Specifications for creep-resistant steels: Japan

2008 ◽  
pp. 155-173
Author(s):  
F. Masuyama
Keyword(s):  
Creep Resistant Steels

Investigations on the growth kinetics of Laves phase precipitates in 12% Cr creep-resistant steels: Experimental and DICTRA calculations

2010 ◽  
Vol 58 (18) ◽  
pp. 6142-6153 ◽  
Author(s):  
O. Prat ◽  
J. Garcia ◽  
D. Rojas ◽  
C. Carrasco ◽  
G. Inden
Keyword(s):  
Growth Kinetics ◽  
Laves Phase ◽  
Creep Resistant Steels ◽  
Kinetics Of

Influence of Stress on Degradation and Life Prediction of High Strength Ferritic Steels

2004 ◽  
Author(s):  
Kazuhiro Kimura ◽  
Kota Sawada ◽  
Kiyoshi Kubo ◽  
Hideaki Kushima
Keyword(s):  
Yield Stress ◽  
Elastic Limit ◽  
High Strength ◽  
Time To Rupture ◽  
Limit Stress ◽  
Creep Resistant Steels ◽  
Grade 91 ◽  
Term Creep ◽  
Grade 91 Steel

Influence of stress on creep deformation and degradation behavior has been investigated. Corresponding to inflection of stress vs. time to rupture curve, difference in recovery phenomena, that was homogeneous in short-term and inhomogeneous in long-term, was observed. Inflection of stress vs. time to rupture curve took place at the stress condition corresponding to half of 0.2% offset yield stress at the temperature. Elastic limit stress of Grade 91 steel was evaluated to be 150MPa at 600°C and 100MPa at 650°C, by means of stress abrupt change test. These stresses were found to be almost the same as half of 0.2% offset yield stress at the temperatures. Inflection of stress vs. time to rupture curve is caused by transient of applied stress from higher level than elastic limit to within elastic range. It has been concluded that long-term creep strength of ferritic creep resistant steels should be predicted from the selected creep rupture data under the stresses lower than elastic limit by considering half of 0.2% offset yield stress at the temperature, by means of Larson-Miller parameter with a constant of 20.

scholarly journals Microstructural characterisation and microanalysis of creep resistant steels

2014 ◽  
Vol 522 ◽  
pp. 012034
Author(s):  
M Wang ◽  
Y Chiu ◽  
I Jones ◽  
N Rowlands ◽  
J Holland ◽  
...  
Keyword(s):  
Microstructural Characterisation ◽  
Creep Resistant Steels
Sign in / Sign up

Export Citation Format

Share Document