Experimental study of grouted sleeve connections under bending for steel modular buildings

2021 ◽  
Vol 243 ◽  
pp. 112614
Author(s):  
Ziquan Dai ◽  
T.Y. Clarence Cheong ◽  
Sze Dai Pang ◽  
J.Y. Richard Liew
2020 ◽  
Vol 154 ◽  
pp. 106790
Author(s):  
John Jing ◽  
G. Charles Clifton ◽  
Krishanu Roy ◽  
James B.P. Lim

2021 ◽  
Vol 21 (2) ◽  
pp. 15-21
Author(s):  
Seung-Mun Son ◽  
Jae-Sung Lee ◽  
Ok-Pin Na

For a floor of a building with no less than four stories and no more than twelve stories, the two-hour fire resistance performance should be satisfied. In the case of slabs with steel studs, no two-hour fire resistance performance has been proposed in Korea. In this study, the two-hour fire resistance performance of slabs with steel studs performing as structural elements of modular buildings was evaluated. These specimens were redesigned based on the typical slab used in Europe and North America by modifying the 45 mm fire-resistant board to achieve two-hour fire resistance. The experimental results showed that the FR-001 specimens with 140 mm mineral wool applied to the lower slab and the FR-002 specimens containing 100 mm lower-slab glass wool and 150 mm upper-slab mineral wool did not satisfy the two-hour fire resistance performance, owing to the rapid deformation of the specimens after 75 and 110 min, respectively. However, the FR-003 specimens containing 100 mm glass wool, 150 mm mineral wool in the upper slab, and concrete in the slab satisfied the two-hour fire resistance performance requirement.


Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.


1962 ◽  
Vol 5 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Bruce Quarrington ◽  
Jerome Conway ◽  
Nathan Siegel
Keyword(s):  

1974 ◽  
Vol 126 (2) ◽  
pp. 243-248
Author(s):  
A WAKABAYASHI ◽  
T KUBO ◽  
K CHARNEY ◽  
Y NAKAMURA ◽  
J CONNOLLY

1963 ◽  
Vol 45 (3) ◽  
pp. 374-383 ◽  
Author(s):  
Donald C. McIlrath ◽  
George A. Hallenbeck ◽  
Hubert A. Allen ◽  
Charles V. Mann ◽  
Edward J. Baldes ◽  
...  
Keyword(s):  

1958 ◽  
Vol 34 (1) ◽  
pp. 11-20 ◽  
Author(s):  
Henry D. Janowitz ◽  
Vernon A. Weinstein ◽  
Rhoda G. Shaer ◽  
James F. Cereghini ◽  
Franklin Hollander

Sign in / Sign up

Export Citation Format

Share Document