Analysis of Uniformly Distributed Limit Load for Circular Plate by TSS Criterion

Author(s):  
Siwei Gao ◽  
Shunhu Zhang ◽  
Guijing Wu ◽  
Jian Cao
Keyword(s):  
2018 ◽  
Vol 15 (1) ◽  
pp. 59
Author(s):  
NAZRUL AZMI AHMAD ZAMRI ◽  
CLOTILDA PETRUS ◽  
AZMI IBRAHIM ◽  
HANIZAH AB HAMID

The application of concrete filled steel tubes (CFSTs) as composite members has widely been used around the world and is becoming popular day by day for structural application especially in earthquake regions. This paper indicates that an experimental study was conducted to comprehend the behaviour of T-stub end plates connected to concrete filled thin-walled steel tube (CFTST) with different types of bolts and are subjected to pullout load. The bolts used are normal type bolt M20 grade 8.8 and Lindapter Hollo-bolt HB16 and HB20. A series of 10 mm thick T-stub end plates were fastened to 2 mm CFTST of 200 mm x 200 mm in cross-section. All of the specimens were subjected to monotonic pull-out load until failure. Based on test results, the Lidapter Hollo-bolts showed better performance compare to normal bolts. The highest ultimate limit load for T-stub end plate fasten with Lindapter Hollo-bolt is four times higher than with normal bolt although all end plates show similar behaviour and failure mode patterns. It can be concluded that T-stub end plate with Lindapter Hollo-bolt shows a better performance in the service limit and ultimate limit states according to the regulations in the design codes.


2020 ◽  
Vol 29 (4) ◽  
pp. 444-453
Author(s):  
Mykola Nagirniak

The work presents the equations of the theory of symmetrical plates, resting on one-way, single-layer, two-parameter Vlasov’s subsoil. Two cases of differential equation solution of the plate deflection of thin and medium thickness on the ground substrate were analyzed depending on the size of the integral characteristics UÖD and 6ÖD. The example of loading the circular plate with a Pk load evenly distributed over the edge was considered and shows dimensionless graphs of deflection, bending torques and transverse forces in the plate and in the ground subsoil. The effect of the Poisson’s coefficient of the plate on deflection values and cross-sectional forces was investigated. The Poisson’s number has been shown to have a significant influence on deflection values and bending torque, however shown negligible effect on transverse forces values.


2021 ◽  
Author(s):  
Jicheng Zhang ◽  
Lifeng Wang ◽  
Guoan Tai ◽  
Jianxin Zhou ◽  
Wei Sun ◽  
...  

Author(s):  
Weipeng Hu ◽  
Mengbo Xu ◽  
Ruisong Jiang ◽  
Chuanzeng Zhang ◽  
Zichen Deng

Sign in / Sign up

Export Citation Format

Share Document