Failure investigation of a Ag sinter-joining SiC power device under harsh cycling conditions

2021 ◽  
Vol MA2021-02 (34) ◽  
pp. 994-994
Author(s):  
Zheng Zhang ◽  
Chuantong Chen ◽  
Aiji Suetake ◽  
Tetsu Takemasa ◽  
Ming-Chun Hsieh ◽  
...  
2021 ◽  
Vol 104 (7) ◽  
pp. 93-100
Author(s):  
Zheng Zhang ◽  
Chuantong Chen ◽  
Aiji Suetake ◽  
Tetsu Takemasa ◽  
Ming-Chun Hsieh ◽  
...  

2020 ◽  
Vol MA2020-02 (26) ◽  
pp. 1834-1834
Author(s):  
Katsuaki Suganuma ◽  
Chuantong Chen ◽  
Zheng Zhang ◽  
Aishi Suetake ◽  
Ming Chun Hsieh ◽  
...  

2010 ◽  
Vol 130 (1) ◽  
pp. 32-36 ◽  
Author(s):  
Ikunorii TAKATA ◽  
Gourab Majumdar
Keyword(s):  

2009 ◽  
Vol 129 (12) ◽  
pp. 817-820 ◽  
Author(s):  
Ikunori TAKATA ◽  
Gourab Majumdar
Keyword(s):  

Author(s):  
E. A. Vakulin ◽  
A. I. Zayats ◽  
V. A. Beklemeshev ◽  
V. A. Ivashkevich ◽  
V. A. Khazhiev ◽  
...  

Investigation of failures is one of the critical activities of mining and haulage equipment operability assurance in mining. Maintaining failure investigation at the required quality level, it is possible to identify provisions, rules and procedures that should be revised or changed, operation conditions that should be improved, additional personnel training, if required, etc. Investigation of failures in mines is under responsibility of machine men and electricians of maintenance and operation services. In reality, factory management and setup for production condition weak concernment of these workers in quality investigation aimed at finding of sources of equipment failures. This article describes real-life results achieved in development and use of maintenance service operation, technology and management monitoring. The requirements are substantiated for quality improvement in failure cause finding and removal in mining and haulage equipment at Chernogorsky open pit mine, SUEK-Khakassia. Causes of the present quality of failure investigation by machine men of Chernogorsky Repair and Engineering Works and Chernogorsky open pit mine are revealed. The proposed recommended practices will improve quality of mining and haulage equipment failure investigation.


2013 ◽  
Vol 50 (12) ◽  
pp. 821-830
Author(s):  
K. Andersson ◽  
R. Pederson ◽  
B. Pettersson ◽  
U. Klement

2013 ◽  
Vol 50 (7) ◽  
pp. 501-512
Author(s):  
S. Leggemann ◽  
E. Cagliyan ◽  
S. Riesenbeck ◽  
A. Neidel

Author(s):  
Clarence Rebello ◽  
Ted Kolasa ◽  
Parag Modi

Abstract During the search for the root cause of a board level failure, all aspects of the product must be revisited and investigated. These aspects encompass design, materials, and workmanship. In this discussion, the failure investigation involved an S-Band Power Amplifier assembly exhibiting abnormally low RF output power where initial troubleshooting did not provide a clear cause of failure. A detailed fault tree drove investigations that narrowed the focus to a few possible root causes. However, as the investigation progressed, multiple contributors were eventually discovered, some that were not initially considered.


Sign in / Sign up

Export Citation Format

Share Document