Detached Eddy Simulation of Transition in Turbomachinery: Linear Compressor Cascade

The adaptive, l2-omega delayed detached eddy simulation model was selected to simulate the flow in the V103 linear compressor cascade. The Reynolds number based on axial chord length is 138,500. Varies inflow turbulent intensities from 0% to 10% were tested to evaluate the performance of the adaptive model. The adaptive model is capable of capturing the laminar boundary layer and the large scale perturbations inside it. The instability of large scale disturbances signals the switch to a hybrid simulation of turbulent boundary layer -- the transition front is thus predicted. In the case of separation-induced transition, the adaptive model, which uses eddy simulation in separated flow, can predict the separation bubble size accurately. Generally, the adaptive, delayed detached eddy simulation model can simulate the transitional separated flow in a linear compressor cascade, with a correct response to varying turbulent intensities.

An Analysis of the Secondary Flow Around a Tandem Blade Under the Presence of a Tip Gap in a High-Speed Linear Compressor Cascade

Tandem blades have often been under investigation, experimentally as well as numerically, but most studies have been about tandem blade stators without tip gap. This work analyzes the influence of a tip gap on the flow field of a tandem blade for engine core compressors. Experiments have been conducted in a high-speed linear compressor cascade on a tandem and a reference geometry. The flow is analyzed using five-hole probe measurements in the wake of the blades and oil flow visualization to show the near surface stream lines. First, the results for design conditions (tandem and conventional blade) are compared to measurements on corresponding blades without tip gap. Similarities and differences in the flow topology due to the tip clearance are analyzed, showing that the introduction of the tip clearance has a similar influence on the loss and turning development for the tandem and the conventional blade. The tandem blade features two tip clearance vortices with a complex flow interaction and the possible formation of a third counter-rotating vortex between them. An incidence variation from 0deg to 5deg for both blades indicates at first a similar behavior. After a separation of the flow field into gap and non-gap half it becomes apparent that the tandem blade shows higher losses on the gap side, while featuring a close-to-constant behavior on the non-gap side. Further investigation of the flow on the gap side shows indicators of the front blade exhibiting tip clearance vortex break down.