Use of Sulfate-Reducing and Bioelectrochemical Reactors for Metal Recovery from Mine Water

2016 ◽  
Vol 46 (1) ◽  
pp. 1-20 ◽  
Author(s):  
Pirjo Isosaari ◽  
Mika Sillanpää
2013 ◽  
Vol 825 ◽  
pp. 487-490
Author(s):  
Ivan Nancucheo ◽  
D. Barrie Johnson

A low pH sulfidogenic bioreactor, maintained between pH 2.8 and 4.0, was used to lower sulfate concentrations in two extremely acidic (pH 1.3 to 3.0) synthetic mine waters that contained ferrous iron but no other chalcophilic metals. Tests with water carried out with synthetic mine water from a German site showed that 98% of the sulfate present could be removed by manipulating the water pH and concentration of electron donor (glycerol) for the sulfate-reducing bacteria. While more sulfate was removed with synthetic Chilean mine water (up to 35 mmoles L-1), this only accounted for between 50-60% of the total present. There was close agreement between the stoichiometry of glycerol used and the amount of sulfate removed, particularly with the German mine water.


2015 ◽  
Vol 1130 ◽  
pp. 606-609 ◽  
Author(s):  
Ana Laura Santos ◽  
D. Barrie Johnson

A low pH sulfate-reducing bioreactor was used to selectively recover copper from synthetic pH 5 mine water draining a copper mine in Brazil, and also to remove other transition metals from solution. The design of the system used meant that a single bioreactor could be used for the process. Over 99% of the copper present was recovered as CuS in an off-line reactor vessel, while other metals (Ni, Co and Zn) were precipitated in the bioreactor vessel.


2017 ◽  
Vol 53 (5) ◽  
pp. 915-924 ◽  
Author(s):  
O. V. Eremin ◽  
E. S. Epova ◽  
R. A. Filenko ◽  
O. S. Rusal’ ◽  
V. A. Bychinsky

2012 ◽  
Vol 223 (6) ◽  
pp. 3049-3055 ◽  
Author(s):  
Jian Lu ◽  
Jun Wu ◽  
Tianhu Chen ◽  
P. Chris Wilson ◽  
Jiazhong Qian ◽  
...  

2020 ◽  
Vol 82 (5) ◽  
pp. 11-20
Author(s):  
D.R. Abdulina ◽  
◽  
L.M. Purish ◽  
G.O. Iutynska ◽  
◽  
...  

The studies of the carbohydrate composition of the sulfate-reducing bacteria (SRB) biofilms formed on the steel surface, which are a factor of microbial corrosion, are significant. Since exopolymers synthesized by bacteria could activate corrosive processes. The aim of the study was to investigate the specificity of commercial lectins, labeled with colloidal gold to carbohydrates in the biofilm exopolymeric matrix produced by the corrosive-relevant SRB strains from man-caused ecotopes. Methods. Microbiological methods (obtaining of the SRB biofilms during cultivation in liquid Postgate B media under microaerophilic conditions), biochemical methods (lectin-binding analysis of 10 commercial lectins, labeled with colloidal gold), transmission electron microscopy using JEM-1400 JEOL. Results. It was shown using transmission electron microscopy that the binding of lectins with carbohydrates in the biofilm of the studied SRB strains occurred directly in the exopolymerіс matrix, as well as on the surfaces of bacterial cells, as seen by the presence of colloidal gold particles. For detection of the neutral carbohydrates (D-glucose and D-mannose) in the biofilm of almost all studied bacterial strains PSA lectin was the most specific. This lectin binding in biofilms of Desulfotomaculum sp. К1/3 and Desulfovibrio sp. 10 strains was higher in 90.8% and 94.4%, respectively, then for ConA lectin. The presence of fucose in the SRB biofilms was detected using LABA lectin, that showed specificity to the biofilm EPS of all the studied strains. LBA lectin was the most specific to N-аcetyl-D-galactosamine for determination of amino sugars in the biofilm. The amount of this lectin binding in D. vulgaris DSM644 biofilm was 30.3, 10.1 and 9.3 times higher than SBA, SNA and PNA lectins, respectively. STA, LVA and WGA lectins were used to detect the N-acetyl-Dglucosamine and sialic acid in the biofilm. WGA lectin showed specificity to N-acetyl-D-glucosamine in the biofilm of all the studied SRB; maximum number of bounded colloidal gold particles (175 particles/μm2) was found in the Desulfotomaculum sp. TC3 biofilm. STA lectin was interacted most actively with N-acetyl-D-glucosamine in Desulfotomaculum sp. TC3 and Desulfomicrobium sp. TC4 biofilms. The number of bounded colloidal gold particles was in 9.2 and 7.4 times higher, respectively, than using LVA lectin. The lowest binding of colloidal gold particles was observed for LVA lectin. Conclusions. It was identified the individual specificity of the 10 commercial lectins to the carbohydrates of biofilm matrix on the steel surface, produced by SRB. It was estimated that lectins with identical carbohydrates specificity had variation in binding to the biofilm carbohydrates of different SRB strains. Establishing of the lectin range selected for each culture lead to the reduction of the scope of studies and labor time in the researching of the peculiarities of exopolymeric matrix composition of biofilms formed by corrosiverelevant SRB.


Sign in / Sign up

Export Citation Format

Share Document