scholarly journals Evidence for Stress Localization Caused by Lithospheric Heterogeneity from Seismic Attenuation

Author(s):  
Zhao Zhu ◽  
Maximiliano J. Bezada ◽  
Joseph S. Byrnes ◽  
Heather A. Ford
2021 ◽  
Author(s):  
Zhao Zhu ◽  
Maximiliano Bezada ◽  
Joseph Stephen Byrnes ◽  
Heather Ford

Author(s):  
Nguyen Le Minh ◽  
Satoru Tanaka ◽  
Yasushi Ishihara ◽  
Nguyen Tien Hung ◽  
Ha Vinh Long ◽  
...  
Keyword(s):  

2020 ◽  
Vol 224 (3) ◽  
pp. 1670-1683
Author(s):  
Liming Zhao ◽  
Genyang Tang ◽  
Chao Sun ◽  
Jianguo Zhao ◽  
Shangxu Wang

SUMMARY We conducted stress–strain oscillation experiments on dry and partially oil-saturated Fontainebleau sandstone samples over the 1–2000 Hz band at different confining pressures to investigate the wave-induced fluid flow (WIFF) at mesoscopic and microscopic scales and their interaction. Three tested rock samples have similar porosity between 6 and 7 per cent and were partially saturated to different degrees with different oils. The measurement results exhibit a single or two attenuation peaks that are affected by the saturation degree, oil viscosity and confining pressure. One peak, exhibited by all samples, shifts to lower frequencies with increasing pressure, and is mainly attributed to grain contact- or microcrack-related squirt flow based on modelling of its characteristics and comparison with other experiment results for sandstones. The other peak is present at smaller frequencies and shifts to higher frequencies as the confining pressure increases, showing an opposite pressure dependence. This contrast is interpreted as the result of fluid flow patterns at different scales. We developed a dual-scale fluid flow model by incorporating the squirt flow effect into the patchy saturation model, which accounts for the interaction of WIFFs at microscopic and mesoscopic scales. This model provides a reasonable interpretation of the measurement results. Our broad-frequency-band measurements give physical evidence of WIFFs co-existing at two different scales, and combining with modelling results, it suggests that the WIFF mechanisms, related to pore microstructure and fluid distribution, interplay with each other and jointly control seismic attenuation and dispersion at reservoir conditions. These observations and modelling results are useful for quantitative seismic interpretation and reservoir characterization, specifically they have potential applications in time-lapse seismic analysis, fluid prediction and reservoir monitoring.


Geophysics ◽  
1985 ◽  
Vol 50 (4) ◽  
pp. 615-626 ◽  
Author(s):  
S. D. Stainsby ◽  
M. H. Worthington

Four different methods of estimating Q from vertical seismic profile (VSP) data based on measurements of spectral ratios, pulse amplitude, pulse width, and zeroth lag autocorrelation of the attenuated impulse are described. The last procedure is referred to as the pulse‐power method. Practical problems concerning nonlinearity in the estimating procedures, uncertainties in the gain setting of the recording equipment, and the influence of structure are considered in detail. VSP data recorded in a well in the central North Sea were processed to obtain estimates of seismic attenuation. These data revealed a zone of high attenuation from approximately 4 900 ft to [Formula: see text] ft with a value of [Formula: see text] Results of the spectral‐ratio analysis show that the data conform to a linear constant Q model. In addition, since the pulse‐width measurement is dependent upon the dispersive model adopted, it is shown that a nondispersive model cannot possibly provide a match to the real data. No unambiguous evidence is presented that explains the cause of this low Q zone. However, it is tentatively concluded that the seismic attenuation may be associated with the degree of compaction of the sediments and the presence of deabsorbed gases.


Sign in / Sign up

Export Citation Format

Share Document