Single-Phase Average Reactive Power Measurement Using Instantaneous Power Theory in a Fixed Point Processor

2020 ◽  
Author(s):  
Dipankar Chatterjee ◽  
Suvarun Dalapati
Keyword(s):  
Fixed Point ◽  
Single Phase ◽  
Reactive Power ◽  
Power Measurement ◽  
Power Theory ◽  
Instantaneous Power ◽  
Phase Average

scholarly journals Interpretasi Praktis Terhadap Istilah-Istilah Daya pada Rangkaian Listrik Satu Fase Sinusoidal

2021 ◽  
Vol 1 (1) ◽  
Author(s):  
Adlan Bagus Pradana ◽  
Unan Yusmaniar Oktiawati ◽  
Jimmy Trio Putra ◽  
Dhanis Woro Fittrin Selo Nur Giyatno ◽  
Atikah Surriani
Keyword(s):  
Computer Simulations ◽  
Daily Activity ◽  
Power Analysis ◽  
Single Phase ◽  
Reactive Power ◽  
Electrical Engineering ◽  
Active Power ◽  
General Application ◽  
Instantaneous Power ◽  
Complex Power

In electrical engineering, there are several power terms; active power, reactive power, instantaneous active power, instantaneous active power, instantaneous power, apparent power and complex power. Even though are used in daily activity, electrical practitioners are facing difficulty to explain those terms practically. This paper tries to solve those difficulty by interpret those term in practical way. Firstly, each power term are defined theoretically. Then those terms are presented mathematically. Next, power in single phase sinusoidal electric network is analyzed. Theoretical definition result is connected with power analysis result. Computer simulations are held to strengthen interpretation result. Considering the width of discussion area, this paper only covers most general application, that is single phase sinusoidal network.

scholarly journals Multilevel Inverter Compensation System of the Single-phase Based on Instantaneous P-instantaneous Real Power and Q-instantaneous Virtual Power Theory

2015 ◽  
Vol 11 (7) ◽  
pp. 47
Author(s):  
Xijuan Wang ◽  
Tao Zhou ◽  
Yang Zhao ◽  
Jingxiao Feng ◽  
Jialun Zhang ◽  
...  
Keyword(s):  
Single Phase ◽  
Reactive Power ◽  
Simulation Analysis ◽  
Active Power ◽  
Multilevel Inverter ◽  
Phase System ◽  
Virtual Power ◽  
Real Power ◽  
Power Theory ◽  
Before And After

This paper gives an introduction to the single-phase instantaneous PQ (P-instantaneous real power and Q-instantaneous virtual power) theory and carries out the calculation and simulation analysis on reactive power, active power, instantaneous reactive power and instantaneous active power for the single system before and after the compensation of the multilevel inverter. By analyzing the experimental results, it can be seen that harmonic current of the single phase system decreased significantly after using multilevel inverter, while the power factor improved obviously.

Detection for Rective Current Based on the Instantaneous Reactive Power Theory

2012 ◽  
Vol 433-440 ◽  
pp. 6565-6571
Author(s):  
Xiao Cui Lei ◽  
Guang Zeng ◽  
Jing Gang Zhang
Keyword(s):  
Single Phase ◽  
Reactive Power ◽  
Phase Locked Loop ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Power Theory ◽  
Instantaneous Reactive Power Theory ◽  
Three Phase ◽  
Reactive Current ◽  
Low Pass

Three-phase circuit instantaneous reactive power theory has received a successful application in detecting harmonic and reactive current timely, the ip-iq and d-q method of first proposed require the phase-locked loop and low-pass filter. The paper make corresponding improvement on the basis of the method based on amplitude integration which only can detect fundamental current , propose a method which can detect the active and reactive current, and the method based on amplitude integration can detect fundamental current of single-phase circuit directly, and simulation. The simulation results show that the method can detect the harmonic and reactive current accurately and timely, and is suitable for various circumstances that three-phase power supply distortion and asymmetry and so on, and when only detecting the harmonic current, it does not require the phase-locked loop and low-pass filter, while detecting the harmonic and reactive current, increases the phase-locked loop; when the method based on amplitude integration is directly used to detect single-phase fundamental current, the phase-locked loop and low-pass filter are not required. The paper deduces the theory of the method and researches on simulation analysis.

Sign in / Sign up

Export Citation Format

Share Document