scholarly journals Prediction of a three-dimensional turbulent boundary layer created by a rotating free-stream velocity vector.

1990 ◽  
Vol 56 (531) ◽  
pp. 3336-3342
Author(s):  
Nobuyuki SHIMA
1974 ◽  
Vol 66 (4) ◽  
pp. 641-655 ◽  
Author(s):  
J. H. Horlock ◽  
A. K. Lewkowicz ◽  
J. Wordsworth

Two attempts were made to develop a three-dimensional laminar boundary layer in the flow over a flat plate in a curved duct, establishing a negligible streamwise pressure gradient and, at the same time, an appreciable crosswise pressure gradient.A first series of measurements was undertaken keeping the free-stream velocity at about 30 ft/s; the boundary layer was expected to be laminar, but appears to have been transitional. As was to be expected, the cross-flow in the boundary layer decreased gradually as the flow became progressively more turbulent.In a second experiment, at a lower free-stream velocity of approximately 10 ft/s, the boundary layer was laminar. Its streamwise profile resembled closely the Blasius form, but the cross-flow near the edge of the boundary layer appears to have exceeded that predicted theoretically. However, there was a substantial experimental scatter in the measurements of the yaw angle, which in laminar boundary layers is difficult to obtain accurately.


1962 ◽  
Vol 84 (3) ◽  
pp. 235-242 ◽  
Author(s):  
R. A. Seban ◽  
L. H. Back

The effectiveness and the heat transfer have been measured in a system involving the tangential injection of air from a single spanwise slot into the turbulent boundary layer of an external air stream, with the velocity of the external stream increasing in a way that concentrated the acceleration in a region downstream of the initial mixing zone. The effectiveness was changed but little from the value that would have existed had the free-stream velocity remained at its initial value and both temperature profiles and analytical considerations show that this invariability of the effectiveness is associated with thermal boundary-layer thicknesses that are much larger than the hydrodynamic thicknesses. Heat-transfer coefficients are shown to be predictable from existing information provided that the momentum thickness Reynolds number is large enough.


1974 ◽  
Vol 40 (329) ◽  
pp. 191-198
Author(s):  
Shigeaki MASUDA ◽  
Naoto SASAKI ◽  
Ichiro ARIGA ◽  
Ichiro WATANABE

Author(s):  
Samuel Addai ◽  
Xingjun Fang ◽  
Afua A Mante ◽  
Mark F. Tachie

Abstract Particle image velocimetry is used to experimentally study the wake dynamics behind a near-wall square cylinder subjected to a thick oncoming turbulent boundary layer. The turbulent boundary layer thickness was 3.6 times the cylinder height (h) while the Reynolds number based on the free-stream velocity and the cylinder height was 12750. The gap distance (G) between the bottom face of the cylinder and the wall was varied, resulting in gap ratios (G/h) of 0, 0.3, 0.5, 1.0, 2.0, 4.0 and 8.0. The effects of varying the gap ratio on the mean flow, Reynolds stresses, triple velocity correlation, two-point autocorrelation and the unsteady wake characteristics were examined. The results indicate that as gap ratio decreases, asymmetry in the wake flow becomes more pronounced and the size of the mean separation bubbles increases. The magnitudes of the Reynolds stresses and triple velocity correlations generally decrease with decreasing gap ratio. Moreover, the size of the large-scale structures increases with decreasing gap ratio and the critical gap ratio, below which Kármán vortex shedding suppression occurs, is found to be 0.3. The dominant Strouhal number in the wake flow expressed in terms of the streamwise mean velocity at the cylinder vertical midpoint increases as gap ratio decreases while that based on the free-stream velocity is less sensitive to gap ratio for the offset cases (G/h > 0).


2008 ◽  
Vol 616 ◽  
pp. 195-203 ◽  
Author(s):  
M. B. JONES ◽  
T. B. NICKELS ◽  
IVAN MARUSIC

We investigate similarity solutions for the outer part of a zero-pressure-gradient turbulent boundary layer in the limit of infinite Reynolds number. Previous work by George (Phil. Trans. R. Soc. vol. 365, 2007 p. 789) has suggested that the only appropriate velocity scale for the outer region is U1, the free-stream velocity. This is based on the fact that scaling with U1 leads to a mathematically valid similarity solution of the momentum equation for the outer region in the asymptotic limit of infinite Reynolds number. Here we show that the classical scaling using the friction velocity also leads to a valid similarity solution for the outer flow in this limit. Therefore on this basis it is not possible to dismiss the friction velocity as a possible scaling as has been suggested by George (2007) and others. We show that both the free-stream velocity and the friction velocity are potentially valid scalings according to this theoretical criterion.


Sign in / Sign up

Export Citation Format

Share Document