DIE-SWELL OF ANTIMISTING KEROSENE: PART 1. SHEAR AND NORMAL STRESSES OF ANTIMISTING KEROSENE AT HIGH SHEAR RATES DETERMINED FROM DIE-SWELL AND TORSIONAL BALANCE MEASUREMENTS

1986 ◽  
Vol 48 (1-3) ◽  
pp. 57-77 ◽  
Author(s):  
R.J. MANNHEIMER
1968 ◽  
Vol 90 (3) ◽  
pp. 561-569 ◽  
Author(s):  
L. H. Bernd

Based on an examination of the characteristics of shear viscosity versus shear rate, it was postulated that high tensile and compressive stresses might exist in certain liquids at very high shear rates. If obtainable, these stresses could be important as load-bearing mechanisms in high-speed machine elements, and as a sealing mechanism in radial face seals. Such stresses should be evident in a polymer fortified oil, or in a liquid comprised of molecules possessing an appreciable length to width ratio. Therefore, a jet reaction viscometer reaching 107 sec−1 shear rate was developed to explore this possibility. Tests with polyisobutylene dissolved in a kerosene showed that elastic stresses were dominant with respect to viscous stresses at high shear rates. Tensile stresses up to more thn 1000 psi were obtained. However, the life of the polyisobutylene molecule was short. Hence it is concluded that normal stresses of appreciable magnitude can exist in high-speed machine elements under favorable conditions to affect their operation.


1997 ◽  
Vol 17 (5) ◽  
pp. 919-924 ◽  
Author(s):  
Patrick André ◽  
Patricia Hainaud ◽  
Claire Bal dit Sollier ◽  
Leonard I. Garfinkel ◽  
Jacques P. Caen ◽  
...  

Open Ceramics ◽  
2021 ◽  
Vol 5 ◽  
pp. 100052
Author(s):  
V. Carnicer ◽  
C. Alcázar ◽  
M.J. Orts ◽  
E. Sánchez ◽  
R. Moreno

1991 ◽  
Vol 35 (4) ◽  
pp. 706-706
Author(s):  
Hideroh Takahashi ◽  
Yoshinori Inoue ◽  
Satoru Yamamoto ◽  
Osami Kamigaito

2011 ◽  
Vol 106 (12) ◽  
pp. 1062-1068 ◽  
Author(s):  
Naoki Tsuji ◽  
Yuko Honda ◽  
Chikako Kamisato ◽  
Yoshiyuki Morishima ◽  
Toshiro Shibano ◽  
...  

SummaryEdoxaban is an oral, direct factor Xa (FXa) inhibitor under late-phase clinical development. This study compared the antithrombotic efficacy of edoxaban with that of an indirect FXa inhibitor, fondaparinux, in in vivo venous and arterial thrombosis models and in ex vivo perfusion chamber thrombosis model under low and high shear rates in rats. Venous and arterial thrombi were induced by platinum wire insertion into the inferior vena cava and by application of FeCl3 to the carotid artery, respectively. The perfusion chamber thrombus was formed by blood perfusion into a collagen-coated capillary at 150 s-1 (low shear rate) and 1,600 s-1 (high shear rate). Effective doses of edoxaban that reduced thrombus formation by 50% (ED50) in venous and arterial thrombosis models were 0.076 and 0.093 mg/kg/h, respectively. In contrast, ED50 of fondaparinux in the arterial thrombosis model (>10 mg/kg/h) was markedly higher compared to ED50 in the venous thrombosis model (0.021 mg/kg/h). In the perfusion chamber thrombosis model, the ratio of ED50 under high shear rate (1.13 mg/kg/h) to that under low shear rate (0.63 mg/kg/h) for edoxaban was 1.9, whereas that for fondaparinux was more than 66. While the efficacy of fondaparinux markedly decreased in arterial thrombosis and in a high-shear state, edoxaban exerted consistent antithrombotic effects regardless of flow conditions. These results suggest that shear rate is a key factor in different antithrombotic effects between edoxaban and fondaparinux.


Sign in / Sign up

Export Citation Format

Share Document