scholarly journals Fatal Cobalt Toxicity after a Non-Metal-on-Metal Total Hip Arthroplasty

2017 ◽  
Vol 2017 ◽  
pp. 1-5 ◽  
Author(s):  
Rinne M. Peters ◽  
Pax Willemse ◽  
Paul C. Rijk ◽  
Mels Hoogendoorn ◽  
Wierd P. Zijlstra
Keyword(s):  
Femoral Head ◽  
Total Hip Arthroplasty ◽  
Hip Arthroplasty ◽  
Hip Prosthesis ◽  
X Rays ◽  
Total Hip ◽  
Metal On Metal ◽  
Metal Wear ◽  
Cobalt Toxicity ◽  
Ceramic On Ceramic

This case illustrates the potential for systemic cobalt toxicity in non-metal-on-metal bearings and its potentially devastating consequences. We present a 71-year-old male with grinding sensations in his right hip following ceramic-on-ceramic total hip arthroplasty (THA). After diagnosing a fractured ceramic liner, the hip prosthesis was revised into a metal-on-polyethylene bearing. At one year postoperatively, X-rays and MARS-MRI showed a fixed reversed hybrid THA, with periarticular densities, flattening of the femoral head component, and a pattern of periarticular metal wear debris and pseudotumor formation. Before revision could take place, the patient was admitted with the clinical picture of systemic cobalt toxicity, supported by excessively high serum cobalt and chromium levels, and ultimately died. At autopsy dilated cardiomyopathy as cause of death was hypothesized. A third body wear reaction between ceramic remnants and the metal femoral head very likely led to excessive metal wear, which contributed systemic cobalt toxicity leading to neurotoxicity and heart failure. This case emphasizes that fractured ceramic-on-ceramic bearings should be revised to ceramic-on-ceramic or ceramic-on-polyethylene bearings, but not to metal-on-polyethylene bearings. We aim to increase awareness among orthopedic surgeons for clinical clues for systemic cobalt intoxication, even when there is no metal-on-metal bearing surface.

scholarly journals The influence of bearing surfaces on revisions due to dislocations in total hip arthroplasty

2021 ◽  
Vol 32 (9) ◽  
Author(s):  
Francesco Castagnini ◽  
Barbara Bordini ◽  
Monica Cosentino ◽  
Cristina Ancarani ◽  
Federica Mariotti ◽  
...  
Keyword(s):  
Total Hip Arthroplasty ◽  
Hip Arthroplasty ◽  
Lower Risk ◽  
Time Distribution ◽  
Total Hip ◽  
Arthroplasty Registry ◽  
Metal On Metal ◽  
The Impact ◽  
Frequent Reason ◽  
Ceramic On Ceramic

Abstract Introduction Recurrent dislocations are still the most frequent reason for revision in total hip arthroplasty (THA). The impact of bearing surfaces on dislocations is still controversial. We hypothesized that: (1) bearing surfaces influence the revisions due to dislocations; (2) ceramic-on-ceramic reduced the revisions for dislocations in adjusted models; (3) Delta-on-Delta bearings reduced the revisions for dislocations in comparison to surfaces with cross-linked polyethylene. Materials and methods The regional arthroplasty registry was enquired about bearing surfaces and revisions for dislocations and instability. Unadjusted and adjusted rates were provided, including sex, age (<65 years or ≥65 years), head diameter (≤28 mm or >28 mm; <36 mm or ≥36 mm) as variables. 44,065 THAs were included. Results The rate of revisions for dislocations was significantly lower in ceramic-on-ceramic and metal-on-metal bearings (unadjusted rates). After adjusting for age, sex, and head size (36 and 28 mm), hard-on-hard bearings were protective (p < 0.05): ceramic-on-ceramic had a lower risk of revisions due to dislocation than ceramic-on-polyethylene (HR 1.6, 95% CI 1.2–2.2 p = 0.0009). The rate of revisions for dislocation was similar in bearings with cross-linked polyethylene and Delta-on-Delta articulations, in unadjusted and adjusted models. Conclusion Bearings with conventional polyethylene were more predisposed to dislocations. Currently adopted bearings exerted no significant influence on revisions due to dislocations. These findings could be primarily related to wear, but due to the time distribution, soft tissue envelopes and surface tension may also play a role. Pre-clinical biomechanical evaluations and prospective matched cohort studies are required to draw definitive conclusions.

