A finite element (FE) based scheme for modeling facet articulation in a spinal motion segment is proposed. The algorithm presented models the facet articulation as a nonlinear progressive contact problem. This algorithm is used to perform a nonlinear FE analysis of a complete L3-L4 motion segment. The role of facets in load transmission through a motion segment and its sensitivity to facet geometric parameters (i.e., spatial orientation of the facets and the gap between the facet articular surfaces) on this load transmission are studied. Compression, flexion, extension, and torsion loads are used in this study. The effect of facetectomy on gross segment response and disk fiber strains is studied by comparing the response of FE models of motion segment with and without facets. Large facet loads are obtained when the motion segment is subjected to torsional and large extension rotations, whereas minimal facet loads are observed under compression and flexion loading. Removal of facets reduces the segment stiffness considerably in torsion and results in higher strain levels in disk fibers. The facet load transmission is sensitive to facet geometric parameters, i.e., spatial orientation and initial facet joint gap. The facet loads increase uniformly with decrease in initial gap between the facet articular surfaces under compression, extension, and torsional loads. The sensitivity to spatial orientation angles of the facet is, however, found to vary with the type of loading. This sensitivity may account for the wide variation in the facet response reported in literature.
The viscoelastic moving-contact problem with inertial effects included
