THEORETICAL STUDY OF A DIRECT STEAM GENERATION POWER PLANT WITH PARABOLIC TROUGH COLLECTORS

2018 ◽  
Author(s):  
João Marcos Gomes Vieira ◽  
Matheus Porto
Keyword(s):  
Power Plant ◽  
Theoretical Study ◽  
Steam Generation ◽  
Parabolic Trough ◽  
Direct Steam ◽  
Generation Power

scholarly journals Experience of operating a solar parabolic trough direct steam generation power plant with superheating

Solar Energy ◽  
2018 ◽  
Vol 171 ◽  
pp. 310-319 ◽  
Author(s):  
Lisa Willwerth ◽  
Jan Fabian Feldhoff ◽  
Dirk Krüger ◽  
Lothar Keller ◽  
Martin Eickhoff ◽  
...  
Keyword(s):  
Power Plant ◽  
Steam Generation ◽  
Parabolic Trough ◽  
Direct Steam ◽  
Generation Power

Approaching a LFR Direct Steam Generation Power Plant Towards an Endoreversible Heat Engine

2021 ◽  
pp. 21-44
Author(s):  
Eduardo González-Mora ◽  
Ma. Dolores Durán-García
Keyword(s):  
Power Plant ◽  
Heat Engine ◽  
Steam Generation ◽  
Direct Steam ◽  
Generation Power

Comparative System Analysis of Direct Steam Generation and Synthetic Oil Parabolic Trough Power Plants With Integrated Thermal Storage

2011 ◽  
Author(s):  
Jan Fabian Feldhoff ◽  
Kai Schmitz ◽  
Markus Eck ◽  
Lars Schnatbaum-Laumann ◽  
Doerte Laing ◽  
...  
Keyword(s):  
Power Plant ◽  
Power Plants ◽  
System Analysis ◽  
Storage System ◽  
Steam Generation ◽  
Parabolic Trough ◽  
Synthetic Oil ◽  
Direct Steam ◽  
Oil Plant ◽  
Steam Parameters

Parabolic trough power plants are currently the most commercially applied systems for CSP power generation. To improve their cost-effectiveness, one focus of industry and research is the development of processes with other heat transfer fluids than the currently used synthetic oil. One option is the utilization of water/steam in the solar field, the so-called direct steam generation (DSG). Several previous studies promoted the economic potential of DSG technology [1–3]. Analyses’ results showed that live steam parameters of up to 500°C and 120 bars are most promising and could lead to a reduction of the levelized electricity cost (LEC) of about 11% [4]. However, all of these studies only considered plants without thermal energy storage (TES). Therefore, a system analysis including integrated TES was performed by Flagsol GmbH and DLR together with Solar Millennium AG, Schott CSP GmbH and Senior Bergho¨fer GmbH, all Germany. Two types of plants are analyzed and compared in detail: a power plant with synthetic oil and a DSG power plant. The design of the synthetic oil plant is very similar to the Spanish Andasol plants [5] and includes a molten salt two-tank storage system. The DSG plant has main steam parameters of 500 °C and 112 bars and uses phase change material (PCM) for the latent and molten salt for the sensible part of the TES system. To enable comparability, both plants share the same gross electric turbine capacity of 100 MWel, the same TES capacity of nine hours of full load equivalent and the same solar multiple of the collector field of about two. This paper describes and compares both plants’ design, performance and investment. Based on these results, the LEC are calculated and the DSG plant’s potential is evaluated. One key finding is that with currently proposed DSG storage costs, the LEC of a DSG plant could be higher than those of a synthetic oil plant. When considering a plant without TES on the other hand, the DSG system could reduce the LEC. This underlines the large influence of TES and the still needed effort in the development of a commercial storage system for DSG.

Numerical investigation of severe slugging under conditions of a parabolic trough power plant with direct steam generation

Solar Energy ◽  
2016 ◽  
Vol 133 ◽  
pp. 567-585 ◽  
Author(s):  
A. Hoffmann ◽  
T. Hirsch ◽  
R. Pitz-Paal
Keyword(s):  
Power Plant ◽  
Numerical Investigation ◽  
Steam Generation ◽  
Parabolic Trough ◽  
Direct Steam

Detailed Modeling of Parabolic Trough Collectors for the Part Load Simulation of Solar Thermal Power Plants

2012 ◽  
Author(s):  
F. Zaversky ◽  
S. Bergmann ◽  
W. Sanz
Keyword(s):  
Heat Transfer ◽  
Power Plant ◽  
Power Plants ◽  
Thermal Power ◽  
Solar Thermal ◽  
Thermal Power Plants ◽  
Steam Generation ◽  
Parabolic Trough ◽  
Solar Thermal Power ◽  
Direct Steam

Solar thermal power plants are a promising way of providing clean renewable electric energy. These plants concentrate the incoming solar direct irradiation in order to heat up a heat transfer fluid. The collected thermal energy can be stored or instantly delivered to a power block where part of the thermal energy is converted to electrical energy in a turbine with the connected generator. The parabolic trough collector plant is the today’s most developed solar thermal power plant type. There the solar irradiation is focused on receiver tubes which are concentrically placed to the focal lines of the parabolic trough collectors. A high temperature oil is pumped through these receiver tubes, which collects the heat and delivers it later on to the steam generator of the connected Rankine steam cycle. In order to improve the efficiency of these solar thermal power plants, the direct steam generation (DSG) within the parabolic trough collector receiver tubes is being investigated. Both types of parabolic trough collectors, the conventional type using oil as heat transfer fluid and the direct steam generation type, are subject of this paper. A detailed steady-state parabolic trough collector model was developed for each type, using the thermodynamic simulation software IPSEpro. The developed models consider the cosine-loss attenuation factor, the shading attenuation factor, optical losses, as well as thermal losses. Appropriate heat transfer and pressure loss correlations were implemented for both collector types. For the direct steam generation model, distinct collectors for the preheating section, the evaporation section and the superheating section were used. Furthermore, the suitable length of discretization for the modeling of one collector loop within a center-fed solar field was investigated. Calculated solar field performance data for the oil concept were compared to validated data available in open literature. Finally, a power plant simulation with each collector type, over the course of one reference day, showed the great potential of the direct steam generation, as well as the suitability of IPSEpro for running solar thermal power plant yield simulations.

scholarly journals Multi-scale modelling of a large scale shell-and-tube latent heat storage system for direct steam generation power plants

2020 ◽  
Author(s):  
Clément Beust ◽  
Erwin Franquet ◽  
Jean-Pierre Bédécarrats ◽  
Pierre Garcia ◽  
Jérôme Pouvreau ◽  
...  
Keyword(s):  
Power Plants ◽  
Large Scale ◽  
Storage System ◽  
Steam Generation ◽  
Latent Heat Storage ◽  
Multi Scale ◽  
Direct Steam ◽  
Scale Modelling ◽  
Shell And Tube ◽  
Generation Power
Sign in / Sign up

Export Citation Format

Share Document