Acceleration of fully implicit Navier-Stokes solvers with Proper Orthogonal Decomposition on GRID architecture

Author(s):  
D. Tromeur-Dervout ◽  
Y. Vassilevski
2009 ◽  
Vol 629 ◽  
pp. 41-72 ◽  
Author(s):  
ALEXANDER HAY ◽  
JEFFREY T. BORGGAARD ◽  
DOMINIQUE PELLETIER

The proper orthogonal decomposition (POD) is the prevailing method for basis generation in the model reduction of fluids. A serious limitation of this method, however, is that it is empirical. In other words, this basis accurately represents the flow data used to generate it, but may not be accurate when applied ‘off-design’. Thus, the reduced-order model may lose accuracy for flow parameters (e.g. Reynolds number, initial or boundary conditions and forcing parameters) different from those used to generate the POD basis and generally does. This paper investigates the use of sensitivity analysis in the basis selection step to partially address this limitation. We examine two strategies that use the sensitivity of the POD modes with respect to the problem parameters. Numerical experiments performed on the flow past a square cylinder over a range of Reynolds numbers demonstrate the effectiveness of these strategies. The newly derived bases allow for a more accurate representation of the flows when exploring the parameter space. Expanding the POD basis built at one state with its sensitivity leads to low-dimensional dynamical systems having attractors that approximate fairly well the attractor of the full-order Navier–Stokes equations for large parameter changes.


2013 ◽  
Vol 2013 ◽  
pp. 1-12 ◽  
Author(s):  
Ibrahim Yilmaz ◽  
Ece Ayli ◽  
Selin Aradag

Simulations of supersonic turbulent flow over an open rectangular cavity are performed to observe the effects of length to depth ratio (L/D) of the cavity on the flow structure. Two-dimensional compressible time-dependent Reynolds-averaged Navier-Stokes equations with k-ωturbulence model are solved. A reduced order modeling approach, Proper Orthogonal Decomposition (POD) method, is used to further analyze the flow. Results are obtained for cavities with severalL/Dratios at a Mach number of 1.5. Mostly, sound pressure levels (SPL) are used for comparison. After a reduced order modeling approach, the number of modes necessary to represent the systems is observed for each case. The necessary minimum number of modes to define the system increases as the flow becomes more complex with the increase in theL/Dratio. This study provides a basis for the control of flow over supersonic open cavities by providing a reduced order model for flow control, and it also gives an insight to cavity flow physics by comparing several simulation results with different length to depth ratios.


2019 ◽  
Vol 40 (2) ◽  
pp. 886-913 ◽  
Author(s):  
Max Gunzburger ◽  
Traian Iliescu ◽  
Michael Schneier

Abstract Partial differential equations (PDEs) are often dependent on input quantities that are uncertain. To quantify this uncertainty PDEs must be solved over a large ensemble of parameters. Even for a single realization this can be a computationally intensive process. In the case of flows governed by the Navier–Stokes equations, an efficient method has been devised for computing an ensemble of solutions. To further reduce the computational cost of this method, an ensemble-proper orthogonal decomposition (POD) method was recently proposed. The main contribution of this work is the introduction of POD spatial filtering for ensemble-POD methods. The POD spatial filter makes possible the construction of the Leray ensemble-POD model, which is a regularized-reduced order model for the numerical simulation of convection-dominated flows of moderate Reynolds number. The Leray ensemble-POD model employs the POD spatial filter to smooth (regularize) the convection term in the Navier–Stokes equations, and diminishes the numerical inaccuracies produced by the ensemble-POD method in the numerical simulation of convection-dominated flows. Specifically, for the numerical simulation of a convection-dominated two-dimensional flow between two offset cylinders, we show that the Leray ensemble-POD method better reflects the dynamics of the benchmark results than the ensemble-POD scheme. The second contribution of this work is a new numerical discretization of the variable viscosity ensemble algorithm in which the average viscosity is replaced with the maximum viscosity. It is shown that this new numerical discretization is significantly more stable than those in current use. Furthermore, error estimates for the novel Leray ensemble-POD algorithm with this new numerical discretization are also proven.


Author(s):  
A Zare ◽  
H Emdad ◽  
E Goshtasbirad

The purpose of this article is to design a reduced order model based on the proper orthogonal decomposition/Galerkin projection and perturbation method to develop a non-autonomous model. The resulting model can be used in optimal control of flow over backward-facing step. The main disadvantage of the proper orthogonal decomposition approach for control purposes is that, controlling parameters or inputs do not show up explicitly in the resulting reduced order system. The perturbation method can solve this problem and insert control inputs in the resulting system. The resulting system captures the time-varying influence of the controlling parameters and precisely predicts the Navier–Stokes response to external excitations. At last, optimal control theory is introduced to design a control law for a non-linear forced reduced model, which attempts to minimize the vorticity content in the fluid domain. The test bed is laminar flow behind backward-facing step [Formula: see text] actuated by a pair of blowing/suction jets. Results show that the wall jet can significantly influence the flow field and delay separation, while the perturbation method can predict the flow field in an accurate manner. The method is also found to be fast and efficient in computational time.


Sign in / Sign up

Export Citation Format

Share Document