Chemical Upcycling of PET Waste towards Terephthalate Redox Nanoparticles for Energy Storage

Over 30 million ton of poly(ethylene terephthalate) (PET) is produced each year and no more than 60% of all PET bottles are reclaimed for recycling due to material property deteriorations during the mechanical recycling process. Herein, a sustainable approach is proposed to produce redox-active nanoparticles via the chemical upcycling of poly(ethylene terephthalate) (PET) waste for application in energy storage. Redox-active nanoparticles of sizes lower than 100 nm were prepared by emulsion polymerization of a methacrylic-terephthalate monomer obtained by a simple methacrylate functionalization of the depolymerization product of PET (i.e., bis-hydroxy(2-ethyl) terephthalate, BHET). The initial cyclic voltammetry results of the depolymerization product of PET used as a model compound show a reversible redox process, when using a 0.1 M tetrabutylammonium hexafluorophosphate/dimethyl sulfoxide electrolyte system, with a standard redox potential of −2.12 V vs. Fc/Fc+. Finally, the cycling performance of terephthalate nanoparticles was investigated using a 0.1 M TBAPF6 solution in acetonitrile as electrolyte in a three-electrode cell. The terephthalate anode electrode displays good cycling stability and performance at high C-rate (i.e., ≥5C), delivering a stable specific discharge capacity of 32.8 mAh.g−1 at a C-rate of 30 C, with a capacity retention of 94% after 100 cycles. However, a large hysteresis between the specific discharge and charge capacities and capacity fading are observed at lower C-rate (i.e., ≤2C), suggesting some irreversibility of redox reactions associated with the terephthalate moiety, in particular related to the oxidation process.

Characterization of redox properties of FAD cofactor of Thermotoga maritima thioredoxin reductase

The fluorescence properties of FAD of Thermotoga maritima thioredoxin reductase (TmTR), taken together with the amino acid sequences and structures of similar TRs, are consistent with the interdomain rotation in the catalysis of TmTR. The standard redox potential of FAD of TmTR, –0.230 V, determined by the reactions with 3-acetylpyridine adenine dinucleotide (APAD+/APADH) redox couple, is close to that of E. coli TR. During the reduction of duroquinone with TmTR, the transient formation of neutral FAD semiquinone, and, possibly, FADH2–NAD+ complex was observed. This shows that in spite of obligatory twoelectron (hydride)-transfer between NADH and physiological disulfide oxidants, the FAD cofactor of TmTR may exist under a stable semiquinone form.

Identification of Fe (IV) in oxides by chemical test methods

A comparative analysis of the behavior of oxides containing Fe (III) and Fe (IV) in redox reactions with organic and inorganic reagents has been carried out. SrFeO3-x oxide obtained by solid-phase synthesis from SrCO3 and Fe2O3 has been an object to develop test methods. It has been shown that Fe (IV) exhibits the properties of a stronger oxidizer than Fe (III), thus providing a set of reagents which enable identification of Fe (IV): hydrobromic acid, Fe2+ complex with V (IV), and Mn (II) salts, and organic reagents, namely, amines (diphenylamine, o-tolidine, benzidine) and dyes (methyl red). Potentiometric method proved stronger oxidative properties of Fe (IV) compared to Fe (III) revealed in different character of changes in EMF during dissolution of the corresponding oxides in HCl. SrFeO3–x oxide does not oxidize Mn (II) to Mn (VII), Cr (III) to Cr (VI), Ce (III) to Ce (IV) in acidic media, and Cu (II) to Cu (III) in alkaline media. Since the oxide under study oxidize Cl– = 1.3583 V) and Br– = 1.087 V) ions to the corresponding halogens, but does not oxidize Mn2+ to = 1.51 V), an estimated value of the standard redox potential is ~1.4 V. We have developed for the first time a system of analytical tests for differentiation of Fe (IV) and Fe (III) which can provide monitoring of the synthesis of complex oxides and phase formation in the systems containing iron, alkali and alkaline earth metals.

Species-Specific, pH-Independent, Standard Redox Potential of Selenocysteine and Selenocysteamine

Microscopic redox equilibrium constants and standard redox potential values were determined to quantify selenolate-diselenide equilibria of biological significance. The highly composite, codependent acid-base and redox equilibria of selenolates could so far be converted into pH-dependent, apparent parameters (equilibrium constants, redox potentials) only. In this work, the selenolate-diselenide redox equilibria of selenocysteamine and selenocysteine against dithiothreitol were analyzed by quantitative nuclear magnetic resonance (NMR) methods to characterize the interfering acid-base and redox equilibria. The directly obtained, pH-dependent, conditional redox equilibrium constants were then decomposed by our method into pH-independent, microscopic constants, which characterize the two-electron redox transitions of selenocysteamine and selenocysteine. The 12 different, species-specific parameter values show close correlation with the respective selenolate basicities, providing a tool to estimate otherwise inaccessible site-specific selenolate-diselenide redox potentials of related moieties in large peptides and proteins.

