Determination of U, Pu, Am and Cm in water coolant of nuclear power plants using membranes impregnated with hydrated manganese dioxide

1998 ◽  
Vol 232 (1-2) ◽  
pp. 163-166 ◽  
Author(s):  
V. N. Yepimakhov ◽  
S. V. Glushkov
Keyword(s):  
Manganese Dioxide ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Water Coolant ◽  
Hydrated Manganese Dioxide

scholarly journals Control Experiences Regarding Clearable Materials from Nuclear Power Plants and Nuclear Installations: Scaling Factors Determination and Measurements’ Acceptance Criteria Definition

Environments ◽  
2019 ◽  
Vol 6 (11) ◽  
pp. 120
Author(s):  
Luca Albertone ◽  
Massimo Altavilla ◽  
Manuela Marga ◽  
Laura Porzio ◽  
Giuseppe Tozzi ◽  
...  
Keyword(s):  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Fission Products ◽  
Scaling Factors ◽  
Activation Products ◽  
Long Time ◽  
Nuclear Installation ◽  
Enriched Uranium

Arpa Piemonte has been carrying out, for a long time, controls on clearable materials from nuclear power plants to verify compliance with clearance levels set by ISIN (Ispettorato Nazionale per la Sicurezza Nucleare e la Radioprotezione - National Inspectorate for Nuclear Safety and Radiation Protection) in the technical prescriptions attached to the Ministerial Decree decommissioning authorization or into category A source authorization (higher level of associated risk, according to the categorization defined in the Italian Legislative Decree No. 230/95). After the experience undertaken at the “FN” (Fabbricazioni Nucleari) Bosco Marengo nuclear installation, some controls have been conducted at the Trino nuclear power plant “E. Fermi,” “LivaNova” nuclear installation based in Saluggia, and “EUREX” (Enriched Uranium Extraction) nuclear installation, also based in Saluggia, according to modalities that envisage, as a final control, the determination of γ-emitting radionuclides through in situ gamma spectrometry measurements. Clearance levels’ compliance verification should be performed for all radionuclides potentially present, including those that are not easily measurable (DTM, Difficult To Measure). It is therefore necessary to carry out upstream, based on a representative number of samples, those radionuclides’ determination in order to estimate scaling factors (SF), defined through the logarithmic average of the ratios between the i-th DTM radionuclide concentration and the related key nuclide. Specific radiochemistry is used for defining DTMs’ concentrations, such as Fe-55, Ni-59, Ni-63, Sr-90, Pu-238, and Pu-239/Pu-240. As a key nuclide, Co-60 was chosen for the activation products (Fe-55, Ni-59, Ni-63) and Cs-137 for fission products (Sr-90) and plutonium (Pu- 238, Pu-239/Pu-240, and Pu-241). The presence of very low radioactivity concentrations, often below the detection limits, can make it difficult to determine the related scaling factors. In this work, the results obtained and measurements’ acceptability criteria are presented, defined with ISIN, that can be used for confirming or excluding a radionuclide presence in the process of verifying clearance levels’ compliance. They are also exposed to evaluations regarding samples’ representativeness chosen for scaling factors’ assessment.

Radiochemical methodologies applied to determination of zirconium isotopes in low-level waste samples from nuclear power plants

2014 ◽  
Vol 302 (1) ◽  
pp. 41-47 ◽  
Author(s):  
T. C. Oliveira ◽  
R. P. G. Monteiro ◽  
G. F. Kastner ◽  
F. Bessueille-Barbier ◽  
A. H. Oliveira
Keyword(s):  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Low Level

scholarly journals Polymeric seal degradation in nuclear power plants: Determination of physical and mechanical properties

2017 ◽  
Vol 135 (7) ◽  
pp. 45814 ◽  
Author(s):  
Christopher P. Porter ◽  
James P. Bezzina ◽  
Francis Clegg ◽  
Mark D. Ogden
Keyword(s):  
Mechanical Properties ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Physical And Mechanical Properties

Determination of gaseous radionuclide forms in the stack air of nuclear power plants

2009 ◽  
Vol 67 (5) ◽  
pp. 950-952 ◽  
Author(s):  
J. Tecl ◽  
I. Svetlik
Keyword(s):  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants

Determination of radioactivity concentrations of fission products in the primary coolant of nuclear power plants

1991 ◽  
Vol 147 (2) ◽  
pp. 347-353 ◽  
Author(s):  
D. Bódizs ◽  
S. Dési ◽  
G. Keömley ◽  
T. Pintér
Keyword(s):  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Fission Products ◽  
Primary Coolant

Determination of hydrazine at Ontario nuclear power plants

2015 ◽  
Vol 7 (23) ◽  
pp. 9825-9834 ◽  
Author(s):  
Slobodan V. Jovanovic ◽  
Thomas Zakharov ◽  
Hemendra Mulye ◽  
Duck Kim ◽  
Kelly-Anne Fagan
Keyword(s):  
Ion Chromatography ◽  
Water Samples ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Limit Of Detection ◽  
Limit Of Quantification ◽  
Amperometric Detector ◽  
Sensitive Method

In this study, we developed and validated a sensitive method for the determination of hydrazine in water samples using ion chromatography coupled with an amperometric detector (limit of detection (LOD) = 0.02 μg L−1 and limit of quantification (LOQ) = 0.1 μg L−1).

Determination of Volatile Organic Compounds in Indoor Air of Buildings in Nuclear Power Plants, Taiwan

2006 ◽  
Vol 170 (1-4) ◽  
pp. 107-121 ◽  
Author(s):  
Ling-Ling Hsieh ◽  
Chih-Chung Chang ◽  
Usha Sree ◽  
Jiunn-Guang Lo
Keyword(s):  
Volatile Organic Compounds ◽  
Organic Compounds ◽  
Indoor Air ◽  
Nuclear Power ◽  
Power Plants ◽  
Nuclear Power Plants ◽  
Volatile Organic
Sign in / Sign up

Export Citation Format

Share Document