Improved particle swarm optimization based load frequency control in a single area power system

2010 ◽  
Author(s):  
Saumya Kr. Gautam ◽  
Nakul Goyal
Keyword(s):  
Particle Swarm Optimization ◽  
Power System ◽  
Frequency Control ◽  
Particle Swarm ◽  
Load Frequency Control ◽  
Swarm Optimization ◽  
Improved Particle Swarm Optimization ◽  
Load Frequency

Load Frequency Control in Power System via Improving PID Controller Based on Particle Swarm Optimization and ANFIS Techniques

2015 ◽  
pp. 462-481 ◽  
Author(s):  
Naglaa K. Bahgaat ◽  
M. I. El-Sayed ◽  
M. A. Moustafa Hassan ◽  
F. A. Bendary
Keyword(s):  
Particle Swarm Optimization ◽  
Power System ◽  
Pid Controller ◽  
Frequency Control ◽  
Particle Swarm ◽  
Load Frequency Control ◽  
Swarm Optimization ◽  
Load Frequency ◽  
System Frequency ◽  
Tie Line

The main objective of Load Frequency Control (LFC) is to regulate the power output of the electric generator within an area in response to changes in system frequency and tie-line loading. Thus the LFC helps in maintaining the scheduled system frequency and tie-line power interchange with the other areas within the prescribed limits. Most LFCs are primarily composed of an integral controller. The integrator gain is set to a level that compromises between fast transient recovery and low overshoot in the dynamic response of the overall system. This type of controller is slow and does not allow the controller designer to take into account possible changes in operating conditions and non-linearities in the generator unit. Moreover, it lacks robustness. This paper studies LFC in two areas power system using PID controller. In this paper, PID parameters are tuned using different tuning techniques. The overshoots and settling times with the proposed controllers are better than the outputs of the conventional PID controllers. This paper uses MATLAB/SIMULINK software. Simulations are done by using the same PID parameters for the two different areas because it gives a better performance for the system frequency response than the case of using two different sets of PID parameters for the two areas. The used methods in this paper are: a) Particle Swarm Optimization, b) Adaptive Weight Particle Swarm Optimization, c) Adaptive Acceleration Coefficients based PSO (AACPSO) and d) Adaptive Neuro Fuzzy Inference System (ANFIS). The comparison has been carried out for these different controllers for two areas power system. Therefore, the article presents advanced techniques for Load Frequency Control. These proposed techniques are based on Artificial Intelligence. It gives promising results.

Load Frequency Control in Power System via Improving PID Controller Based on Particle Swarm Optimization and ANFIS Techniques

2014 ◽  
Vol 3 (3) ◽  
pp. 1-24 ◽  
Author(s):  
Naglaa K. Bahgaat ◽  
M. I. El-Sayed ◽  
M. A. Moustafa Hassan ◽  
F. A. Bendary
Keyword(s):  
Particle Swarm Optimization ◽  
Power System ◽  
Pid Controller ◽  
Frequency Control ◽  
Particle Swarm ◽  
Load Frequency Control ◽  
Swarm Optimization ◽  
Load Frequency ◽  
System Frequency ◽  
Tie Line

The main objective of Load Frequency Control (LFC) is to regulate the power output of the electric generator within an area in response to changes in system frequency and tie-line loading. Thus the LFC helps in maintaining the scheduled system frequency and tie-line power interchange with the other areas within the prescribed limits. Most LFCs are primarily composed of an integral controller. The integrator gain is set to a level that compromises between fast transient recovery and low overshoot in the dynamic response of the overall system. This type of controller is slow and does not allow the controller designer to take into account possible changes in operating conditions and non-linearities in the generator unit. Moreover, it lacks robustness. This paper studies LFC in two areas power system using PID controller. In this paper, PID parameters are tuned using different tuning techniques. The overshoots and settling times with the proposed controllers are better than the outputs of the conventional PID controllers. This paper uses MATLAB/SIMULINK software. Simulations are done by using the same PID parameters for the two different areas because it gives a better performance for the system frequency response than the case of using two different sets of PID parameters for the two areas. The used methods in this paper are: a) Particle Swarm Optimization, b) Adaptive Weight Particle Swarm Optimization, c) Adaptive Acceleration Coefficients based PSO (AACPSO) and d) Adaptive Neuro Fuzzy Inference System (ANFIS). The comparison has been carried out for these different controllers for two areas power system. Therefore, the article presents advanced techniques for Load Frequency Control. These proposed techniques are based on Artificial Intelligence. It gives promising results.

scholarly journals Optimal Model Predictive Frequency Control Management of Grid Integration PV/Wind/FC/Storage Battery Based Smart Grid Using Multi Objective Particle Swarm Optimization MOPSO

2021 ◽  
Vol 12 ◽  
pp. 46-54
Author(s):  
Adel Elgammal ◽  
Tagore Ramlal
Keyword(s):  
Particle Swarm Optimization ◽  
Adaptive Control ◽  
Smart Grid ◽  
Power System ◽  
Objective Function ◽  
Frequency Control ◽  
Load Frequency Control ◽  
Storage Battery ◽  
Swarm Optimization ◽  
Load Frequency

This article forecasts the performance of smart-grid electrical transmission systems and integrated battery/FC/Wind/PV storage system renewable power sources in the context of unpredictable solar and wind power supplies. The research provided a hybrid renewable energy sources smart grid power system electrical frequency control solution using adaptive control techniques and model predictive control (MPC) based on the Multi-Objective Practical Swarm Optimization Algorithm MOPSO. To solve the problems of parameter tuning in Load Frequency Control, the suggested adaptive control approach is utilized to accomplish on-line adjustment of the Load Frequency Control parameters. During the electrical grid's integration, the system under investigation is a hybrid Wind/PV/FC/Battery smart grid with variable demand load. To achieve optimal outcomes, all of the controller settings for various units in power grids are determined by means of a customized objective function and a particle swarm optimization method rather than a regular objective function with fluctuating restrictions. To suppress the consumption and generation balance, MPCs were designed for each of the Storage Battery, Wind Turbine Generation, and the model Photovoltaic Generation. In addition, demand response (real-time pricing) was used in this scheme to reduce the load frequency by adjusting the controlled loads. The suggested control strategy is evaluated in the Simulink /MATLAB environment in order to analyse the suggested approach's working in the power system, as well as its effectiveness, reliability, robustness, and stability. The simulation findings show that the proposed control method generally converges to an optimal operating point that minimises total user disutility, restores normal frequency and planned tie-line power flows, and maintains transmission line thermal restrictions. The simulation results further indicate that the convergence holds even when the control algorithm uses inaccurate system parameters. Finally, numerical simulations are used to illustrate the proposed algorithm's robustness, optimality, and effectiveness. In compared to previous methodologies, the system frequency recovers effectively and efficiently in the event of a power demand disturbance, as demonstrated. A sensitivity test is also performed to assess the suggested technique's effectiveness.

Sign in / Sign up

Export Citation Format

Share Document