Calculation Of Heat Flow And Pn Velocity Values Of West Anotalia Using Curie Point Depth Values

Author(s):  
M. Mihci ◽  
A. Buyuksarac ◽  
O. Bektas ◽  
A. Ates
2020 ◽  
Vol 2 (8) ◽  
Author(s):  
Kasi Njeudjang ◽  
Janvier Domra Kana ◽  
Ahmat Tom ◽  
Jean Marcel Abate Essi ◽  
Noël Djongyang ◽  
...  

Author(s):  
B. C. Udochukwu ◽  
M. Akiishi ◽  
A. A. Tyovenda

The aeromagnetic data of Monguno area northeastern Nigeria have been used to estimate Curie point depth, geothermal gradients and heat flow using spectral analysis. These geothermal parameters were subsequently employed to identify areas of geothermal resources. First order polynomial fitting was applied in Regional-residual separation. The Curie point depth obtained in this area ranges from 10.318 to 24.476 km with an average of 13.387 km, the geothermal gradient of the area varies from 23.697 to 56.212°C /km, with an average of 46.195°C /km, while the heat flow ranges from 59.242 to 136.176 mWm-2, with an average value of about 112.364 mWm-2. It was also observed that the deepest Curie depth in the area is identified in the south, while the shallow depth is located in the northeast and spread toward the southwest. On the other hand, the highest geothermal gradient in the area is identified in the northern part of Moguno, while in the south,                    the lowest, geothermal gradient is located. The highest heat flow in the area is seen in the south-west and north-east, while the lowest heat flow is observed in the south. The high heat flow and geothermal gradient in the area show that geothermal energy could be found in Monguno region of the northeastern Nigeria.


Geophysics ◽  
1985 ◽  
Vol 50 (3) ◽  
pp. 481-494 ◽  
Author(s):  
Y. Okubo ◽  
R. J. Graf ◽  
R. O. Hansen ◽  
K. Ogawa ◽  
H. Tsu

As part of a comprehensive, nationwide evaluation of geothermal resources for Japan, the first of the Curie point depth maps, covering the island of Kyushu, has been prepared. The map was created by inverting gridded, regional aeromagnetic data. Two satisfactory algorithms were developed to invert the gridded data based upon a distribution of point dipoles. The first algorithm estimates [Formula: see text],[Formula: see text], and [Formula: see text], the coordinates of the centroid of the distribution, by computing a least‐squares fit to the radial frequency of the Fourier transform; the second algorithm estimates centroid depth only by computing a least‐squares fit to the squared amplitude of the frequency estimates. The average depth to the top, [Formula: see text] of the collection of point dipoles, was estimated by a variation of the second algorithm. The depth to the bottom of the dipoles, inferred Curie point depth, is [Formula: see text]. The depth estimates are hand contoured to produce the final map. The Curie point depth map is then compared to regional geology and heat flow data, and to a limited set of gravity data. Good correlations are found between the Curie point depths and the heat flow and regional geology. A spatial correlation observed between gravity and Curie point depths is considered a secondary, structural effect. Locations of the currently operating geothermal power plants correspond to the shallowest Curie point depths. Based on these comparisons, we conclude that the methods provide geologically reasonable results which are usable in a nationwide geothermal assessment program.


2019 ◽  
Vol 8 (1) ◽  
pp. 1-11 ◽  
Author(s):  
Taiwo Adewumi ◽  
Kazeem Adeyinka Salako ◽  
Sunday Obadare Adediran ◽  
Oke Israel Okwokwo ◽  
Yusuf A Sanusi

This study attempt to estimate the Curie point depth (CPD) and heat flow using high resolution aeromagnetic data over part of Bida basin bounded with longitude 5o00’E – 6o30’E and Latitude 8o30’N – 9o30’N   with an estimated total area of 18,150 km2. We subjected the total magnetic intensity field of the study area to regional/residual separation using polynomial fitting. We divided the residual map into sixteen overlapping spectral blocks. We obtained centroid depths (Zo) and depth to top of basement (Zt)got from the plot of log of power spectrum against wave number; the centroid depth ranges from 6.61 km to 20.30 km while the depth to top of basement ranges from 1.59 km to 6.38 km. input parameter to calculate the curie depth (Zo). The CPD range from 10.88 km to 35.51 km with an average value of 23.22km. The CPD is deeper at the centre of the southern and eastern part of the study area which correspond to part of Pategi and part of Baro; and shallow at the northeastern and Northwestern part of the study area correspond to part of Mokwa and part of Bida. The geothermal gradients for the sixteen blocks range from 16.33 oCkm-1 at the centre of the southern region of the area to 53.30 oCkm-1 at the northeastern and north western region of the study area with an average of 28.98 oCkm-1. While the heat flow to range from 40.99 mWm-1 to 133.80 mWm-1 with an average value of 76.19 mWm-2. It can therefore be deduced from this study that the Southeastern, southwestern, and the northwestern part of the study area might be a good indicator of geothermal energy potential with minimum CPD, maximum geothermal gradient and heat flow since demagnetized rocks confirm a hot rock quantity in the crust that can be harnessed for geothermal energy exploitation.


Sign in / Sign up

Export Citation Format

Share Document