Wide Band Inset Feed Microstrip Patch Antenna for Mobile Communication

Author(s):  
Z. Ali ◽  
V. K. Singh ◽  
A. K. Singh ◽  
S. Ayub
2015 ◽  
Vol 4 (3) ◽  
pp. 9-14
Author(s):  
Rajeewa Kumar Jaisawal ◽  
◽  
Arvind Kumar Pandey ◽  
R. K. Chauhan ◽  
◽  
...  

2021 ◽  
pp. 491-496
Author(s):  
Aditi Chauhan ◽  
Utkarsh Jain ◽  
Aakash Warke ◽  
Manan Gupta ◽  
Ashok Kumar ◽  
...  

YMER Digital ◽  
2021 ◽  
Vol 20 (12) ◽  
pp. 790-807
Author(s):  
N Parthiban ◽  
◽  
M Mohamed Ismail ◽  

Microstrip antenna is an essential choice for Ultra Wide Band (UWB) applications of its light weight, low profile and easy to form antenna arrays. However, the design of microstrip patch antenna bandwidth is greatly affects by the dielectric substrate material (FR4). In this research, the bandwidth enhancement of MPA was designed by minimizing the dimension of Defected GP (DGP) in GP for Ultra Wide Band wireless applications. But, the antenna design complexity increases with the number of an operating frequency band. In this research, the MPA was designed as small as size of 10×13×1.6 mm and operates on frequency band between 3.1GHz to 10.6GHz for VSWR less than 2. The microstrip patch antenna was designed at 3.1GHz to 10.6GHz using High-Frequency Structure Simulator (HFSS) software. The simulation result shows that the proposed microstrip patch antenna obtained <-10dB of return loss from 3.1GHz to 10.6GHz throughout the frequency range. The measured result proves that the proposed microstrip patch antenna has better characteristics to fulfill the requirements of UWB applications


Author(s):  
Akhila John Davuluri ◽  
P. Siddaiah

This paper proposes a microstrip patch antenna (MSPA) in the Ku band for satellite applications. The antenna is small in size with dimensions of about 40 mm×48 mm×1.59 mm and is fed with a coaxial cable of 50 Ω impedance. The proposed antenna has a wide bandwidth of 3.03 GHz ranging from 12.8 GHz to 15.8 GHz. To realize the characteristics of wideband the techniques of defective ground structure (DGS) and etching slots on the radiating element are adopted. The antenna is modeled on the FR4 substrate. A basic circular patch is selected for the design of a dual-frequency operation and in the next step DGS is introduced into the basic antenna and enhanced bandwidth is achieved at both the frequencies. To attain wider bandwidth two slots are etched on the radiating element of which one is a square ring slot and the second one is a circular ring slot. The novelty of the proposed antenna is a miniaturized design and unique response within the Ku band region which is applicable for wireless UWB applications with VSWR <2 and an average gain of 3.6 dB.


Sign in / Sign up

Export Citation Format

Share Document