The effect of operating temperature on characteristics of single-walled carbon nanotubes (SWNT) based gas sensor was investigated. SWNT-based sensor was fabricated from SWNT powder (Iljin Nanotech, Korea) by screen-printing method. SWNT powder (30 mg, AP grade) was dispersed into 0.78 gram a-terpineol (Aldrich) by ultrasonic vibration for 1 hour then stirred
manually for 1 hour to increase adhesion. From this condensed solution, a thick film of SWNT was printed onto alumina substrates. The film then was sintered at 300oC for 2 hours to remove residual impurities. Upon exposure to some gases such as nitrogen, ammonia or nitric oxide, resistance of the sensor dramatically changes due to gas adsorption. In our experiments, SWNT-based sensor was employed to detect NH3 gas in N2 ambience. After saturated of N2, the sensor exposes to NH3 with various concentrations (from 5 ppm to 100 ppm, diluted by N2 as carrier gas). This sensor exhibits a fast response, high sensitivity but slow recovery at room temperature. By heating at high temperature and increasing the flow-rate of carrier gas, NH3 gas desorbs easily and recovery of the sensor improved. The heating also influenced the characteristics of sensors such as response and
reproducibility. Other special changes in electric property of SWNT-based sensor caused by heating are also discussed.
Modeling and Analysis of Pressure Sensor with Single Walled Carbon Nanotubes for Piezoresistive Transduction
