Sinusoidal steady-state analysis for fault location in power distribution systems

2005 ◽  
Author(s):  
Fengling Han ◽  
Xinghuo Yu ◽  
Yi Wang ◽  
M. Al-Dabbagh
Keyword(s):  
Steady State ◽  
Power Distribution ◽  
Distribution Systems ◽  
Fault Location ◽  
Power Distribution Systems ◽  
Steady State Analysis ◽  
State Analysis

Optimal fault location for power distribution systems with distributed generations using synchronized measurements

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Wen Fan ◽  
Yuan Liao ◽  
Ning kang
Keyword(s):  
Power Distribution ◽  
Distribution Systems ◽  
Fault Location ◽  
Test System ◽  
Power Distribution Systems ◽  
Distributed Generations ◽  
High Penetration ◽  
Maintenance Time ◽  
Phasor Measurements ◽  
Synchronized Measurements

AbstractAccurate fault location in distribution systems greatly shortens maintenance time and improves reliability. This paper presents novel methods to pinpoint fault location and identify possible bad measurements for enhanced accuracy. It is assumed that network parameters and topology of the distribution network are available. The methods are applicable to a single fault as well as simultaneous faults and are applicable to both balanced and unbalanced networks. The methods utilize synchronized voltage and current phasor measurements to locate the fault. The methods are validated by simulation studies using the modified IEEE 34-Node Test System. Case studies have demonstrated that the methods are suitable for distribution systems with high penetration of distributed generations.

scholarly journals Complete power distribution system representation and state determination for fault location

DYNA ◽  
2015 ◽  
Vol 82 (192) ◽  
pp. 141-149 ◽  
Author(s):  
Andres Felipe Panesso-Hernández ◽  
Juan Mora-Flórez ◽  
Sandra Pérez-Londoño
Keyword(s):  
Power Distribution ◽  
Distribution System ◽  
Distribution Systems ◽  
Fault Location ◽  
Estimation Error ◽  
Distance Estimation ◽  
Power Distribution Systems ◽  
Line Load ◽  
Power Distribution System ◽  
Line Section

<p>The impedance-based approaches for fault location in power distribution systems determine a faulted line section. Next, these require of the estimation of the voltages and currents at one or both section line ends to exactly determine the fault location. It is a challenge because in most of the power distribution systems, measurements are only available at the main substation.  This document presents a modeling proposal of the power distribution system and an easy implementation method to estimate the voltages and currents at the faulted line section, using the measurements at the main substation, the line, load, transformer parameters and other serial and shunt connected devices and the power system topology. The approach here proposed is tested using a fault locator based on superimposed components, where the distance estimation error is lower than 1.5% in all of the cases. </p>

Sign in / Sign up

Export Citation Format

Share Document