scholarly journals Modified trapdoor procedures using autogenous tricortical iliac graft without preserving the broken cartilage to treat osteonecrosis of the femoral head: A Prospective Cohort Study With Historical Controls

2019 ◽  
Author(s):  
Qi Cheng ◽  
fengchao zhao ◽  
Shi-zhuang Xu ◽  
Li Zheng ◽  
Xin Zheng ◽  
...  
Keyword(s):  
Articular Cartilage ◽  
Femoral Head ◽  
Total Hip Arthroplasty ◽  
Hip Arthroplasty ◽  
Harris Hip Score ◽  
X Rays ◽  
Clinical Failure ◽  
Light Bulb ◽  
Total Hip

Abstract Background The aim of the present study was to investigate clinical and radiological outcomes of autologous tricortical iliac graft through a window created at the femoral head, without suturing the opened articular cartilage to treat osteonecrosis of the femoral head (ONFH), called modified trapdoor procedures. Methods A total of 59 consecutive patients (67 hips ) with ONFH were included in this study, which was conducted during the period from April 2009 to March 2012. Harris hip scores (HHS) were used to evaluate hip function pre- and postoperatively. Anteroposterior and frog-position X-rays and magnetic resonance imaging (MRI) were conducted to evaluate lesion location, size, and ARCO stage. Clinical failure was defined as score < 80 points or treatment by total hip arthroplasty(THA). Radiographic failure was defined as a > 3 mm of collapse in the hip. This group was retrospectively matched according to the ARCO stage, extent, location, etiology of the lesion, average age, gender, and preoperative Harris hip score to a group of 59 patients (67 hips) who underwent the“light bulb”approach during March 2007 to April 2009. Results Mean follow-up was 91.2 ± 13.6 months (range, 75–115 months). Mean HHS was 91.3 ± 4.5, compared with 83.1± 4.5 in the “light bulb” cohort at the 6 years follow-up examination ( P < 0.001). At the 6 years follow-up, for modified trapdoor procedures, five hips (8.5%) were classified as clinical failure, and 3 hips underwent total hip arthroplasty; Seven hips were classified as (10.4%) radiographic failure.The clinical and radiographic failure of the hips treated with the modified trapdoor procedure was significantly lower than that of the hips treated with the “light bulb” procedure (p < 0.05). Survival of the joint was not significantly related to the location of the femoral head lesion between two groups, but there was better clinical and radiographic results in modified trapdoor procedures with Size-C and the ARCO stage III. Conclusion The study demonstrated superior medterm clinical results in ONFH with the use of autologous tricortical iliac block graft through a femoral head window, without suturing the opened articular cartilage.

Fracture of a Ceramic Femoral Head After Ceramic-On-Ceramic Total Hip Arthroplasty

2006 ◽  
Vol 21 (7) ◽  
pp. 1072-1073 ◽  
Author(s):  
Manuel Malillos Torán ◽  
Jorge Cuenca ◽  
Ángel Antonio Martinez ◽  
Antonio Herrera ◽  
Javier Vicente Thomas
Keyword(s):  
Femoral Head ◽  
Total Hip Arthroplasty ◽  
Hip Arthroplasty ◽  
Total Hip ◽  
Ceramic Femoral Head ◽  
Ceramic On Ceramic

scholarly journals Modified trapdoor procedures  using autogenous tricortical iliac graft  without preserving the broken cartilage to treat osteonecrosis of the femoral head: A Prospective Cohort Study With Historical Controls

2020 ◽  
Author(s):  
qi Cheng ◽  
fengchao zhao ◽  
Shizhuang Xu ◽  
Li Zheng ◽  
Xin Zheng
Keyword(s):  
Articular Cartilage ◽  
Femoral Head ◽  
Total Hip Arthroplasty ◽  
Hip Arthroplasty ◽  
Harris Hip Score ◽  
X Rays ◽  
Clinical Failure ◽  
Light Bulb ◽  
Total Hip

