scholarly journals MEASUREMENT OF THE AMBIENT DOSE EQUIVALENT RATE OF NEUTRONS AT NUCLEAR POWER PLANTS

2021 ◽  
pp. 14-20
Author(s):  
A. Alexeev ◽  
P. Alexeev
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Dose Equivalent ◽  
Equivalent Rate ◽  
Ambient Dose Equivalent ◽  
Ambient Dose

Calculations of the neutron response for the most widely used neutron dosimeters at the Russian nuclear power plant (NPP) have been performed. It is shown that in some cases it is necessary to introduce a correction for the measured value of the ambient dose equivalent rate (AEDR). The experimentally tested values of the correction for measuring AEDR in the containment rooms of NPP with VVER-1200 are given.

Correction Coefficients for Measuring the Ambient Dose Equivalent Rate of Neutrons

ANRI ◽  
2021 ◽  
Vol 0 (4) ◽  
pp. 32-40
Author(s):  
Alexander Alexeev ◽  
Vladimir Pikalov ◽  
Pavel Alexeev
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Dose Equivalent ◽  
Equivalent Rate ◽  
Ambient Dose Equivalent ◽  
Ambient Dose

Calculations of the response for the most widely used neutron dosimeters at the Russian nuclear power plant (NPP) have been performed. It is shown that in some cases it is necessary to introduce a correction for the measured value of the ambient dose equivalent rate (AEDR). The experimentally tested values of the correction for measuring AEDR in the containment rooms of NPP with VVER-1200 are given.

scholarly journals Radiation effects on wild medaka around Fukushima Dai-ichi Nuclear Power Plant assessed by micronucleus assay

2020 ◽  
Vol 62 (1) ◽  
pp. 79-85
Author(s):  
Kouichi Maruyama ◽  
Bing Wang ◽  
Kazutaka Doi ◽  
Koji Ishibashi ◽  
San’ei Ichikawa ◽  
...  
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Radiation Effects ◽  
Micronucleus Assay ◽  
Dose Equivalent ◽  
Equivalent Rate ◽  
Significant Difference ◽  
Ambient Dose Equivalent ◽  
Ambient Dose

Abstract Since the Fukushima Dai-ichi Nuclear Power Plant (F1-NPP) accident in 2011, radiation effects on wildlife in the contaminated areas have been a major concern. The outskirts of the F1-NPP are mainly rural areas, where many rice fields, streams and reservoirs are located. We searched for wild medaka (small aquarium fish) around the F1-NPP and found two wild medaka habitats (S1 and S2). S1 is a stream located 4 km from the F1-NPP, where the ambient dose equivalent rate was 0.4–0.9 μSv/h (2013–14), and S2 is a reservoir located 7.5 km from the F1-NPP, where the ambient dose equivalent rate was 9.8–22 μSv/h (2013–14 and 2017–18). Dosimeters were placed for one day at the locations where the medaka were captured, and the absorbed dose rates were estimated. Radiation effects on wild medaka were examined using micronucleus assay between 2013 and 2018. No significant difference in frequency of micronucleated gill cells was observed among the wild medaka from S1, S2 and our cultivated medaka that were used as a control.

Research on Earthquake Acceleration Alarm of Nuclear Power Plant

2021 ◽  
Author(s):  
Li Liang ◽  
Pan Rong ◽  
Ren Guopeng ◽  
Zhu Xiuyun
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
False Alarm ◽  
Ground Motion ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Time History ◽  
Seismic Acceleration ◽  
Trigger Signal

Abstract Almost all nuclear power plants in the world are equipped with seismic instrument system, especially the third generation nuclear power plants in China. When the ground motion measured by four time history accelerometers of containment foundation exceeds the preset threshold, the automatic shutdown trigger signal will be generated. However, from the seismic acceleration characteristics, isolated and prominent single high frequency will be generated the acceleration peak, which has no decisive effect on the seismic response, may cause false alarm, which has a certain impact on the smooth operation of nuclear power plant. According to the principle of three elements of ground motion, this paper puts forward a method that first selects the filtering frequency band which accords with the structural characteristics of nuclear power plants, then synthesizes the three axial acceleration time history, and finally selects the appropriate acceleration peak value for threshold alarm. The results show that the seismic acceleration results obtained by this method can well represent the actual magnitude of acceleration, and can solve the problem of false alarm due to the randomness of single seismic wave, and can be used for automatic reactor shutdown trigger signal of seismic acceleration.

scholarly journals Comparison and Evaluation of Domestic and Foreign Radiation Environmental Standards for Nuclear Power Plants

