222 Time and Temperature Dependence of Flexural Strength of CFRP Laminates Using Heat-Resistant Resin

2002 ◽  
Vol 10.1 (0) ◽  
pp. 489-492
Author(s):  
Yozo Hamagami ◽  
Naoyuki Sekine ◽  
Masayuki Nakada ◽  
Yasushi Miyano
Keyword(s):  
Flexural Strength ◽  
Temperature Dependence ◽  
Cfrp Laminates ◽  
Heat Resistant

scholarly journals Time and Temperature Dependence on Flexural Strength of Heat-resistant CFRP Laminates

2003 ◽  
Vol 46 (3) ◽  
pp. 437-440 ◽  
Author(s):  
Yozo HAMAGAMI ◽  
Naoyuki SEKINE ◽  
Masayuki NAKADA ◽  
Yasushi MIYANO
Keyword(s):  
Flexural Strength ◽  
Temperature Dependence ◽  
Cfrp Laminates ◽  
Heat Resistant

Time-temperature dependence of flexural strength of unidirectional CFRP using pitch based carbon fibers.

1991 ◽  
Vol 40 (449) ◽  
pp. 192-198
Author(s):  
Yasushi MIYANO ◽  
Yukio TAKAMURA ◽  
Megumu SUZUKI ◽  
Michihiro MOHRI
Keyword(s):  
Flexural Strength ◽  
Temperature Dependence ◽  
Carbon Fibers

The Temperature Dependence of Yield Stress and Fracture Toughness in Unstabilized Zirconia Crystals

1986 ◽  
Vol 78 ◽  
Author(s):  
T. W. Coyle ◽  
R. P. Ingel ◽  
P. A. Willging
Keyword(s):  
Fracture Toughness ◽  
Flexural Strength ◽  
Temperature Dependence ◽  
Yield Stress ◽  
Test Temperature ◽  
Room Temperature ◽  
Single Edge ◽  
Melting Technique ◽  
Strength Tests ◽  
Edge Notch

ABSTRACTThe flexural strength and the single edge notch beam fracture toughness of undoped ZrO2 crystals, grown by the skull melting technique, were examined from room temperature to 1400°C. On heating the toughness increased with test temperature to a maximum of 4.0 MPajm at 1225°C then gradually decreased to 2.6 MPa/m. Upon cooling after a 20 minute hold at 1250°C an increase in toughness to 5 MPa/m was observed at 1200°C; upon cooling to lower temperatures Kic gradually diminished. The loaddeflection curves for the flexural strength tests showed marked nonlinearity before failure for samples tested on cooling. The temperature dependence of the apparent yield stress suggests that initial yielding occurs by slip above 1200°C but that from 1200°C to 1050°C the observed yielding is due to stress induced tetragonal to monoclinic transformation.

scholarly journals Applicability of Time-Temperature-Water Absorption Superposition Principle for Flexural Strength of CFRP Laminates

2003 ◽  
Vol 46 (3) ◽  
pp. 467-472 ◽  
Author(s):  
Hisanori FUJIEDA ◽  
Naoyuki SEKINE ◽  
Masayuki NAKADA ◽  
Yasushi MIYANO ◽  
Akira KURAISHI ◽  
...  
Keyword(s):  
Flexural Strength ◽  
Water Absorption ◽  
Superposition Principle ◽  
Cfrp Laminates ◽  
Temperature Water

scholarly journals A note on the temperature dependence of the flexural strength of a porcelain

2002 ◽  
Vol 18 (7) ◽  
pp. 558-560 ◽  
Author(s):  
J Lenz ◽  
M Thies ◽  
P Wollwage ◽  
K Schweizerhof
Keyword(s):  
Flexural Strength ◽  
Temperature Dependence
Sign in / Sign up

Export Citation Format

Share Document