Non-Traditional Shape Variations on Bistable Carbon Fiber Reinforced Polymer Laminates

Author(s):  
Christopher M. Nelon ◽  
Jonathan Figueroa ◽  
Oliver J. Myers ◽  
Aaron Shepard

Abstract The ability of a material to display two equilibrium states, called bistability, has been previously observed in carbon fiber reinforced polymers (CFRPs). For bistability to occur, the laminate must consist of an unsymmetric layup about its midplane which generates internal residual stress from thermal contraction. Prior studies have observed bistability in CFRPs with small-scale rectangular geometries where all sides were less than 250 mm. The aim of this paper is to demonstrate the existence of bistability in large-scale CFRPs with rectangular and non-rectangular geometries. Experiments and finite element analyses were conducted to determine the viability of bistability in large-scale CFRPs where at least one length aspect of the specimen was greater than or equal to 304.8 mm. Specimens whose shapes included rectangles, deltoids, triangles, and circles, were fabricated and tested to determine the presence of bistability and the associated curvature for each cured equilibrium state. Rectangular specimens had a side length of 914.4 mm and widths that varied from 177.8 to 457.2 mm. For the deltoids, triangles, and circles, one length aspect (i.e. the height, hypotenuse, and diameter, respectively) equaled 304.8 mm. Finite element models were created to compare the equilibrium shapes’ curvatures and displacements with the experimental laminates; the existence of bistability was also examined using a nondimensionalized bifurcation plot. Experimentally, bistability was found to occur for the fabricated laminates up to six plies. As the studied laminates could be considered thin, they displayed cylindrical cured shapes. The non-traditional shaped CFRPs followed bistability trends found for traditional, small-scale, rectangular laminates. An inverse relationship between the ply count and curvature was exhibited for the large-scale, rectangular laminates; curvature decreased as the number of plies in the laminate increased.

2020 ◽  
Vol 23 (3) ◽  
pp. 313-318
Author(s):  
Sarah Fadhil Abass ◽  
Bassman R. Muhammad ◽  
Qais A. Hasan ◽  
Qais A. Hasan

In this vast world after an earthquake lessons are learned; many strategies have been considered in order to achieve a proper seismic strength capacity.The aim of this paper is studying the seismic behavior of a typical reinforced concrete bridge pier in Iraq and implementing a proper technique of strengthening in order to fix any damage that had happened.Structure of a full scale three-dimensional finite element model was used in order to simulate a reinforced concrete pier via the computer software ABAQUS/CAE 2017 using concrete plasticity damage model (CDP).Under the action of Halabja earthquake, which was recorded at city of Halabja in Iraq on 12 November 2017, the behavior of model was traced, analyzed and the resulted damages were managed.The finite element analysis results indicated that the proposed configuration of carbon fiber reinforced polymers laminates substantially increases the lateral load strength and deformation capacity of the bridge pier


Sign in / Sign up

Export Citation Format

Share Document