Direct Measurement of R Value for Aluminum Alloy Sheet Metal Using Digital Image Correlation

2017 ◽  
pp. 89-94 ◽  
Author(s):  
Xin Xie ◽  
Junrui Li ◽  
Boyang Zhang ◽  
Bernard Sia ◽  
Lianxiang Yang
Keyword(s):  
Aluminum Alloy ◽  
Digital Image Correlation ◽  
Sheet Metal ◽  
Direct Measurement ◽  
Digital Image ◽  
Alloy Sheet ◽  
Image Correlation ◽  
Aluminum Alloy Sheet ◽  
R Value

An experimental validation of volume conservation assumption for aluminum alloy sheet metal using digital image correlation method

2016 ◽  
Vol 52 (1) ◽  
pp. 24-29 ◽  
Author(s):  
Xin Xie ◽  
Junrui Li ◽  
Bernard Sia ◽  
Tian Bai ◽  
Thorsten Siebert ◽  
...  
Keyword(s):  
Aluminum Alloy ◽  
Digital Image Correlation ◽  
Sheet Metal ◽  
Volume Change ◽  
Digital Image ◽  
Experimental Validation ◽  
Tensile Tests ◽  
Experimental Results ◽  
Image Correlation ◽  
Volume Conservation

This article shows an experimental validation of the volume conservation assumption (zero plastic volume change assumption) for aluminum alloy (AA6000) sheet metal. A series of tensile tests were conducted. During the tensile tests, an optimized digital image correlation setup was used to simultaneously measure three principal strain components. The experimental results show that, at locations outside the necking band, AA6000 strictly follows the zero plastic volume change assumption throughout the duration of the test. Inside the necking band, AA6000 follows the zero plastic volume change assumption in the elastic range and early plastic range. However, before failure, a visible volume strain increase can be found inside the necking band, which shows that, in the deep plastic zone, AA6000 does not always follow the volume conservation assumption. The experiment plan, measurement setup optimization, experimental results and data analysis are shown in detail.

Sheet-Metal Assessment at Medium Strain-Rates by Digital Image Correlation

Strain ◽  
2010 ◽  
Vol 46 (4) ◽  
pp. 396-403 ◽  
Author(s):  
G. B. Broggiato ◽  
D. Ferrari ◽  
M. Fischer ◽  
V. Veglianti
Keyword(s):  
Digital Image Correlation ◽  
Sheet Metal ◽  
Digital Image ◽  
Image Correlation ◽  
Strain Rates

scholarly journals Process metallurgy design for high-formability aluminum alloy sheet metal generation by using two-scale FEM

2011 ◽  
Vol 10 ◽  
pp. 2250-2255 ◽  
Author(s):  
Hiroyuki Kuramae ◽  
Hidetoshi Sakamoto ◽  
Hideo Morimoto ◽  
Eiji Nakamachi
Keyword(s):  
Aluminum Alloy ◽  
Sheet Metal ◽  
Alloy Sheet ◽  
Aluminum Alloy Sheet ◽  
Process Metallurgy
Sign in / Sign up

Export Citation Format

Share Document