scholarly journals Spatial selectivity of the four-wave radiation converter in a transparent two-component medium in a scheme with concurrent pump waves

2016 ◽  
Vol 40 (3) ◽  
pp. 322-330 ◽  
Author(s):  
V. V. Ivakhnik ◽  
M. V. Savelyev
2018 ◽  
Vol 42 (2) ◽  
pp. 227-235
Author(s):  
V. V. Ivakhnik ◽  
M. V. Savelyev

We analyze changes in the spatial structure of an object wave under four-wave mixing in a transparent two-component medium in schemes with opposing and concurrent pump waves. It is shown that in the spatial spectrum of the object wave there is a dip, whose position is determined by the propagation direction of the second pump wave. Angular rotation and frequency shift of the pump waves lead to a decrease in the conversion efficiency of high spatial frequencies. The bandwidth of the spatial frequencies cut out by the four-wave radiation converter decreases monotonically over time, whereas the bandwidth of the most efficiently converted spatial frequencies increases.


2020 ◽  
Vol 23 (3) ◽  
pp. 27-33
Author(s):  
Valery V. Ivakhnik ◽  
Darkhan R. Kapizov ◽  
Vladimir I. Nikonov

The spatial selectivity of a four-wave radiation converter in a multimode waveguide with thermal nonlinearity in a circuit with incident pump waves is analyzed. It is shown that the half-widths of the modulus of the point spread function, which characterizes the image conversion quality, are mainly determined by the transverse dimensions of the waveguide. With an increase in the angle of incidence of the pump waves on the front face of the waveguide, it decreases both the maximum value and the half-width of the modulus of the point spread function. The recording of two temperature gratings in the waveguide leads to a modulation of the point spread function with a period inversely proportional to the angle of incidence of the pump waves.


1965 ◽  
Vol 5 ◽  
pp. 109-111
Author(s):  
Frederick R. West

There are certain visual double stars which, when close to a node of their relative orbit, should have enough radial velocity difference (10-20 km/s) that the spectra of the two component stars will appear resolved on high-dispersion spectrograms (5 Å/mm or less) obtainable by use of modern coudé and solar spectrographs on bright stars. Both star images are then recorded simultaneously on the spectrograph slit, so that two stellar components will appear on each spectrogram.


Author(s):  
R.J. Mount ◽  
R.V. Harrison

The sensory end organ of the ear, the organ of Corti, rests on a thin basilar membrane which lies between the bone of the central modiolus and the bony wall of the cochlea. In vivo, the organ of Corti is protected by the bony wall which totally surrounds it. In order to examine the sensory epithelium by scanning electron microscopy it is necessary to dissect away the protective bone and expose the region of interest (Fig. 1). This leaves the fragile organ of Corti susceptible to physical damage during subsequent handling. In our laboratory cochlear specimens, after dissection, are routinely prepared by the O-T- O-T-O technique, critical point dried and then lightly sputter coated with gold. This processing involves considerable specimen handling including several hours on a rotator during which the organ of Corti is at risk of being physically damaged. The following procedure uses low cost, readily available materials to hold the specimen during processing ,preventing physical damage while allowing an unhindered exchange of fluids.Following fixation, the cochlea is dehydrated to 70% ethanol then dissected under ethanol to prevent air drying. The holder is prepared by punching a hole in the flexible snap cap of a Wheaton vial with a paper hole punch. A small amount of two component epoxy putty is well mixed then pushed through the hole in the cap. The putty on the inner cap is formed into a “cup” to hold the specimen (Fig. 2), the putty on the outside is smoothed into a “button” to give good attachment even when the cap is flexed during handling (Fig. 3). The cap is submerged in the 70% ethanol, the bone at the base of the cochlea is seated into the cup and the sides of the cup squeezed with forceps to grip it (Fig.4). Several types of epoxy putty have been tried, most are either soluble in ethanol to some degree or do not set in ethanol. The only putty we find successful is “DUROtm MASTERMENDtm Epoxy Extra Strength Ribbon” (Loctite Corp., Cleveland, Ohio), this is a blue and yellow ribbon which is kneaded to form a green putty, it is available at many hardware stores.


1997 ◽  
Vol 90 (4) ◽  
pp. 679-681
Author(s):  
F. SAIJA ◽  
G. FIUMARA ◽  
P.V. GIAQUINTA

Sign in / Sign up

Export Citation Format

Share Document