Abstract Background The aim of the present study was to investigate clinical and radiological outcomes of autologous tricortical iliac graft through a window created at the femoral head, without suturing the opened articular cartilage to treat osteonecrosis of the femoral head (ONFH), called modified trapdoor procedures.Methods A total of 59 consecutive patients (67 hips; 36 males and 23 females) with ONFH were included in this study, which was conducted during the period from April 2009 to March 2012. Patient age ranged from 27 to 46 years old, with mean age of 36.3 years. Harris hip scores (HHS) were used to evaluate hip function pre- and postoperatively. Anteroposterior and frog-position X-rays and magnetic resonance imaging (MRI) were conducted to evaluate lesion location, size, and ARCO stage. Clinical failure was defined as score < 80 points or treatment by total hip arthroplasty(THA). Radiographic failure was defined as a > 3 mm of collapse in the hip. This group was retrospectively matched according to the ARCO stage, extent, location, etiology of the lesion, average age, gender, and preoperative Harris hip score to a group of 59 patients (67 hips) who underwent the“light bulb”approach during March 2007 to April 2009. Results Mean follow-up was 91.2 ± 13.6 months (range, 75–115 months). Mean HHS was 91.3 ± 4.5, compared with 83.1± 4.5 in the “light bulb” cohort at the 6 years follow-up examination (P < 0.001). At the 6 years follow-up, for modified trapdoor procedures, five hips (8.5%) were classified as clinical failure, and 3 hips underwent total hip arthroplasty; Seven hips were classified as (10.4%) radiographic failure.The clinical and radiographic failure of the hips treated with the modified trapdoor procedure was significantly lower than that of the hips treated with the “light bulb” procedure (p < 0.05). Survival of the joint was not significantly related to the location of the femoral head lesion between two groups, but there was better clinical and radiographic results in modified trapdoor procedures with Size-C and the ARCO stage III.Conclusion The study demonstrated superior medterm clinical results in ONFH with the use of autologous tricortical iliac block graft through a femoral head window, without suturing the opened articular cartilage. The results of this femoral head-preserving procedure in patients with postcollapse osteonecrosis and large lesion are superior to those of the “light bulb” procedure treatment.

scholarly journals Pseudotumor in Metal-on-metal Total Hip Arthroplasty: An Unusual Complication

2018 ◽  
Vol 52 (1) ◽  
pp. 26-30
Author(s):  
Jagandeep S Virk ◽  
Sudhir K Garg ◽  
Purnima Aggarwal ◽  
Reetu Kundu ◽  
Robin Bohat
Keyword(s):  
Total Hip Arthroplasty ◽  
Hip Arthroplasty ◽  
Wear Debris ◽  
Ultrahigh Molecular Weight Polyethylene ◽  
Unusual Complication ◽  
Metal Debris ◽  
Total Hip ◽  
Metal On Metal ◽  
Metal Wear ◽  
New Type

ABSTRACT Second-generation metal-on-metal (MoM) total hip arthroplasty (THA) was introduced to overcome the complications associated with the wear debris from ultrahigh molecular weight polyethylene (UHMWPE). However, a new type of complication began appearing, described as aseptic lymphocyte-dominated vasculitis-associated lesion (ALVAL). Patients with ALVAL complain of pain and, in some cases, extensive swelling around the hip joint known as “pseudotumors.” The cause is unknown and probably multifactorial. This may be an adverse reaction to an excess of particulate metal wear debris or a hypersensitivity reaction to a normal amount of metal debris. Surgical findings are typical and symptoms tend to resolve reliably following conversion to an alternative bearing surface. We report one such case of a 55-year-old male, who underwent a revision of bearing surfaces because of ALVAL and pseudotumor formation following an MoM THA at our institute. How to cite this article Virk JS, Garg SK, Aggarwal P, Kundu R, Bohat R. Pseudotumor in Metal-on-metal Total Hip Arthroplasty: An Unusual Complication. J Postgrad Med Edu Res 2018;52(1):26-30.

scholarly journals Serum ion levels after ceramic-on-ceramic and metal-on-metal total hip arthroplasty: 8-year minimum follow-up

2008 ◽  
Vol 26 (12) ◽  
pp. 1569-1576 ◽  
Author(s):  
Lucia Savarino ◽  
Giovanni Padovani ◽  
Massimo Ferretti ◽  
Michelina Greco ◽  
Elisabetta Cenni ◽  
...  
Keyword(s):  
Total Hip Arthroplasty ◽  
Hip Arthroplasty ◽  
Total Hip ◽  
Metal On Metal ◽  
Ceramic On Ceramic
Sign in / Sign up

Export Citation Format

Share Document