Wind Farm Voltage Control Scheme to Improve Dynamic Voltage Stability

2013 ◽  
Vol 732-733 ◽  
pp. 745-751 ◽  
Author(s):  
Peng Guo ◽  
Wen Ying Liu ◽  
Wei Wang ◽  
Ning Bo Wang ◽  
Huai Sen Jia

Dynamic voltage instability is one of the new problems with the fast development of wind farm clusters. This text is about the improvement of voltage stability of weak grid connected with wind turbine generators (WTGs). It focuses on the control strategy and mode of WTGs and dynamic reactive compensators during disturbance. Firstly, in order to propel WTGs outputting reactive power, the active control mode regarding both doubly fed induction generators (DFIGs) and permanent magnetic synchronous generators (PMSGs) is given. Secondly, the method of installing SVC at the terminal of part of WTGs is proposed. The selection of WTGs to install SVC is based on the sensitivity analysis. Thirdly, a coordinating method of various reactive sources is discussed. Finally, the comprehensive control logic under time series is listed. The simulation validates the methods above.

Author(s):  
Denis Juma ◽  
Bessie Monchusi ◽  
Josiah Munda ◽  
Adisa Jimoh

This paper investigates the impacts of a wind farm connected at Harterbeespoort substation in South Africa on voltage stability of the power network. The site wind speed was determined and analyzed for viability. A comparison is made between the use of Doubly-Fed Induction Generators and Self-excited Induction Generators driven by the wind turbines. The resulting P-V and Q-V curves from load flow studies are presented and analyzed. The models for this study were implemented in DigSILENT PowerFactory.


2014 ◽  
Vol 1070-1072 ◽  
pp. 224-227
Author(s):  
Li Lin ◽  
Kai Li

Current control strategy of reactive power and voltage for wind power integration is separate control of single wind farm (WF), which cannot achieve the optimal allocation of reactive power and is not beneficial for the optimization of voltage stability and network loss. In this paper, a coordinated control strategy of reactive power and voltage for wind farm cluster is proposed, which takes the voltage stability at point of common coupling (PCC) and economic operation as the optimization goals. The coordinated control strategy is realized through the platform of Cybercontrol industrial configuration, and the application testing verifies the effectiveness of the proposed strategy.


2019 ◽  
Vol 9 (4) ◽  
pp. 4384-4388 ◽  
Author(s):  
D. N. Truong ◽  
V. T. Bui

The objective of this paper is to perform a hybrid design for an Adaptive Neuro-Fuzzy Inference System (ANFIS) optimized by Particle Swarm Optimization (PSO) to improve the dynamic voltage stability of a grid-connected wind power system. An onshore 99.2MW wind farm using Doubly Fed Induction Generator (DFIG) is studied. To compensate the reactive power absorbed from the power grid of the wind farm, a Static VAR Compensator (SVC) is proposed. To demonstrate the performance of the proposed hybrid PSO–ANFIS controller, simulations of the voltage response in time-domain are performed in Matlab to evaluate the effectiveness of the designed controller. From the results, it can be concluded that the proposed hybrid PSO-optimized ANFIS-based model can be applied to enhance the dynamic voltage stability of the studied grid-connected wind power system.


2013 ◽  
Vol 724-725 ◽  
pp. 619-622 ◽  
Author(s):  
Chia Yu Hsu ◽  
Ta Hsiu Tseng ◽  
Pei Hwa Huang

The main purpose of this paper is to study the enhancement of the Low-Voltage-Ride-Through (LVRT) capability of the wind farm with the installment of the Static Synchronous Compensator (STATCOM) and the Static Var Compensator (SVC). With more penetration of wind energy from on-shore and off-shore wind farms, utilities have been starting to set up the regulation requiring the wind turbine generators to remain connected to the grid when a fault takes place in the system which is referred to as Low-Voltage-Ride-Through (LVRT). A wind farm composed with doubly fed induction generators is used as the study system. Both the STATCOM and the SVC are utilized as the devices for enhancing the LVRT capability of the wind farm. The results are demonstrated for comparing the performance of the two devices in the improvement of voltage dynamic characteristics of the study system.


2011 ◽  
Vol 354-355 ◽  
pp. 989-992
Author(s):  
An Lin

Squirrel-cage induction generator (SCIG) has been widely utilized in large wind farms in China. However, the large wind farm composed of induction generators will cause obvious power system stability problems due to the dependency on reactive power. Doubly-fed induction generator (DFIG) has excellent dynamic characteristics of wind farm operations. With the increasing of wind power penetration in power systems, more and more wind farms use both SCIG and DFIG. This paper firstly analyzes the the dynamic characteristic of wind farm on power systems, especially in terms of the voltage stability. Then the interaction between the SCIGs and DFIGs is also investigated. A detailed simulation model of wind farms is presented by means of MATLAB. The simulation results demonstrate that the DFIG applications will improve the voltage stability of the wind farm largely and the low voltage ride through characteristics of SCIG to some extend.


2021 ◽  
Author(s):  
Miad Mohaghegh Montazeri

Using power electronic converters with reduced capacity in doubly-fed induction generator (DFIG) based wind turbines make them vulnerable to over-current during grid disturbances. This thesis aims to analyze the behaviour of doubly-fed induction generators based wind farm for various timing schemes of crowbar deactivation and resumption of rotor side converter (RSC) in the case of grid fault. Also, usage of a static synchronous compensator (STATCOM) for the purpose of stabilizing the grid voltage after a three-phase fault is studied in this these. Moreover, finding minimum capacity of STATCOM which ensures low-voltage ride through (LVRT) of wind farm is studied. Finally, coordination of reactive power from wind turbine generators and STATCOM in steady-state condition is performed. All the results in this thesis show that STATCOM improves low voltage ride through (LVRT) capability of wind farm and assists for an uninterrupted operation of wind turbine generators during grid faults.


Author(s):  
Denis Juma ◽  
Bessie Monchusi ◽  
Josiah Munda ◽  
Adisa Jimoh

This paper investigates the impacts of a wind farm connected at Harterbeespoort substation in South Africa on voltage stability of the power network. The site wind speed was determined and analyzed for viability. A comparison is made between the use of Doubly-Fed Induction Generators and Self-excited Induction Generators driven by the wind turbines. The resulting P-V and Q-V curves from load flow studies are presented and analyzed. The models for this study were implemented in DigSILENT PowerFactory.


Sign in / Sign up

Export Citation Format

Share Document