Discrete Band-Limited Signal Reconstruction From Irregular Samples

Author(s):  
David G. Long
Author(s):  
Jacopo Tani ◽  
Sandipan Mishra ◽  
John T. Wen

Image sensors are typically characterized by slow sampling rates, which limit their efficacy in signal reconstruction applications. Their integrative nature though produces image blur when the exposure window is long enough to capture relative motion of the observed object relative to the sensor. Image blur contains more information on the observed dynamics than the typically used centroids, i.e., time averages of the motion within the exposure window. Parameters characterizing the observed motion, such as the signal derivatives at specified sampling instants, can be used for signal reconstruction through the derivative sampling extension of the known sampling theorem. Using slow image based sensors as derivative samplers allows for reconstruction of faster signals, overcoming Nyquist limitations. In this manuscript, we present an algorithm to extract values of a signal and its derivatives from blurred image measurements at specified sampling instants, i.e. the center of the exposure windows, show its application in two signal reconstruction numerical examples and provide a numerical study on the sensitivity of the extracted values to significant problem parameters.


1979 ◽  
Vol 23 (1) ◽  
pp. 568-572 ◽  
Author(s):  
Tarald O. Kvålseth

Information-theory statistics were used as performance measures during selfpaced pursuit tracking tasks with a time-discrete band-limited white Gaussian noise reference input and both time-discrete and time-continuous response signals. The experimental results from 64 subjects showed that the generated information rate increased exponentially with increasing input variance or input entropy. The spacing between successive input points had no general significant effects on the information rate. Discrete responses produced significantly higher information rates than continuous responses. The maximum information capacity was determined to be centered at about 10 bits/sec with asymptotes at about 11 bits/sec for discrete responses and 9 bits/sec for continuous responses.


Sensors ◽  
2020 ◽  
Vol 20 (21) ◽  
pp. 6246
Author(s):  
Dongxiao Wang ◽  
Xiaoqin Liu ◽  
Xing Wu ◽  
Zhihai Wang

Important state parameters, such as torque and angle obtained from the servo control and drive system, can reflect the operating condition of the equipment. However, there are two problems with the information obtained through the network from the control and drive system: the low sampling rate, which does not meet the sampling theorem and the nonuniformity of the sampling points. By combing equivalent sampling and nonuniform signal reconstruction theory, this paper proposes a reconstruction method for signal obtained from servo system in periodic reciprocating motion. Equivalent sampling combines the low rate and nonuniform samples from multiple periods into one single period, so that the equivalent sampling rate is far increased. Then, the nonuniform samples with high density are further resampled to meet the reconstruction conditions. This step can avoid the amplitude error in the reconstructed signal and increase the possibility of successful reconstruction. Finally, the reconstruction formula derived from basis theory is applied to recover the signal. This method has been successfully verified by the simulation signal of the robot swing process and the actual current signal collected on the robot arm testbed.


Geophysics ◽  
2004 ◽  
Vol 69 (4) ◽  
pp. 994-1004 ◽  
Author(s):  
Li‐Yun Fu

I propose a joint inversion scheme to integrate seismic data, well data, and geological knowledge for acoustic impedance estimation. I examine the problem of recovering acoustic impedance from band‐limited seismic data. Optimal estimation of impedance can be achieved by combined applications of model‐based and deconvolution‐based methods. I incorporate the Robinson seismic convolutional model (RSCM) into the Caianiello neural network for network mapping. The Caianiello neural network provides an efficient approach to decompose the seismic wavelet and its inverse. The joint inversion consists of four steps: (1) multistage seismic inverse wavelets (MSIW) extraction at the wells, (2) the deconvolution with MSIW for initial impedance estimation, (3) multistage seismic wavelets (MSW) extraction at the wells, and (4) the model‐based reconstruction of impedance with MSW for improving the initial impedance model. The Caianiello neural network offers two algorithms for the four‐step process: neural wavelet estimation and input signal reconstruction. The frequency‐domain implementation of the algorithms enables control of the inversion on different frequency scales and facilitates an understanding of reservoir behavior on different resolution scales. The test results show that, with well control, the joint inversion can significantly improve the spatial description of reservoirs in data sets involving complex continental deposits.


Sign in / Sign up

Export Citation Format

Share Document