Performance analysis of solar water heater with flattened tube spiral absorber using forced circulation

2019 ◽  
Vol 16 (11) ◽  
pp. 811-824 ◽  
Author(s):  
A Sacithra ◽  
A Manivannan
2018 ◽  
Vol 141 (3) ◽  
Author(s):  
Vinod Kumar Soni ◽  
R. L. Shrivastava ◽  
S. P. Untawale ◽  
Kshitij Shrivastava

Concentrated solar power (CSP) is a mature and efficient technology to cater the large-scale demand of hot water. Conventional reflectors/mirrors in CSP share 50% of total system cost. High installation as well as O&M cost is the major concern in reflector-based CSP. Apart from the above, manufacturing defects and adverse service environment cause premature degradation of reflectors and substantial drop in efficiency and service life. Performance analysis of an innovative optically concentrated solar water heater (OCSWH) using plurality of Fresnel lenses of poly methyl methacrylate (PMMA) is presented in the work. Size and yield of any solar water heater (SWH) are mainly dependent on its aperture area, output temperature, and mass flow rate, which are termed herein as critical parameters. Series of experimentations is carried out by varying critical design and operating parameters viz. aperture area, outlet temperature, and rate of mass flow, and similar experimentation is also carried out on commercially available flat plate SWH to compare its performance. Loss of heat from riser and header pipes is restricted by application of effective insulation. Substantial improvement in collector efficiency, increase in rate of mass flow, and rise in discharge temperature with reference to flat plate collector are noted. Economics is also studied covering life cycle cost (LCC), life cycle saving (LCS), and energy payback period.


Author(s):  
David Alejandro Arguello Bravo ◽  
Javier Martínez-Gómez ◽  
Esteban Francisco Urresta Suárez ◽  
David Rodger Salazar Loor ◽  
Gonzalo Guerrón

Author(s):  
Ouhammou Badr ◽  
Azeddine Frimane ◽  
Aggour Mohammed ◽  
Brahim Daouchi ◽  
Abdellah Bah ◽  
...  

The Indirect Solar Water Heater System (SWHS) with Forced Circulation is modeled by proposing a theoretical dynamic multi-node model. The SWHS, which works with a 1,91 m<sup>2</sup> PFC and 300 L storage tank, and it is equipped with available forced circulation scale system fitted with an automated sub-system that controlled hot water, is what the experimental setup consisted of. The system, which 100% heated water by only using solar energy. The experimental weather conditions are measured every one minute. The experiments validation steps were performed for two periods, the first one concern the cloudy days in December, the second for the sunny days in May; the average deviations between the predicted and the experimental values is 2 %, 5 % for the water temperature output and for the useful energy  are 4 %, 9 % respectively for the both typical days, which is very satisfied. The thermal efficiency was determined experimentally and theoretically and shown to agree well with the EN12975 standard for the flow rate between 0,02 kg/s and 0,2kg/s.


Sign in / Sign up

Export Citation Format

Share Document