scholarly journals Operating characteristics of core type magnetic frequency multiplier with compensatory reactor.

1987 ◽  
Vol 11 (2) ◽  
pp. 361-364 ◽  
Author(s):  
H. Suzuki ◽  
M. Tadokoro
Diagnostica ◽  
2019 ◽  
Vol 65 (3) ◽  
pp. 179-190 ◽  
Author(s):  
Vincent Mustapha ◽  
Renate Rau

Zusammenfassung. Cut-Off-Werte ermöglichen eine ökonomische, binäre Beurteilung von Summenscores. Für Beanspruchungsfragebögen, die personenbezogene Merkmale erfragen, sind Cut-Off-Werte häufig vorhanden und in der klinischen Diagnostik unerlässlich. Für die Bewertung von Arbeitsmerkmalen sind Cut-Off-Werte ebenfalls wünschenswert. Bislang fehlen sie jedoch für die Beurteilung von Arbeitsmerkmalen wie Arbeitsintensität und Tätigkeitsspielraum. Zwischen 2006 und 2016 wurden daher in verschiedenen Branchen 801 objektive Arbeitsplatzanalysen durchgeführt, welche eine Unterteilung in gut und schlecht gestalteten Tätigkeitsspielraum sowie gut und schlecht gestaltete Arbeitsintensität nach DIN EN ISO 6385 (2016) ermöglichen. Anhand dieser Unterteilung wurden mit der Receiver-Operating-Characteristics-Analyse Cut-Off-Werte für den subjektiv-bedingungsbezogen Fragebogen zum Erleben von Arbeitsintensität und Tätigkeitsspielraum (FIT; Richter et al., 2000 ) ermittelt. Für den Tätigkeitsspielraum weisen Summenscores ≤ 22 und für die Arbeitsintensität Summenscores ≥ 15 auf eine schlechte Gestaltung des jeweiligen Arbeitsmerkmals hin. Anhand einer weiteren Stichprobe von 1 076 Arbeitenden konnte gezeigt werden, dass Arbeitende mit schlecht gestaltetem Tätigkeitspielraum vital erschöpfter sowie weniger engagiert sind und Arbeitende mit schlecht gestalteter Arbeitsintensität eine höhere Erholungsunfähigkeit sowie vitale Erschöpfung aufweisen.


1993 ◽  
Vol 140 (6) ◽  
pp. 503 ◽  
Author(s):  
J. Arrillaga ◽  
J.R. Camacho ◽  
S.J. MacDonald ◽  
C.P. Arnold

2000 ◽  
Vol 10 (PR11) ◽  
pp. Pr11-11-Pr11-21 ◽  
Author(s):  
C. Bundy ◽  
C. Knowlen ◽  
A. P. Bruckner

1999 ◽  
Vol 38 (06) ◽  
pp. 172-177
Author(s):  
H. Bailer ◽  
Marianne Gwechenberger ◽  
Martha Pruckmayer ◽  
A. Staudenherz ◽  
G. Kronik ◽  
...  

Summary Aim: The simultaneous computation and display of wall motion and perfusion patterns in a single 3D ventricular model would considerably ease the assessment of ECG-gated Tc-99m-sestamibi SPECT, yet the effect on the accuracy of allocating regional perfusion has so far not been validated. Methods: 3D perfusion mapping (3D Perfusion/Motion Map Software) was compared to the visual assessment of ungated tomographic slices and polar perfusion mapping (Cedars-Sinai PTQ) by correlation analysis and receiver operating characteristics (ROC) analysis at different cut-off levels for coronary stenoses in 50 patients (11 single-, 22 two-, 16 three-vessel disease). Ungated SPECT data were obtained by adding the intervals prior to reconstruction and displaying conventional tomographic slices. All display options were visually assessed in 8 ventricular segments according to a 4-point scoring system and compared to the graded results of coronary angiography. Results: All three display options showed a comparable diagnostic performance for the detection of severe stenoses. The diagnostic gain for the detection of stenoses above 59% was highest for ungated tomographic slices, followed by ungated polar mapping and 3D mapping. Regional assessment revealed a limited performance of 3D mapping in the proximal anterior and distal lateral wall. Polar mapping showed a balanced regional performance. Conclusion: 3D Perfusion mapping provides comparable information to conventional display options with the highest diagnostic strength in severe stenoses. Further improvement of the algorithm is needed in the definition of the valve plane.


1991 ◽  
Vol 30 (03) ◽  
pp. 187-193 ◽  
Author(s):  
H. J. Moens ◽  
J. K. van der Korst

AbstractA Bayesian decision support system was developed for the diagnosis of rheumatic disorders. Knowledge in this system is represented as evidential weights of findings. Simple weights were calculated as the logarithm of likelihood ratios on the basis of 1,000 consecutive patients from a rheumatological clinic. The effect of various methods to improve performance of the system by modification of the weights was studied. Three methods had a mathematical basis; a fourth consisted of weights adapted by a human expert, which allowed inclusion of diagnostic rules such as defined in widely accepted criteria sets. The system’s performance was measured in a test population of 570 different cases from the same clinic and compared with predictions of diagnostic outcome made by rheumatologists. The weights from a human expert gave optimal results (sensitivity 65% and specificity 96%), that were close to the physicians’ predictions (sensitivity 64% and specificity 98%). The methods to measure the performance of the various models used in this study emphasize sensitivity, specificity and the use of receiver operating characteristics.


Sign in / Sign up

Export Citation Format

Share Document