scholarly journals I. The liquation of gold and platinum alloys

1890 ◽  
Vol 47 (286-291) ◽  
pp. 180-186 ◽  

It is a well known fact that when molten alloys of certain metals are cooled, some of the constituents separate and become concentrated either in the centre or in the external portions of the solidified mass; to this segregation the name of liquation is given. It is specially noticeable in the case of silver-copper alloys, and its importance is now being widely recognised in almost all branches of metallurgy. In the case of gold, however, the phenomenon of liquation does not appear to have been much observed. Gold alloys, to the value of many millions sterling, pass annually from hand to hand upon the results of assays cut from the external portions of ingots, which assays cannot, of course, be trustworthy, if the centre of the bars differs in composition from the external portions. Peligot has recently endeavoured to obtain evidence of liquation in gold-copper alloys, and has concluded that it does not exist. Roberts-Austen, who has devoted much time to the study of liquation, has also satisfied himself that gold-silver alloys do not rearrange themselves on cooling.

Gold Bulletin ◽  
1980 ◽  
Vol 13 (3) ◽  
pp. 113-116 ◽  
Author(s):  
Randall M. German ◽  
Matthew M. Guzowski ◽  
David C. Wright

JOM ◽  
1949 ◽  
Vol 1 (1) ◽  
pp. 46-48
Author(s):  
John G. McMullin ◽  
John T. Norton

2017 ◽  
Vol 891 ◽  
pp. 89-94 ◽  
Author(s):  
Stephanie Greil ◽  
Christian Edtmaier ◽  
Roland Haubner ◽  
Lukas Lauter

A typical metallographic preparation (i.e. mechanical grinding and chemical etching) and electrochemical etch-polishing was carried out to observe the microstructure of pure silver and two silver-copper alloys (Sterling silver Ag 925 and Ag 333) in circular blanks used for coin production. The obtained micrographs revealed cold working effects on the coin rim caused by the rimming process. These rim effects are the reason for local differences in the mechanical properties of circular blanks, posing a challenge to tool lifetime. To quantify these effects, a micro hardness-mapping was performed and analysed.


1959 ◽  
Vol 13 ◽  
pp. 2082-2088 ◽  
Author(s):  
Einar Jacobsen ◽  
Jan Rydberg ◽  
William F. Miller ◽  
Susanne Refn

Sign in / Sign up

Export Citation Format

Share Document