Transient wall temperature measurements of two-phase slug flow in a microchannel

2014 ◽  
Author(s):  
Farzad Houshmand ◽  
Yoav Peles
Keyword(s):  
Wall Temperature ◽  
Slug Flow ◽  
Temperature Measurements ◽  
Two Phase

Local Wall Temperature Measurements in Microchannel Flow Boiling Using Infrared Thermography

2008 ◽  
Author(s):  
Daniel Krebs ◽  
Vinod Narayanan ◽  
James Liburdy ◽  
Deborah Pence
Keyword(s):  
Infrared Thermography ◽  
Wall Temperature ◽  
Heat Sink ◽  
Channel Wall ◽  
Quantitative Measurement ◽  
Flow Boiling ◽  
Temperature Measurements ◽  
Test Facility ◽  
Microchannel Flow ◽  
Two Phase

Quantitative measurement of channel wall temperature in two-phase microchannel flows using infrared thermography is discussed. In particular, the top channel wall temperature of a branching microchannel silicon heat sink is presented. Quantitative temperature measurements require several considerations in the design and fabrication of the heat sink and test facility, in calibration, and in data analysis; each of these are discussed. Temperature measurements, with a spatial resolution of 10 μm, are presented over an 18 mm × 18 mm area of the heat sink during flow boiling.

ACCURACY ANALYSIS OF DIRECT INFRARED TEMPERATURE MEASUREMENTS OF TWO-PHASE CONFINED FLOWS

2018 ◽  
Author(s):  
Andrea Catarsi ◽  
Davide Fioriti ◽  
Mauro Mameli ◽  
Sauro Filippeschi ◽  
Paolo Di Marco
Keyword(s):  
Temperature Measurements ◽  
Accuracy Analysis ◽  
Two Phase ◽  
Confined Flows

On Instabilities in Horizontal Two-Phase Flow

1994 ◽  
Vol 59 (12) ◽  
pp. 2595-2603
Author(s):  
Lothar Ebner ◽  
Marie Fialová
Keyword(s):  
Differential Equation ◽  
Flow Regime ◽  
Slug Flow ◽  
Annular Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Annular Flows ◽  
Flow Regime Maps

Two regions of instabilities in horizontal two-phase flow were detected. The first was found in the transition from slug to annular flow, the second between stratified and slug flow. The existence of oscillations between the slug and annular flows can explain the differences in the limitation of the slug flow in flow regime maps proposed by different authors. Coexistence of these two regimes is similar to bistable behaviour of some differential equation solutions.

Pressure drop and drag reduction in two-phase non-newtonian slug flow

1976 ◽  
Vol 54 (1-2) ◽  
pp. 111-114 ◽  
Author(s):  
Lambert Otten ◽  
Abdelrahman S. Fayed
Keyword(s):  
Pressure Drop ◽  
Drag Reduction ◽  
Slug Flow ◽  
Two Phase

scholarly journals Research on the Dynamic Responses of Simply Supported Horizontal Pipes Conveying Gas-Liquid Two-Phase Slug Flow

Processes ◽  
2021 ◽  
Vol 9 (1) ◽  
pp. 83
Author(s):  
Gang Liu ◽  
Zongrui Hao ◽  
Yueshe Wang ◽  
Wanlong Ren
Keyword(s):  
Slug Flow ◽  
Peak Frequency ◽  
Dynamic Responses ◽  
Piping System ◽  
Transverse Displacement ◽  
Vibration Acceleration ◽  
Two Phase ◽  
Horizontal Pipes ◽  
Simply Supported ◽  
Superficial Gas Velocity

The dynamic responses of simply supported horizontal pipes conveying gas-liquid two-phase slug flow are explored. The intermittent characteristics of slug flow parameters are mainly considered to analyze the dynamic model of the piping system. The results show that the variations of the midpoint transverse displacement could vary from periodic-like motion to a kind of motion whose amplitude increases as time goes on if increasing the superficial gas velocity. Meanwhile, the dynamic responses have certain relations with the vibration acceleration. By analyzing the parameters in the power spectrum densities of vibration acceleration such as the number of predominant frequencies and the amplitude of each peak frequency, the dynamic behaviors of the piping system like periodicity could be calculated expediently.

An Investigation of Two-Phase Slug Flow in Inclined Pipelines

2004 ◽  
Vol 26 (7) ◽  
pp. 627-638 ◽  
Author(s):  
SUAT BAGCI
Keyword(s):  
Slug Flow ◽  
Two Phase

scholarly journals Wall Temperature Measurements in Gas Turbine Combustors With Thermographic Phosphors

2018 ◽  
Vol 141 (4) ◽  
Author(s):  
Patrick Nau ◽  
Zhiyao Yin ◽  
Oliver Lammel ◽  
Wolfgang Meier
Keyword(s):  
Gas Turbine ◽  
Wall Temperature ◽  
Gas Turbines ◽  
High Speed ◽  
Bluff Body ◽  
Temperature Measurements ◽  
Transient Temperature ◽  
High Time Resolution ◽  
Ceramic Surface ◽  
Precessing Vortex Core

Phosphor thermometry has been developed for wall temperature measurements in gas turbines and gas turbine model combustors. An array of phosphors has been examined in detail for spatially and temporally resolved surface temperature measurements. Two examples are provided, one at high pressure (8 bar) and high temperature and one at atmospheric pressure with high time resolution. To study the feasibility of this technique for full-scale gas turbine applications, a high momentum confined jet combustor at 8 bar was used. Successful measurements up to 1700 K on a ceramic surface are shown with good accuracy. In the same combustor, temperatures on the combustor quartz walls were measured, which can be used as boundary conditions for numerical simulations. An atmospheric swirl-stabilized flame was used to study transient temperature changes on the bluff body. For this purpose, a high-speed setup (1 kHz) was used to measure the wall temperatures at an operating condition where the flame switches between being attached (M-flame) and being lifted (V-flame) (bistable). The influence of a precessing vortex core (PVC) present during M-flame periods is identified on the bluff body tip, but not at positions further inside the nozzle.

Experimental Characterization of Slug Flow Velocity Distribution in Two Phase Pipe Flow

2009 ◽  
Author(s):  
Afshin Goharzadeh ◽  
Peter Rodgers
Keyword(s):  
Velocity Distribution ◽  
Slug Flow ◽  
Two Phase ◽  
Significant Drop ◽  
Horizontal Pipe ◽  
Measured Velocity ◽  
Air Bubble ◽  
Velocity Magnitude ◽  
Index Matching ◽  
Refractive Index Matching

This paper presents an experimental study of gas-liquid slug flow inside a horizontal pipe. The influence of air bubble passage on liquid flow is characterized using Particle Image Velocimetry (PIV) combined with Refractive Index Matching (RIM) and fluorescent tracers. A physical insight into the velocity distribution within slug flow is presented. It was observed that the slug flow significantly influences the velocity profile in the liquid film. Measured velocity distributions also revealed a significant drop in the velocity magnitude immediately upstream of the slug nose. These findings aim to aid an understanding of the mechanism of solid transportation in slug flows.

Sign in / Sign up

Export Citation Format

Share Document