A Simple Transfer Tube for Liquid Helium

A flexible and transparent transfer tube for liquid helium

Cryogenics ◽

10.1016/0011-2275(63)90027-4 ◽

1963 ◽

Vol 3 (2) ◽

pp. 104 ◽

Cited By ~ 2

Author(s):

R.A Kimber

Keyword(s):

Liquid Helium ◽

Transfer Tube

Download Full-text

127. Precooling device for liquid helium transfer tube.

Vacuum ◽

10.1016/0042-207x(60)90294-3 ◽

1960 ◽

Vol 10 (3) ◽

pp. 283

Keyword(s):

Liquid Helium ◽

Transfer Tube

Download Full-text

Liquid Helium Transfer Tube

Review of Scientific Instruments ◽

10.1063/1.1718277 ◽

1963 ◽

Vol 34 (12) ◽

pp. 1449-1450 ◽

Cited By ~ 3

Author(s):

M. W. Dowley ◽

R. D. Knight

Keyword(s):

Liquid Helium ◽

Transfer Tube

Download Full-text

Precooling Device for Liquid Helium Transfer Tube

Review of Scientific Instruments ◽

10.1063/1.1716702 ◽

1959 ◽

Vol 30 (7) ◽

pp. 601-602

Author(s):

H. H. M. Zerbst

Keyword(s):

Liquid Helium ◽

Transfer Tube

Download Full-text

Automated liquid‐helium transfer tube lifting system

Review of Scientific Instruments ◽

10.1063/1.1141416 ◽

1990 ◽

Vol 61 (7) ◽

pp. 2004-2005 ◽

Cited By ~ 1

Author(s):

Kiyonori Kato ◽

Mitsukazu Suzui

Keyword(s):

Liquid Helium ◽

Transfer Tube ◽

Lifting System

Download Full-text

A Superconducting Microscope

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100064104 ◽

1971 ◽

Vol 29 ◽

pp. 10-11 ◽

Cited By ~ 1

Author(s):

R. E. Worsham ◽

J. E. Mann ◽

E. G. Richardson

Keyword(s):

Liquid Helium ◽

Focal Length ◽

Vacuum System ◽

Objective Lens ◽

Electrical Instability ◽

Radiation Shields ◽

And Control ◽

Thermal Oscillations ◽

Flux Pump

This superconducting microscope, Figure 1, was first operated in May, 1970. The column, which started life as a Siemens Elmiskop I, was modified by removing the objective and intermediate lenses, the specimen chamber, and the complete vacuum system. The large cryostat contains the objective lens and stage. They are attached to the bottom of the 7-liter helium vessel and are surrounded by two vapor-cooled radiation shields.In the initial operational period 5-mm and 2-mm focal length objective lens pole pieces were used giving magnification up to 45000X. Without a stigmator and precision ground pole pieces, a resolution of about 50-100Å was achieved. The boil-off rate of the liquid helium was reduced to 0.2-0.3ℓ/hour after elimination of thermal oscillations in the cryostat. The calculated boil-off was 0.2ℓ/hour. No effect caused by mechanical or electrical instability was found. Both 4.2°K and 1.7-1.9°K operation were routine. Flux pump excitation and control of the lens were quite smooth, simple, and, apparently highly stable. Alignment of the objective lens proved quite awkward, however, with the long-thin epoxy glass posts used for supporting the lens.

Download Full-text

Water accumulation as a function of temperature on specimens in an electron microscope cold stage

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100142219 ◽

1986 ◽

Vol 44 ◽

pp. 114-115 ◽

Cited By ~ 2

Author(s):

M.K. Lamvik ◽

D.A. Kopf ◽

S.D. Davilla ◽

J.D. Robertson

Keyword(s):

Electron Microscope ◽

Mass Loss ◽

Liquid Helium ◽

Liquid Nitrogen ◽

Liquid Nitrogen Temperature ◽

Liquid Helium Temperature ◽

Helium Temperature ◽

Cold Stage ◽

Water Accumulation ◽

Better Than

Last year we reported1 that there is a striking reduction in the rate of mass loss when a specimen is observed at liquid helium temperature. It is important to determine whether liquid helium temperature is significantly better than liquid nitrogen temperature. This requires a good understanding of mass loss effects in cold stages around 100K.

Download Full-text