A simplified mathematical model for the dam-breach hydrograph for three reservoir geometries following a sudden full dam break

2020 ◽  
Vol 102 (3) ◽  
pp. 1515-1540
Author(s):  
Hui Hu ◽  
Jianfeng Zhang ◽  
Tao Li ◽  
Jie Yang
2015 ◽  
Vol 713-715 ◽  
pp. 756-759
Author(s):  
Xu Guang Zhang ◽  
Zhen Xie

A flux damping control strategy was proposed to accelerate the decay of stator flux and restrain stator, rotor current and torque oscillation caused by grid voltage dips. Firstly, this paper analyzes the simplified mathematical model of DFIG during symmetrical voltage dips. Then, the mechanism of flux damping control strategy to restrain stator, rotor current oscillation and increase flux damping was analyzed. The flux damping control strategy can increase the damping of stator side, which accelerates the decay of the stator flux natural component and improve the dynamic LVRT performance of DFIG. The correctness and effectiveness of this method is verified by MATLAB/Simulink simulation results.


2011 ◽  
Vol 31 (5) ◽  
pp. 1015-1026
Author(s):  
Julio C. Molina ◽  
Carlito Calil Júnior ◽  
Roberto R. de Freitas

In São Paulo State, mainly in rural areas, the utilization of wooden poles is observed for different purposes. In this context, wood in contact with the ground presents faster deterioration, which is generally associated to environmental factors and, especially to the presence of fungi and insects. With the use of mathematical models, the useful life of wooden structures can be predicted by obtaining "climatic indexes" to indicate, comparatively among the areas studied, which have more or less tendency to fungi and insects attacks. In this work, by using climatological data of several cities at São Paulo State, a simplified mathematical model was obtained to measure the aggressiveness of the wood in contact with the soil.


2017 ◽  
Vol 27 (6) ◽  
pp. 150-153
Author(s):  
L. Ya. Poberezhnyi ◽  
A. V. Hrytsanchuk ◽  
S. M. Petrushchak

2006 ◽  
Vol 18 (1) ◽  
pp. 89-96 ◽  
Author(s):  
Andrea Manuello Bertetto ◽  
◽  
Maurizio Ruggiu

In this paper an aquatic device inspired to the fish propulsion is proposed. At the first, the operating principle of the fluidic actuator and its experimental characterization are presented. Then, the results of numerous tests carried out on the integrated tail-actuator device are shown either in terms of thrust exerted or as biomorphism of its kinematics. The tests were run at several driven frequencies with different fins depending on their geometrical dimensions and compliances. On the other hand, a simplified mathematical model of the propulsion system, based on the calculation of the instantaneous tail kinematics and dynamics by means of a numerical procedure, is proposed with the aim of simulating performances either in terms of thrust exerted or kinematics behavior. Finally a discussion about the results obtained and a comparison between experimental and numerical data are presented.


2018 ◽  
Vol 232 ◽  
pp. 04043
Author(s):  
Xudong Zhang ◽  
Haiyu Ji

A simplified mathematical model for modulation and demodulation of a single channel monopulse (SCM) system is proposed, which is based on a ship-borne pulse radar S-band guided receiver. Using the proposed mathematical model, the modulation and demodulation of single-channel and multi-channel signals were simulated respectively, and the factors influencing the modulation and demodulation of the SCM system were analysed.


2013 ◽  
Vol 13 (07) ◽  
pp. 1340009 ◽  
Author(s):  
JAN KOZÁNEK ◽  
VÁCLAV VLČEK ◽  
IGOR ZOLOTAREV

A high speed camera was used for interferometry visualization (in different phases of the motion) of the fluttering NACA0015 profile supported in a translational and rotational manner. First, the simplified mathematical model of the support of investigated profile was identified from minimum least squares differences between modeled and measured system responses. A special graphical Matlab procedure was proposed for evaluation of interferograms. Kinematic analysis defining motion of the profile as a function of time was obtained by a regression using the least squares method. Numerical integration of pressure functions around the airfoil surface allows for calculation of the resulting aerodynamic forces and moments.


Sign in / Sign up

Export Citation Format

Share Document