Dithienylpyrrole Electrografting on a Surface through the Electroreduction of Diazonium Salts

The control of the interface and the adhesion process are key issues for the development of new application based on electrochromic materials. In this work the functionalization of an electrode’s surface through electroreduction of diazonium generated in situ from 4-(2,5-di-thiophen-2-yl-pyrrol-1-yl)-phenylamine (SNS-An) has been proposed. The synthesis of the aniline derivative SNS-An was performed and the electrografting was investigated by cyclic voltammetry on various electrodes. Then the organic thin film was fully characterized by several techniques and XPS analysis confirms the presence of an organic film based on the chemical composition of the starting monomer and allows an estimation of its thickness confirmed by AFM scratching measurements. Depending on the number of electrodeposition cycles, the thickness varies from 2 nm to 10 nm, which corresponds to a few grafted oligomers. In addition, the grafted film showed a good electrochemical stability depending on the scan rates up to 400 V/s and the electrochemical response of the modified electrode towards several redox probes showed that the attached layer acts as a conductive switch. Therefore, the electrode behaves as a barrier to electron transfer when the standard redox potential of the probe is below the layer switching potential, whereas the layer can be considered as transparent towards the electron transfer for redox probes with a redox potential above it.

Quest for Compounds at the Verge of Charge Transfer Instabilities: The Case of Silver(II) Chloride †

Electron-transfer processes constitute one important limiting factor governing stability of solids. One classical case is that of CuI2, which has never been prepared at ambient pressure conditions due to feasibility of charge transfer between metal and nonmetal (CuI2 → CuI + ½ I2). Sometimes, redox instabilities involve two metal centers, e.g., AgO is not an oxide of divalent silver but rather silver(I) dioxoargentate(III), Ag(I)[Ag(III)O2]. Here, we look at the particularly interesting case of a hypothetical AgCl2 where both types of redox instabilities operate simultaneously. Since standard redox potential of the Ag(II)/Ag(I) redox pair reaches some 2 V versus Normal Hydrogen Electrode (NHE), it might be expected that Ag(II) would oxidize Cl− anion with great ease (standard redox potential of the ½ Cl2/Cl− pair is + 1.36 V versus Normal Hydrogen Electrode). However, ionic Ag(II)Cl2 benefits from long-distance electrostatic stabilization to a much larger degree than Ag(I)Cl + ½ Cl2, which affects relative stability. Moreover, Ag(II) may disproportionate in its chloride, just like it does in an oxide; this is what AuCl2 does, its formula corresponding in fact to Au(I)[Au(III)Cl4]. Formation of polychloride substructure, as for organic derivatives of Cl3− anion, is yet another possibility. All that creates a very complicated potential energy surface with a few chemically distinct minima i.e., diverse polymorphic forms present. Here, results of our theoretical study for AgCl2 will be presented including outcome of evolutionary algorithm structure prediction method, and the chemical identity of the most stable form will be uncovered together with its presumed magnetic properties. Contrary to previous rough estimates suggesting substantial instability of AgCl2, we find that AgCl2 is only slightly metastable (by 52 meV per formula unit) with respect to the known AgCl and ½ Cl2, stable with respect to elements, and simultaneously dynamically (i.e., phonon) stable. Thus, our results point out to conceivable existence of AgCl2 which should be targeted via non-equilibrium approaches.

Redox properties of the tissue factor Cys186–Cys209 disulfide bond

TF (tissue factor) is a transmembrane cofactor that initiates blood coagulation in mammals by binding Factor VIIa to activate Factors X and IX. The cofactor can reside in a cryptic configuration on primary cells and de-encryption may involve a redox change in the C-terminal domain Cys186–Cys209 disulfide bond. The redox potential of the bond, the spacing of the reduced cysteine thiols and their oxidation by TF activators was investigated to test the involvement of the dithiol/disulfide in TF activation. A standard redox potential of −278 mV was determined for the Cys186–Cys209 disulfide of recombinant soluble TF. Notably, ablating the N-terminal domain Cys49–Cys57 disulfide markedly increased the redox potential of the Cys186–Cys209 bond, suggesting that the N-terminal bond may be involved in the regulation of redox activity at the C-terminal bond. Using As(III) and dibromobimane as molecular rulers for closely spaced sulfur atoms, the reduced Cys186 and Cys209 sulfurs were found to be within 3–6 Å (1 Å=0.1 nm) of each other, which is close enough to reform the disulfide bond. HgCl2 is a very efficient activator of cellular TF and activating concentrations of HgCl2-mediated oxidation of the reduced Cys186 and Cys209 thiols of soluble TF. Moreover, PAO (phenylarsonous acid), which cross-links two cysteine thiols that are in close proximity, and MMTS (methyl methanethiolsulfonate), at concentrations where it oxidizes closely spaced cysteine residues to a cystine residue, were efficient activators of cellular TF. These findings further support a role for Cys186 and Cys209 in TF activation.