Friction behavior of SUS 304 metastable austenitic stainless steel sheet against DC 53 die under the condition of friction coupling plastic deformation

Wear ◽  
2011 ◽  
Vol 271 (7-8) ◽  
pp. 1166-1173 ◽  
Author(s):  
Wurong Wang ◽  
Meng Hua ◽  
Xicheng Wei
Keyword(s):  
Plastic Deformation ◽  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Steel Sheet ◽  
Stainless Steel Sheet ◽  
Friction Behavior ◽  
Metastable Austenitic Stainless Steel

Low Temperature Isothermal Strain in a Metastable Austenitic Stainless Steel Sheet

1990 ◽  
Vol 112 (3) ◽  
pp. 362-365
Author(s):  
Y. Oshida ◽  
A. Deguchi
Keyword(s):  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Low Temperature ◽  
Steel Sheet ◽  
Stress Ratio ◽  
Continuous Operation ◽  
Stainless Steel Sheet ◽  
Metastable Austenitic Stainless Steel ◽  
Stationary Creep ◽  
Low Temperature Creep

Low temperature stationary creep strain in a metastable austenitic stainless steel was studied at −162°C under various combinations of prestrain and stress ratio. It was found that the amount of transformed martensite during low temperature stressing increased with the number of thermal cycles as well as the degree of prestrain and stress ratio. When the applied stress exceeded 70 percent of the material yield strength at −162°C, the martensite volume increased significantly. At the same time, the stationary low temperature creep rate exceeded 1.8x10−10 (s−1), which would cause approximately 0.44 percent strain after continuous operation for a year.

Sign in / Sign up

Export Citation Format

Share Document