2021 ◽  
Vol 2083 (2) ◽  
pp. 022020
Author(s):  
Jiahuan Yu ◽  
Xiaofeng Zhang
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
The United States ◽  
Discharge System ◽  
Radioactive Effluent ◽  
Effluent Discharge ◽  
The Impact

Abstract With the development of the nuclear energy industry and the increasing demand for environmental protection, the impact of nuclear power plant radiation on the environment has gradually entered the public view. This article combs the nuclear power plant radiation environmental management systems of several countries, takes the domestic and foreign management of radioactive effluent discharge from nuclear power plants as a starting point, analyses and compares the laws and standards related to radioactive effluents from nuclear power plants in France, the United States, China, and South Korea. In this paper, the management improvement of radioactive effluent discharge system of Chinese nuclear power plants has been discussed.

scholarly journals Seismic safety evaluation during site selection for the nuclear power plants in Bangladesh

2018 ◽  
Vol 4 (4) ◽  
pp. 251-256 ◽  
Author(s):  
Sergey Shcheklein ◽  
Ismail Hossain ◽  
Mohammad Akbar ◽  
Vladimir Velkin
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Spent Nuclear Fuel ◽  
Heat Removal ◽  
Good Time ◽  
Diagnostics System ◽  
Seismic Impacts

Bangladesh lies in a tectonically active zone. Earlier geological studies show that Bangladesh and its adjoining areas are exposed to a threat of severe earthquakes. Earthquakes may have disastrous consequences for a densely populated country. This dictates the need for a detailed analysis of the situation prior to the construction of nuclear power plant as required by the IAEA standards. This study reveals the correlation between seismic acceleration and potential damage. Procedures are presented for investigating the seismic hazard within the future NPP construction area. It has been shown that the obtained values of the earthquake’s peak ground acceleration are at the level below the design basis earthquake (DBE) level and will not lead to nuclear power plant malfunctions. For the most severe among the recorded and closely located earthquake centers (Madhupur) the intensity of seismic impacts on the nuclear power plant site does not exceed eight points on the MSK-64 scale. The existing predictions as to the possibility of a super-earthquake with magnitude in excess of nine points on the Richter scale to take place on the territory of the country indicate the necessity to develop an additional efficient seismic diagnostics system and to switch nuclear power plants in good time to passive heat removal mode as stipulated by the WWER 3+ design. A conclusion is made that accounting for the predicted seismic impacts in excess of the historically recorded levels should be achieved by the establishment of an additional efficient seismic diagnostics system and by timely switching the nuclear power plants to passive heat removal mode with reliable isolation of the reactor core and spent nuclear fuel pools.

Comparison of Plant Response of Forsmark 3 Nuclear Power Plant to Forsmark 1 Type of Transient (25th July 2006), Using the HAMBO BWR Simulator: Thermal-Hydraulic Aspects

2008 ◽  
Author(s):  
Esko Pekkarinen
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Short Circuit ◽  
Complex Interplay ◽  
Operator Interface ◽  
Control Rooms ◽  
Hydraulic Process

Modernisation of control rooms of the nuclear power plants has been a major issue during the last few years. With this as a basis, the BWR plants in Sweden and Finland funded, in co-operation with the Halden Project, an experimental HAMBO BWR simulator project based on the Forsmark 3 plant in Sweden. VTT Energy in Finland developed the simulator models for HAMBO with the aid of their APROS tool, while the operator interface was developed by the Halden Project. The simulator and its performance have been described in other publications [1, 2]. On July 25th 2006 there was a short circuit at Forsmark 1 nuclear power plant when manoeuvring equipment in the 400kV-switch yard. Due to the short circuit, the plant suffered an electrical disturbance that led to scram and failure of two out of four diesel generators. The purpose of the study carried out at VTT in 2007 was to assess the capabilities of the HAMBO BWR simulator to handle Forsmark 1 type of events in different nuclear power plants (Forsmark 3 in this case). The Forsmark 1 incident showed (among other things) that the intention to protect certain components (in this case the UPS-system) can in certain situations affect negatively to the safety functions. It is concluded that most of this type of BWR transients may be simulated to a certain extent using the existing HAMBO- and APROS- models. A detailed modelling of the automation and electric systems is required sometimes if the complex interplay between these systems and the process is to be predicted reliably. The modelling should be plant specific and level of detail should be assessed case-by-case (i.e. what kind of transient is in question, what systems are available, what is the main purpose of the analyses etc.). The thermal-hydraulic models of the APROS-code seem to replicate well the real behaviour of thermal-hydraulic process provided that there is enough information about the transient in consideration.

Sign in / Sign up

Export Citation Format

Share Document