End-Gas Temperature Measurements in a DOHC Spark-Ignition Engine Using CARS

2000 ◽  
Author(s):  
Inyong Choi ◽  
Kwang Min Chun ◽  
Chul-Woung Park ◽  
Jae Won Hahn
Keyword(s):  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Temperature Measurements ◽  
Gas Temperature

Emissions Level Approximation at Cold Start for Spark Ignition Engine Vehicles

2014 ◽  
Vol 555 ◽  
pp. 375-384 ◽  
Author(s):  
Stelian Tarulescu ◽  
Adrian Soica
Keyword(s):  
Cold Start ◽  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Estimation Methods ◽  
Exhaust Gas ◽  
Gas Temperature ◽  
Mathematical Approximation ◽  
Exhaust Gas Temperature ◽  
The Mathematical Model ◽  
Polynomial Regressions

This paper present a study regarding the emissions produced at the engine cold start. Also, the paper presents a brief survey of current extra emissions estimation methods. The main goal of this work is to describe the relative cold start extra emissions as a function of exhaust gas temperature. Experimental research has been done for a light vehicle, Dacia Sandero, equipped with a 1390 cm3 Renault spark ignition engine (Power = 55 kW at 5500 rpm). There were been made several tests, in different temperature conditions, in the could season, using a portable analyzer, GA-21 plus (produced by Madur Austria). The parameters measured with the analyzer and used in the analysis are: CO, NO, NOx and SO2. It was concluded that the highest pollutants values ​​are recorded until the point when the catalyst comes into operation (when the gas temperature entering the catalyst is approx. 200 oC) and exhaust gas temperature is 40-50 oC. In order to accomplish a mathematical approximation of CO, NO and SO2 in function of exhaust gas temperature, logarithmic approximations and polynomial regressions were used. The curves resulted from the mathematical model can be used to approximate the level of CO, NO and SO2, for similar vehicles.

scholarly journals Correlation of Performance, Exhaust Gas Temperature and Speed of a Spark Ignition Engine Using Kiva4

2021 ◽  
Vol 09 (08) ◽  
pp. 53-78
Author(s):  
Joseph Lungu ◽  
Lennox Siwale ◽  
Rudolph Joe Kashinga ◽  
Shadreck Chama ◽  
Akos Bereczky
Keyword(s):  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Exhaust Gas ◽  
Gas Temperature ◽  
Exhaust Gas Temperature

Performance and Emissions of Acetone-Butanol-Ethanol (ABE) and Gasoline Blends in a Port Fuel Injected Spark Ignition Engine

2014 ◽  
Author(s):  
Karthik Nithyanandan ◽  
Chia-fon F. Lee ◽  
Han Wu ◽  
Jiaxiang Zhang
Keyword(s):  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Exhaust Gas ◽  
Engine Fuel ◽  
Cylinder Pressure ◽  
Gas Temperature ◽  
Promising Alternative ◽  
Unburned Hydrocarbons ◽  
Exhaust Gas Temperature ◽  
Acetone Butanol Ethanol

Acetone-Butanol-Ethanol (ABE), an intermediate product in the ABE fermentation process for producing bio-butanol, is considered a promising alternative fuel because it not only preserves the advantages of oxygenated fuels which typically emit fewer pollutants, but also lowers the cost of fuel recovery for each individual component during fermentation. An experiment was conducted using a Ford single-cylinder spark-ignition (SI) research engine to investigate the potential of ABE as an SI engine fuel. Blends of pure gasoline and ABE, ranging from 0% to 80% vol. ABE, were created and the performance and emission characteristics were compared with pure gasoline as the baseline. Measurements of brake torque and exhaust gas temperature along with in-cylinder pressure traces were used to study the performance of the engine and measurements of emissions of unburned hydrocarbons, carbon monoxide, and nitrogen oxides were used to compare the fuels in terms of combustion byproducts. Experiments were performed at a constant engine speed and a comparison was made on the basis of similar power output (Brake Mean Effective Pressure (BMEP)). In-cylinder pressure data showed that the peak pressure of all the blends was slightly lower than that of gasoline, except for ABE80 which showed a slightly higher and advanced peak relative to gasoline. ABE showed an increase in brake specific fuel consumption (BSFC); while exhaust gas temperature and nitrogen oxide measurements show that ABE combusts at a lower peak temperature. The emissions of unburned hydrocarbons were higher compared to those of gasoline but the CO emissions were lower. Of particular interest is the combined effect of the higher laminar flame speed (LFS) and higher latent heat of vaporization of ABE fuels on the combustion process.

Sign in / Sign up

Export Citation Format

Share Document