scholarly journals Automated Detection and Quantification of Circadian Eye Blinks Using a Contact Lens Sensor

2015 ◽  
Vol 4 (1) ◽  
pp. 4 ◽  
Author(s):  
Christophe Gisler ◽  
Antonio Ridi ◽  
Jean Hennebert ◽  
Robert N. Weinreb ◽  
Kaweh Mansouri
2010 ◽  
Vol 12 (S1) ◽  
Author(s):  
Sotirios A Tsaftaris ◽  
Xiangzhi Zhou ◽  
Richard Tang ◽  
Aggelos Katsaggelos ◽  
Debiao Li ◽  
...  

PLoS ONE ◽  
2021 ◽  
Vol 16 (3) ◽  
pp. e0248211
Author(s):  
Kevin Gillmann ◽  
Robert Wasilewicz ◽  
Kirsten Hoskens ◽  
Sonja Simon-Zoula ◽  
Kaweh Mansouri

Purpose To address the unmet need of continuous IOP monitoring, a Pressure-Measuring Contact Lens (PMCL) was developed to measure IOP in millimeters of mercury (mmHg) continuously over 24 hours. The present study assessed the reliability of the novel PMCL. Methods In this prospective open-label clinical study, healthy and open-angle glaucoma (OAG) subjects were fitted with the PMCL, and pneumatonometry was performed on study eyes (in absence of the PMCL) and on fellow eyes before, during, and after provocative tests. The primary outcome measures were (1) mean IOP difference between same-eye measurements, and (2) percentage of timepoints at which IOP measured by the PMCL was within 5 mmHg of that measured by pneumatonometry in the fellow eye. Results Eight subjects were analysed (4 healthy, 4 OAG). The average difference in successive IOP measurements made by pneumatonometry and with the PMCL was 2.0±4.3mmHg at placement-time, and 6.5±15.2mmHg at removal time. During water drinking test, a significant increase in IOP was detected both by PMCL in the study eye (2.4±2.5mmHg, p = 0.03) and by pneumatonometry in the fellow eye (1.9±1.9mmHg, p = 0.02). Over the 24-hour recording, 88.0% of IOP variations measured by the PMCL were within 5mmHg of that measured with the pneumatonometer in the fellow eye. A transient corneal erosion of severe intensity was observed following removal of the PMCL on one single eye, and may have affected measurement accuracy in that eye. Conclusions This study is a proof-of-concept for this novel PMCL, and its results are encouraging, with a fair accuracy in IOP values measurement and good sensitivity to subtle IOP variations.


Author(s):  
Chien-Kai Tseng ◽  
Yu-Chieh Huang ◽  
Shang-Wei Tsai ◽  
Guan-Ting Yeh ◽  
Chung-Hao Chang ◽  
...  

2018 ◽  
Vol 194 ◽  
pp. 46-53 ◽  
Author(s):  
Keith R. Martin ◽  
Kaweh Mansouri ◽  
Robert N. Weinreb ◽  
Robert Wasilewicz ◽  
Christophe Gisler ◽  
...  

2018 ◽  
pp. 222-222
Author(s):  
Shibal Bhartiya ◽  
Parul Ichhpujani ◽  
Talvir Sidhu

Author(s):  
Ana Moya ◽  
Anton Guimerà ◽  
Irene Sánchez ◽  
Vladimir Laukin ◽  
Raúl Martín ◽  
...  

A new portable measuring device for monitoring intraocular pressure with a non invasive system using a prototype of contact lens has been developed. The contact lens is based on a new organic flexible highly piezo-resisitive film sensor that is glued to the central hole of a lens. The measuring system is wire connected to the contact lens and incorporates user interface methods and a Bluetooth link for bi-directional wireless data transfer. The key design aspects of such architecture are discussed in this paper. The system is designed with an architecture that can be integrated in the future in order to be placed in the contact lens. The discrete system is used to validate the electronic measurement operation and the contact lens sensor (CLS). The measurement instrument can calibrate the differences of the nominal value of the sensor and measure resistances variations that are related to pressure variations. The measuring system and the contact lens sensor were tested with an eye phantom and with enucleated pig eyes by applying pressure changes between 7 to 32 mmHg recording the electrical changes with the portable device.


Sign in / Sign up

Export Citation Format

Share Document