DISTRIBUIÇÃO ESPACIAL DOS INTERVALOS OIL SHALE PERMIANOS DA BACIA DO PARANÁ

2022 ◽  
pp. 123-132
Author(s):  
Ailton da Silva Brito ◽  
Lorena Tuane Gomes de Almeida ◽  
Sidney Gonçalo de Lima
Keyword(s):  
1994 ◽  
Author(s):  
John Stehn ◽  
Scott Carter ◽  
Asmund Vego
Keyword(s):  

2018 ◽  
Author(s):  
Devon Jakob ◽  
Le Wang ◽  
Haomin Wang ◽  
Xiaoji Xu

<p>In situ measurements of the chemical compositions and mechanical properties of kerogen help understand the formation, transformation, and utilization of organic matter in the oil shale at the nanoscale. However, the optical diffraction limit prevents attainment of nanoscale resolution using conventional spectroscopy and microscopy. Here, we utilize peak force infrared (PFIR) microscopy for multimodal characterization of kerogen in oil shale. The PFIR provides correlative infrared imaging, mechanical mapping, and broadband infrared spectroscopy capability with 6 nm spatial resolution. We observed nanoscale heterogeneity in the chemical composition, aromaticity, and maturity of the kerogens from oil shales from Eagle Ford shale play in Texas. The kerogen aromaticity positively correlates with the local mechanical moduli of the surrounding inorganic matrix, manifesting the Le Chatelier’s principle. In situ spectro-mechanical characterization of oil shale will yield valuable insight for geochemical and geomechanical modeling on the origin and transformation of kerogen in the oil shale.</p>


Stratigraphy ◽  
2017 ◽  
Vol 14 (1-4) ◽  
pp. 97-122 ◽  
Author(s):  
Julie A. Dumoulin ◽  
Craig A. Johnson ◽  
Karen D. Kelley ◽  
Palma Jarboe ◽  
Paul Hackley ◽  
...  
Keyword(s):  

2019 ◽  
Author(s):  
Chem Int

The study aims to use an adsorbent natural based of Moroccan oil shale of Timahdit area (Y layer) in a physical-chemical adsorption process for treating industrial discharges colorful. The used adsorbent is the insoluble party of the sub-critical extraction of decarbonized oil shale of Timahdit. The tests performed on the methylene blue (MB), showed a strong elimination in the first 10 minutes. The influences of various experimental parameters were studied: mass ratio of adsorbent, time and temperature of thermal treatment, contact time, pH of MB and heating temperature of solution on the parameters of material were studied. The experimental results have shown that the adsorption of methylene blue dye by the adsorbent is more than 90% at initial pH a range 6-7 at room temperature for 30 minutes. The process is simple and the adsorbent produced is a new material with interesting adsorption capacities of moderate cost which does not require an activating agent and can be used as industrial adsorbent for the decontamination of effluents containing organic pollutants.


2019 ◽  
Author(s):  
Chem Int

The new adsorbents were prepared from Moroccan oil shale by chemical and physical process .In this study, experimental Plackett-Burman has been used as a screening method to study six factors for the development of materials to adsorbent basis of oil shale Moroccan. The factors have been identified by two levels, To Know temperature (°C), Processing time (min), mass ratio (m precursor/m acid), Pretreatment mixture the precursor with acid, origin of the raw material and type of the activating agent (H2SO4, H3PO4).And it was chosen as a response The maximum quantity of adsorption of the molecule of Methylene blue (Qads in mg/g) and the specific surface measure by the method bet (Sbet in m2/g), The predicted values were in agreement with the experimental values with a coefficient of determination (R2) of 0.98. The model has been validated by experiments subsequent to optimized conditions. The experimental data processing by software JMP 7 showed that the processing temperature The report of oil shale on the acid and activation time were the important effect on the maximal capacity of adsorption of methylene blue. The sample prepared at 237 °C during 215 min with pre-processing has a maximal capacity of adsorption equal to 54mg/g according to model of adsorption of Langmuir and SBET equal to 143 m2/g.


1974 ◽  
Author(s):  
John B. Weeks ◽  
George H. Leavesley ◽  
Frank A. Welder ◽  
George J. Saulnier
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document