scholarly journals Constraints on the Structure of the Border Ranges Fault System, Kenai Peninsula, Alaska from the Preliminary Results of the 3D Inversion Model of Gravity Data

2013 ◽  
Vol 2013 (1) ◽  
pp. 1-3
Author(s):  
Niti Mankhemthong ◽  
Diane I. Doser ◽  
Mark Baker ◽  
Rolando Cardenas
2016 ◽  
Author(s):  
Godfred Osukuku ◽  
Abiud Masinde ◽  
Bernard Adero ◽  
Edmond Wanjala ◽  
John Ego

Abstract This research work attempts to map out the stratigraphic sequence of the Kerio Valley Basin using magnetic, gravity and seismic data sets. Regional gravity data consisting of isotactic, free-air and Bouguer anomaly grids were obtained from the International Gravity Bureau (BGI). Magnetic data sets were sourced from the Earth Magnetic Anomaly grid (EMAG2). The seismic reflection data was acquired in 1989 using a vibrating source shot into inline geophones. Gravity Isostacy data shows low gravity anomalies that depict a deeper basement. Magnetic tilt and seismic profiles show sediment thickness of 2.5-3.5 Km above the basement. The Kerio Valley Basin towards the western side is underlain by a deeper basement which are overlain by succession of sandstones/shales and volcanoes. At the very top are the mid Miocene phonolites (Uasin Gishu) underlain by mid Miocene sandstones/shales (Tambach Formation). There are high gravity anomalies in the western and southern parts of the basin with the sedimentation being constrained by two normal faults. The Kerio Valley Basin is bounded to the west by the North-South easterly dipping fault system. Gravity data was significantly of help in delineating the basement, scanning the lithosphere and the upper mantle according to the relative densities. The basement rocks as well as the upper cover of volcanoes have distinctively higher densities than the infilled sedimentary sections within the basin. From the seismic profiles, the frequency of the shaley rocks and compact sandstones increases with depths. The western side of the basin is characterized by the absence of reflections and relatively higher frequency content. The termination of reflectors and the westward dip of reflectors represent a fault (Elgeyo fault). The reflectors dip towards the west, marking the basin as an asymmetrical syncline, indicating that the extension was towards the east. The basin floor is characterized by a nearly vertical fault which runs parallel to the Elgeyo fault. The seismic reflectors show marked discontinuities which may be due to lava flows. The deepest reflector shows deep sedimentation in the basin and is in reasonable agreement with basement depths delineated from potential methods (gravity and magnetic). Basement rocks are deeper at the top of the uplift footwall of the Elgeyo Escarpment. The sediments are likely of a thickness of about 800 M which is an interbed of sandstones and shales above the basement.


Geophysics ◽  
2008 ◽  
Vol 73 (1) ◽  
pp. K1-K9 ◽  
Author(s):  
Colin G. Farquharson

A modification of the typical minimum-structure inver-sion algorithm is presented that generates blocky, piecewise-constant earth models. Such models are often more consistent with our real or perceived knowledge of the subsurface than the fuzzy, smeared-out models produced by current minimum-structure inversions. The modified algorithm uses [Formula: see text]-type measures in the measure of model structure instead of the traditional sum-of-squares, or [Formula: see text], measure. An iteratively reweighted least-squares procedure is used to deal with the nonlinearity introduced by the non-[Formula: see text] measure. Also, and of note here, diagonal finite differences are included in the measure of model structure. This enables dipping interfaces to be formed. The modified algorithm retains the benefits of the minimum-structure style of inversion — namely, reliability, robustness, and minimal artifacts in the constructed model. Two examples are given: the 2D inversion of synthetic magnetotelluric data and the 3D inversion of gravity data from the Ovoid deposit, Voisey’s Bay, Labrador.


