ash deposits formed under oxidizing and reducing conditions. Three coals were tested under oxidizing conditions: two bituminous coals derived from the Illinois #6 basin and a subbituminous Powder River Basin coal. The subbituminous coal exhibited the lowest range of effective thermal conductivities (0.05–0.18 W/m· K) while the Illinois #6 coals showed higher effective thermal conductivities (0.2–0.5 W/m· K). One of the bituminous coals and the subbituminous coal were also tested under reducing conditions. A comparison of the ash deposits from these two coals showed no discernible difference in the effective thermal conductivity based on stoichiometry. All experiments indicated an increase in effective thermal conductivity with deposit thickness, probably associated with deposit sintering.


Author(s):  
D. Cundick ◽  
D. Maynes ◽  
T. Moore ◽  
D. R. Tree ◽  
M. R. Jones ◽  
...  

This work presents in situ measurements of the effective thermal conductivity in particulate coal ash deposits under both reducing and oxidizing environments. Laboratory experiments generated deposits on an instrumented deposition probe of loosely bound particulate ash from three coals generated in a down-fired flow reactor with optical access. An approach is presented for making in situ measurements of the temperature difference across the ash deposits, the thickness of the deposits, and the total heat transfer rate through the ash deposits. Using this approach, the effective thermal conductivity was determined for coal ash deposits formed under oxidizing and reducing conditions. Three coals were tested under oxidizing conditions: two bituminous coals derived from the Illinois #6 basin and a subbituminous Powder River Basin coal. The subbituminous coal exhibited the lowest range of effective thermal conductivities (0.05–0.18 W/m K) while the Illinois #6 coals showed higher effective thermal conductivities (0.2–0.5 W/m K). One of the bituminous coals and the subbituminous coal were also tested under reducing conditions. A comparison of the ash deposits from these two coals showed no discernible difference in the effective thermal conductivity based on stoichiometry. All experiments indicated an increase in effective thermal conductivity with deposit thickness, probably associated with deposit sintering.


1989 ◽  
Author(s):  
G. Clark ◽  
M. Holmes ◽  
S. Vecci ◽  
R. Bailey

Author(s):  
Travis J. Moore ◽  
Darron P. Cundick ◽  
Matthew R. Jones ◽  
Dale R. Tree ◽  
R. Daniel Maynes ◽  
...  

An experimental procedure has been developed to make in situ spectral emittance measurements of coal ash deposits. Pulverized coal is injected into a down-fired, entrained-flow reactor. Ash accumulates on a probe placed in the reactor effluent. The spectral emittance of the ash layer is calculated using measurements of the surface temperature and the spectral emissive power of the deposit. Measurements of the spectral emissive power and the surface temperature are obtained using a Fourier transform infrared (FTIR) spectrometer. The methods used to extract the spectral emissive power and surface temperature from measured infrared spectra were validated using a blackbody radiator at known temperatures. The experimental procedure was then used to find the spectral emittance of a coal ash deposit formed under oxidizing conditions.


2019 ◽  
Author(s):  
Michael Stukel ◽  
Thomas Kelly

Thorium-234 (234Th) is a powerful tracer of particle dynamics and the biological pump in the surface ocean; however, variability in carbon:thorium ratios of sinking particles adds substantial uncertainty to estimates of organic carbon export. We coupled a mechanistic thorium sorption and desorption model to a one-dimensional particle sinking model that uses realistic particle settling velocity spectra. The model generates estimates of 238U-234Th disequilibrium, particulate organic carbon concentration, and the C:234Th ratio of sinking particles, which are then compared to in situ measurements from quasi-Lagrangian studies conducted on six cruises in the California Current Ecosystem. Broad patterns observed in in situ measurements, including decreasing C:234Th ratios with depth and a strong correlation between sinking C:234Th and the ratio of vertically-integrated particulate organic carbon (POC) to vertically-integrated total water column 234Th, were accurately recovered by models assuming either a power law distribution of sinking speeds or a double log normal distribution of sinking speeds. Simulations suggested that the observed decrease in C:234Th with depth may be driven by preferential remineralization of carbon by particle-attached microbes. However, an alternate model structure featuring complete consumption and/or disaggregation of particles by mesozooplankton (e.g. no preferential remineralization of carbon) was also able to simulate decreasing C:234Th with depth (although the decrease was weaker), driven by 234Th adsorption onto slowly sinking particles. Model results also suggest that during bloom decays C:234Th ratios of sinking particles should be higher than expected (based on contemporaneous water column POC), because high settling velocities minimize carbon remineralization during sinking.


2013 ◽  
Vol 24 (3) ◽  
pp. 147
Author(s):  
Ming LI ◽  
Qinghua YANG ◽  
Jiechen ZHAO ◽  
Lin ZHANG ◽  
Chunhua LI ◽  
...  

1995 ◽  
Vol 31 (7) ◽  
pp. 51-59 ◽  
Author(s):  
Ian Guymer ◽  
Rob O'Brien

Previously, the design of sewer systems has been limited to studies of their hydraulic characteristics, in particular the ability of the system to convey the maximum discharge. Greater environmental awareness has necessitated that new designs, and some existing schemes, are assessed to determine the environmental load which the scheme will deliver to any downstream component. This paper describes a laboratory programme which has been designed to elucidate the effects of manholes on the longitudinal dispersion of solutes. A laboratory system is described, which allows in situ measurements to be taken of the concentration of a fluorescent solute tracer, both up- and down-stream of a surcharged manhole junction. Results are presented from a preliminary series of studies undertaken for a single manhole geometry over a range of discharges, with varying levels of surcharge. Results are presented showing the variation of travel time, change in second moment of the distribution and of a dispersion factor with surcharge, assuming a Taylor approach and determining the dispersion factor using a ‘change in moment’ method. The effect of the stored volume within the manhole is clearly evident. The limitations and the applicability of this approach are discussed.


Sign in / Sign up

Export Citation Format

Share Document