Effects of CO2 on pulmonary air flow resistance in the duck

1976 ◽  
Vol 26 (3) ◽  
pp. 333-349 ◽  
Author(s):  
V. Molony ◽  
W. Graf ◽  
P. Scheid
1982 ◽  
Vol 25 (4) ◽  
pp. 1103-1106 ◽  
Author(s):  
C. F. Abrams ◽  
Jr. ◽  
J. D. Fish ◽  
Jr

2000 ◽  
Vol os-9 (3) ◽  
pp. 1558925000OS-90
Author(s):  
Peter Ping-yi Tsai ◽  
Guo-wei Qin ◽  
Charles Hassenboehler

Melt blown (MB) fabrics are composed of fine fibers which contribute to high filtration efficiency (FE) and low air flow resistance compared to high efficiency filtration media such as fiber glass paper. Furthermore, MB fabrics are mostly made of polypropylene (PP) polymer, which can be electrostatically charged to enhance the media filtration efficiency without the increase of air flow resistance. However, different charging techniques or charging at different locations on the MB line will contribute to different filtration efficiency. This paper compares the efficiencies of different charging techniques in the MB line.


1994 ◽  
Vol 17 (3) ◽  
pp. 175-182 ◽  
Author(s):  
G.J. Verkerke ◽  
A. Veenstra ◽  
H.K. Schutte ◽  
I.F. Herrmann ◽  
G. Rakhorst

The surgical treatment of throat cancer often requires total laryngectomy. The necessary tracheostoma attracts attention, especially during speech, when one must close it manually to force air into the esophagus. To avoid this manual control, several devices have been developed. These must be placed in or around the tracheostoma and possess a valve which closes with a large air flow value. Most devices have a major drawback; coughing calls for manual adaptation, which again attracts attention. A new hands-free tracheostoma valve has been developed. The device consists of two magnetic valves, one which closes the outflow to allow speech, and one which opens to cough. Prototypes were tested in a physical model. Air flow resistance and closing pressures of the speech valve proved to be comparable to those of existing devices. Patients were enthusiastic about the new approach, even though air leakage sometimes occurred.


1999 ◽  
Vol 123 (3) ◽  
pp. 315-318 ◽  
Author(s):  
Keiji Sasao ◽  
Mitsuru Honma ◽  
Atsuo Nishihara ◽  
Takayuki Atarashi

A numerical method for simulating impinging air flow and heat transfer in plate-fin type heat sinks has been developed. In this method, all the fins of an individual heat sink and the air between them are replaced with a single, uniform element having an appropriate flow resistance and thermal conductivity. With this element, fine calculation meshes adapted to the shape of the actual heat sink are not needed, so the size of the calculation mesh is much smaller than that of conventional methods.


Sign in / Sign up

Export Citation Format

Share Document