Geosphere ◽  
2020 ◽  
Vol 16 (2) ◽  
pp. 660-684 ◽  
Author(s):  
Ray E. Wells ◽  
Richard J. Blakely ◽  
Sean Bemis

Abstract The Gales Creek fault (GCF) is a 60-km-long, northwest-striking dextral fault system (west of Portland, Oregon) that accommodates northward motion and uplift of the Oregon Coast Range. New geologic mapping and geophysical models confirm inferred offsets from earlier geophysical surveys and document ∼12 km of right-lateral offset of a basement high in Eocene Siletz River Volcanics since ca. 35 Ma and ∼8.8 km of right-lateral separation of Miocene Columbia River Basalt at Newberg, Oregon, since 15 Ma (∼0.62 ± 0.12 mm/yr, average long-term rate). Relative uplift of Eocene Coast Range basalt basement west of the fault zone is at least 5 km based on depth to basement under the Tualatin Basin from a recent inversion of gravity data. West of the city of Forest Grove, the fault consists of two subparallel strands ∼7 km apart. The westernmost, Parsons Creek strand, forms a linear valley southward to Henry Hagg Lake, where it continues southward to Newberg as a series of en echelon strands forming both extensional and compressive step-overs. Compressive step-overs in the GCF occur at intersections with ESE-striking sinistral faults crossing the Coast Range, suggesting the GCF is the eastern boundary of an R′ Riedel shear domain that could accommodate up to half of the ∼45° of post–40 Ma clockwise rotation of the Coast Range documented by paleomagnetic studies. Gravity and magnetic anomalies suggest the western strands of the GCF extend southward beneath Newberg into the Northern Willamette Valley, where colinear magnetic anomalies have been correlated with the Mount Angel fault, the proposed source of the 1993 M 5.7 Scotts Mills earthquake. The potential-field data and water-well data also indicate the eastern, Gales Creek strand of the fault may link to the NNW-striking Canby fault through the E-W Beaverton fault to form a 30-km-wide compressive step-over along the south side of the Tualatin Basin. LiDAR data reveal right-lateral stream offsets of as much as 1.5 km, shutter ridges, and other youthful geomorphic features for 60 km along the geophysical and geologic trace of the GCF north of Newberg, Oregon. Paleoseismic trenches document Eocene bedrock thrust over 250 ka surficial deposits along a reverse splay of the fault system near Yamhill, Oregon, and Holocene motion has been recently documented on the GCF along Scoggins Creek and Parsons Creek. The GCF could produce earthquakes in excess of Mw 7, if the entire 60 km segment ruptured in one earthquake. The apparent subsurface links of the GCF to other faults in the Northern Willamette Valley suggest that other faults in the system may also be active.


2014 ◽  
Vol 2 (4) ◽  
pp. SJ65-SJ74 ◽  
Author(s):  
Leandro B. Adriano ◽  
Paulo T. L. Menezes ◽  
Alan S. Cunha

The Barra de São João Graben (BSJG), shallow water Campos Basin, is part of the Cenozoic rift system that runs parallel to the Brazilian continental margin. This system was formed in an event that caused the reactivation of the main Precambrian shear zones of southeastern Brazil in the Paleocene. We proposed a new structural framework of BSJG based on gravity data interpretation. Magnetic data, one available 2D seismic line, and a density well-log of a nearby well were used as constraints to our interpretation. To estimate the top of the basement structure, we separated the gravity effects of deep sources from the shallow basement (residual anomaly). Then, we performed a 2D modeling exercise, in which we kept fixed the basement topography and the density of the sediments, to estimate the density of the basement rocks. Next, we inverted the residual anomaly to recover the depth to the top of the basement. This interpretation strategy allowed the identification of a complex structural framework with three main fault systems: a northeast–southwest-trending normal fault system, a northwest–southeast-trending transfer fault system, and an east–west-trending transfer fault system. These trends divided the graben into several internal highs and lows. Our interpretation was corroborated by the magnetic anomalies. The existence of ultradense and strongly magnetized elongated bodies in the basement was interpreted as ophiolite bodies that were probably obducted by the time of the shutdown of the Proterozoic Adamastor Ocean.


Sign in / Sign up

Export Citation Format

Share Document