The control of the interface and the adhesion process are key issues for the development of new application based on electrochromic materials. In this work the functionalization of an electrode’s surface through electroreduction of diazonium generated in situ from 4-(2,5-di-thiophen-2-yl-pyrrol-1-yl)-phenylamine (SNS-An) has been proposed. The synthesis of the aniline derivative SNS-An was performed and the electrografting was investigated by cyclic voltammetry on various electrodes. Then the organic thin film was fully characterized by several techniques and XPS analysis confirms the presence of an organic film based on the chemical composition of the starting monomer and allows an estimation of its thickness confirmed by AFM scratching measurements. Depending on the number of electrodeposition cycles, the thickness varies from 2 nm to 10 nm, which corresponds to a few grafted oligomers. In addition, the grafted film showed a good electrochemical stability depending on the scan rates up to 400 V/s and the electrochemical response of the modified electrode towards several redox probes showed that the attached layer acts as a conductive switch. Therefore, the electrode behaves as a barrier to electron transfer when the standard redox potential of the probe is below the layer switching potential, whereas the layer can be considered as transparent towards the electron transfer for redox probes with a redox potential above it.
Dithienylpyrrole Electrografting on a Surface through the Electroreduction of Diazonium Salts