Free Convective Mass Transfer at Isosceles Triangular Surfaces of Varying Inclination

2003 ◽  
Vol 68 (11) ◽  
pp. 2080-2092 ◽  
Author(s):  
Martin Keppert ◽  
Josef Krýsa ◽  
Anthony A. Wragg
Keyword(s):  
Mass Transfer ◽  
Transfer Rate ◽  
Mass Transfer Rate ◽  
Mass Transfer Process ◽  
Sulfate Solution ◽  
Convective Mass Transfer ◽  
Varying Length ◽  
Inclined Surface ◽  
Vertical Case ◽  
Limiting Diffusion Current

The limiting diffusion current technique was used for investigation of free convective mass transfer at down-pointing up-facing isosceles triangular surfaces of varying length and inclination. As the mass transfer process, copper deposition from acidified copper(II) sulfate solution was used. It was found that the mass transfer rate increases with inclination from the vertical to the horizontal position and decreases with length of inclined surface. Correlation equations for 7 angles from 0 to 90° were found. The exponent in the ShL-RaL correlation ranged from 0.247 for the vertical case, indicating laminar flow, to 0.32 for inclinations of 60 to 90°, indicating mixed or turbulent flow. The general correlation ShL = 0.358(RaL sin θ)0.30 for the RaL sin θ range from 7 × 106 to 2 × 1011 and inclination range from 15 to 90° was obtained.

Free Convective Mass Transfer at Down-Pointing Isosceles Triangles of Varying Inclination

1998 ◽  
Vol 63 (12) ◽  
pp. 2114-2122 ◽  
Author(s):  
Josef Krýsa ◽  
Fukuya Iino ◽  
Anthony A. Wragg
Keyword(s):  
Mass Transfer ◽  
Entire Range ◽  
Transfer Rate ◽  
Mass Transfer Rate ◽  
Diffusion Current ◽  
Convective Mass Transfer ◽  
Transfer Measurement ◽  
Inclined Surface ◽  
Isosceles Triangles ◽  
Limiting Diffusion Current

Free convective mass transfer at down-pointing triangular surfaces of different length and down-facing inclination was investigated using the limiting diffusion current technique of mass transfer measurement. The mass transfer rate was observed to be higher for a down-pointing triangular inclined surface over the entire range of inclination than that for an inclined rectangular surface because of the different rleading edger condition. A mass transfer correlation for down-facing inclined triangular surfaces of different length was found to be ShL = 0.774(RaL cos θ)0.25 for the RaL cos θ range from 2 . 106 to 2 . 1011.

Dissolution-driven convection in a heterogeneous porous medium

2018 ◽  
Vol 857 ◽  
pp. 61-79 ◽  
Author(s):  
Ashwanth K. R. Salibindla ◽  
Rabin Subedi ◽  
Victor C. Shen ◽  
Ashik U. M. Masuk ◽  
Rui Ni
Keyword(s):  
Mass Transfer ◽  
Transfer Rate ◽  
Mass Transfer Rate ◽  
Horizontal Layer ◽  
Density Contrast ◽  
Convective Mass Transfer ◽  
Anisotropic Permeability ◽  
Two Fluids ◽  
Finger Width ◽  
Disc Size

Motivated by subsurface carbon sequestration, an experimental investigation of dissolution-driven Rayleigh–Darcy convection using two miscible fluids in a Hele-Shaw cell is conducted. A thin horizontal layer of circular impermeable discs is inserted to create an environment with heterogeneous and anisotropic permeability. The Sherwood number that measures the convective mass transfer rate between two fluids at the interface is linked to different parameters of the disc layer, including the disc size, spacing, layer permeability and its relative height with respect to the fluid interface. It is surprising that the convective mass transfer rate in our configuration is dominated by the disc spacing, but almost independent of either the disc size or the mean permeability of the layer. To explain this dependence, the convective mass transfer rate is decomposed into the number, velocity and density contrast of fingers travelling through the disc layer. Both the number and density contrast of fingers show dependences on the disc layer permeability, even though the product of them, the mass transfer rate, does not. In addition, the density contrast also shows a non-monotonic dependence on the disc spacing. The transition point is at a spacing that is close to the finger width. Based on this observation, a simple model based on mixing and scale competition is proposed, and it shows an excellent agreement with the experimental results.

Distributed mass transfer rate for modelling the leaching of porous granular materials containing soluble pollutants

2000 ◽  
Vol 55 (7) ◽  
pp. 1257-1267 ◽  
Author(s):  
Tiruta-Barna Ligia ◽  
Barna Radu ◽  
Moszkowicz Pierre ◽  
Bae Hae-Ryong
Keyword(s):  
Mass Transfer ◽  
Granular Materials ◽  
Transfer Rate ◽  
Mass Transfer Rate

Enhancement of formic acid production from CO2 in formate dehydrogenase reaction using nanoparticles

RSC Advances ◽  
2016 ◽  
Vol 6 (111) ◽  
pp. 109978-109982 ◽  
Author(s):  
Young-Kee Kim ◽  
Sung-Yeob Lee ◽  
Byung-Keun Oh
Keyword(s):  
Mass Transfer ◽  
Formic Acid ◽  
Acid Production ◽  
Transfer Rate ◽  
Formate Dehydrogenase ◽  
Mass Transfer Rate ◽  
Liquid Mass ◽  
Dehydrogenase Reaction ◽  
Liquid Mass Transfer ◽  
Mesoporous Nanoparticles

In an enzyme process using a gas substrate, the enhanced gas liquid mass transfer rate of the gas substrate by methyl-functionalized mesoporous nanoparticles could improve the productivity.

Sign in / Sign up

Export Citation Format

Share Document