Stearns-Noechel color matching model of digital rotor spinning viscose melange yarn

Cellulose ◽  
2021 ◽  
Author(s):  
Ruihua Yang ◽  
Bo Pan ◽  
Kanglei Zhang ◽  
Zhuo Wang
2021 ◽  
pp. 004051752110408
Author(s):  
Ruihua Yang ◽  
Chuang He ◽  
Bo Pan ◽  
Zhuo Wang

The color-matching model is conducive to expanding the scope of application of colorful fabrics and can speed up the achievement of intelligent production. To solve the problem in which the existing color-matching system of intelligent colored spun yarn cannot be applied to the digital rotor-spinning products of dope dyed viscose fiber, 66 types of mélange yarn were spun with a digital rotor-spinning frame using red, yellow, and blue dope dyed viscose fibers at a ratio gradient of 10%. Furthermore, the knitted fabric samples were produced using a circular machine. Meanwhile, a Datacolor 650 spectrophotometer was used for color testing, and the experimental results were recorded. Based on the color-matching model of the Kubelka–Munk theory, a color-matching model is built based on the experimental results. In addition, the accuracy of the model was analyzed and verified using the least-squares and relative value methods. The results show that, compared with the relative value method, the color-matching model constructed using the absorption coefficient K value and scattering coefficient S value calculated based on the least-squares approach is more accurate. The error between the predicted ratio of the test sample and the actual ratio was only 0.0979, the average color difference was only 0.465, and there were no visible differences between the predicted color of the sample and the actual color.


2010 ◽  
Vol 174 ◽  
pp. 64-67
Author(s):  
Wei Guo Bai ◽  
Xing Yue Hu ◽  
Yan Yan

The admixture of Spot-color ink is generally determined by experience to make sure the type of primary color and the use of each ink, and then change the proportion of each primary color by the chromaticity control or visual experience. While this approach is difficult to admixture a qualified spot color ink, it also easily leads to the waste of ink. This paper did many researches and experiments on how to establish a spot color matching system based on the calculation of ink. Through the calculation of the largest ink thickness on paper, the model of the total estimated amount of printing based on image is established. Then this paper adopts the method of three stimulate value matching to establish the spot-color matching model based on Kubelka-Munk law. Through the combination of these two models above, spot color matching system based on ink calculation is finally established, and verified through the actual printing.


2019 ◽  
Vol 70 (4) ◽  
pp. 386
Author(s):  
RUI HUA YANG ◽  
◽  
YAYA XU ◽  
CHUN PING XIE ◽  
BO JUN XU ◽  
...  

2014 ◽  
Vol 16 (7) ◽  
pp. 07-14
Author(s):  
Tatsumi Shinogi ◽  
◽  
Saki Aihara ◽  
Kakuro Amasaka

2019 ◽  
Vol 2019 (1) ◽  
pp. 320-325 ◽  
Author(s):  
Wenyu Bao ◽  
Minchen Wei

Great efforts have been made to develop color appearance models to predict color appearance of stimuli under various viewing conditions. CIECAM02, the most widely used color appearance model, and many other color appearance models were all developed based on corresponding color datasets, including LUTCHI data. Though the effect of adapting light level on color appearance, which is known as "Hunt Effect", is well known, most of the corresponding color datasets were collected within a limited range of light levels (i.e., below 700 cd/m2), which was much lower than that under daylight. A recent study investigating color preference of an artwork under various light levels from 20 to 15000 lx suggested that the existing color appearance models may not accurately characterize the color appearance of stimuli under extremely high light levels, based on the assumption that the same preference judgements were due to the same color appearance. This article reports a psychophysical study, which was designed to directly collect corresponding colors under two light levels— 100 and 3000 cd/m2 (i.e., ≈ 314 and 9420 lx). Human observers completed haploscopic color matching for four color stimuli (i.e., red, green, blue, and yellow) under the two light levels at 2700 or 6500 K. Though the Hunt Effect was supported by the results, CIECAM02 was found to have large errors under the extremely high light levels, especially when the CCT was low.


2010 ◽  
Vol 22 (6) ◽  
pp. 990-996 ◽  
Author(s):  
Rukun Fan ◽  
Jing Fu ◽  
Silei Cheng ◽  
Xiang Zhang ◽  
Weidong Geng
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document