A fiber-optic localized surface plasmon resonance (LSPR) sensor anchored with metal organic framework (HKUST-1) film for acetone sensing

Author(s):  
LiangLiang Liu ◽  
ChenYang He ◽  
Stephen P. Morgan ◽  
Ricardo Correia ◽  
Serhiy Korposh
Sensors ◽  
2021 ◽  
Vol 21 (4) ◽  
pp. 1420
Author(s):  
Chenyang He ◽  
Liangliang Liu ◽  
Sergiy Korposh ◽  
Ricardo Correia ◽  
Stephen P. Morgan

A tip-based fibreoptic localised surface plasmon resonance (LSPR) sensor is reported for the sensing of volatile organic compounds (VOCs). The sensor is developed by coating the tip of a multi-mode optical fibre with gold nanoparticles (size: 40 nm) via a chemisorption process and further functionalisation with the HKUST-1 metal–organic framework (MOF) via a layer-by-layer process. Sensors coated with different cycles of MOFs (40, 80 and 120) corresponding to different crystallisation processes are reported. There is no measurable response to all tested volatile organic compounds (acetone, ethanol and methanol) in the sensor with 40 coating cycles. However, sensors with 80 and 120 coating cycles show a significant redshift of resonance wavelength (up to ~9 nm) to all tested volatile organic compounds as a result of an increase in the local refractive index induced by VOC capture into the HKUST-1 thin film. Sensors gradually saturate as VOC concentration increases (up to 3.41%, 4.30% and 6.18% in acetone, ethanol and methanol measurement, respectively) and show a fully reversible response when the concentration decreases. The sensor with the thickest film exhibits slightly higher sensitivity than the sensor with a thinner film. The sensitivity of the 120-cycle-coated MOF sensor is 13.7 nm/% (R2 = 0.951) with a limit of detection (LoD) of 0.005% in the measurement of acetone, 15.5 nm/% (R2 = 0.996) with an LoD of 0.003% in the measurement of ethanol and 6.7 nm/% (R2 = 0.998) with an LoD of 0.011% in the measurement of methanol. The response and recovery times were calculated as 9.35 and 3.85 min for acetone; 5.35 and 2.12 min for ethanol; and 2.39 and 1.44 min for methanol. The humidity and temperature crosstalk of 120-cycle-coated MOF was measured as 0.5 ± 0.2 nm and 0.5 ± 0.1 nm in the humidity range of 50–75% relative humidity (RH) and temperature range of 20–25 °C, respectively.


RSC Advances ◽  
2015 ◽  
Vol 5 (31) ◽  
pp. 23990-23998 ◽  
Author(s):  
Gaoling Liang ◽  
Zhongjun Zhao ◽  
Yin Wei ◽  
Kunping Liu ◽  
Wenqian Hou ◽  
...  

A simple, label-free and cost-effective localized surface plasmon resonance (LSPR) immunosensing method was developed for detection of alpha-fetoprotein (AFP).


2019 ◽  
Vol 7 (1) ◽  
Author(s):  
Se-Woong Bae ◽  
Hyeong-Min Kim ◽  
Jae-Hyoung Park ◽  
Seung-Ki Lee

Abstract Fiber optic based localized surface plasmon resonance (FO-LSPR) sensor is one of the biosensors that detects specific biomolecules and can detect the onset of disease. In this paper, we propose two methods to improve the signal to noise ratio (SNR) of the sensor, which is one of the main characteristics of the FO-LSPR sensor. The first method is to increase the intensity of the sensor by increasing the size of gold nanoparticle (Au NP) formed on the optical fiber surface by Au capping method. The second method is to form a structure that reduces the reflection by increasing the roughness of the surface by etching the surface of the optical fiber using the Au NP formed on the surface of the optical fiber as a mask. Increasing the roughness of the optical fiber surface can reduce the background signal of the sensor. The two methods mentioned above can increase the SNR of the sensor. When the SNR of the sensor is increased, the efficiency of the sensor is improved.


Sign in / Sign up

Export Citation Format

Share Document