An Analysis of Electrochemical Wire Cutting Process Using Finite Element Technique

1980 ◽  
pp. 631-636 ◽  
Author(s):  
V. K. Jain ◽  
P. C. Pandey
Keyword(s):  
Finite Element ◽  
Cutting Process ◽  
Finite Element Technique ◽  
Wire Cutting ◽  
Element Technique

A Study of Wall Ironing by the Finite Element Technique

1978 ◽  
Vol 100 (1) ◽  
pp. 31-36 ◽  
Author(s):  
E. I. Odell
Keyword(s):  
Finite Element ◽  
Lower Bound ◽  
Cone Angle ◽  
Reduction Ratio ◽  
Operating Parameters ◽  
Finite Element Technique ◽  
Elastic Plastic ◽  
Maximum Reduction ◽  
Load Displacement ◽  
Element Technique

Wall ironing has been analyzed using an elastic-plastic finite element technique. The effects that the ironing ring semi-cone angle and friction have on the maximum reduction ratio are studied in detail. Stress contours are given for a typical set of operating parameters. Several ram load/displacement curves are provided and compared with upper and lower bound loads.

The Effect of Initial Forces on the Hydroelastic Vibration and Stability of Planar Curved Tubes

1974 ◽  
Vol 41 (2) ◽  
pp. 355-359 ◽  
Author(s):  
J. L. Hill ◽  
C. G. Davis
Keyword(s):  
Finite Element ◽  
Internal Pressure ◽  
Constant Curvature ◽  
Elastic Limit ◽  
Center Line ◽  
Finite Element Technique ◽  
Line Shapes ◽  
Circular Arcs ◽  
Out Of Plane ◽  
Element Technique

The effect of initial forces on the vibration and stability of curved, clamped, fluid conveying tubes is analyzed by the finite-element technique. The tubes are initially planar with general center-line shapes approximated by constant curvature arcs. The effect of internal pressure is included. Numerical results are presented with, and without, the effects of the initial in-plane forces, for circular arcs S, L, and spiral configurations. Neglecting initial forces results in out-of-plane buckling, while including these forces prevents buckling within the elastic limit, in all configurations studied.

Sign in / Sign up

Export Citation Format

Share Document