Removal of impurities from scandium chloride solution using 732-type resin

2018 ◽  
Vol 36 (3) ◽  
pp. 311-316 ◽  
Author(s):  
Guotao Zhou ◽  
Qinggang Li ◽  
Pan Sun ◽  
Wenjuan Guan ◽  
Guiqing Zhang ◽  
...  
1986 ◽  
Vol 18 (2) ◽  
pp. 151-156 ◽  
Author(s):  
R. Zapf-Gilje ◽  
S. O. Russell ◽  
D. S. Mavinic

When snow is made from sewage effluent, the impurities become concentrated in the early melt leaving the later runoff relatively pure. This could provide a low cost method of separating nutrients from secondary sewage effluent. Laboratory experiments showed that the degree of concentration was largely independent of the number of melt freeze cycles or initial concentration of impurity in the snow. The first 20% of melt removed with it 65% of the phosphorus and 90% of the nitrogen from snow made from sewage effluent; and over 90% of potassium chloride from snow made from potassium chloride solution. Field experiments with a salt solution confirmed the laboratory results.


2004 ◽  
Vol 89 (11-12) ◽  
pp. 1822-1825 ◽  
Author(s):  
Theodore C. Labotka ◽  
David R. Cole ◽  
Mostafa Fayek ◽  
Lee R. Riciputi ◽  
Frank J. Stadermann

2021 ◽  
Vol 9 (1) ◽  
Author(s):  
Vahid Pourzarghan ◽  
Bahman Fazeli-Nasab

AbstractThe most important inhibitors used in bronze disease are BTA and AMT. While these inhibitors control corrosion, they are toxic and cancerous. In this study, the acacia fruit extract (200 ppm to 1800 ppm) was used to the prevention of corrosion inhibition of bronze alloy in corrosive sodium chloride solution 0.5 M, for 4 weeks consecutively. The Bronze alloy used in this research, was made based on the same percentage as the ancient alloys (Cu-10Sn). IE% was used to obtain the inhibitory efficiency percentage and Rp can be calculated from the resistance of polarization. SEM–EDX was used to evaluate the surfaces of alloy as well as inhibitory. The experiment was conducted in split plot design in time based on the RCD in four replications. ANOVA was performed and comparison of means square using Duncan's multiple range test at one percent probability level. The highest rate of corrosion inhibition (93.5%) was obtained at a concentration of 1800 ppm with an increase in the concentration of the extract, corrosion inhibition also increased, i.e., more bronze was prevented from burning. Also, the highest corrosion inhibitory activity of Acacia extract (79.66) was in the second week and with increasing duration, this effect has decreased. EDX analysis of the control sample matrix showed that the amount of chlorine was 8.47%wt, while in the presence of corrosive sodium chloride solution, after 4 weeks, the amount of chlorine detected was 3.20%wt. According to the morphology (needle and rhombus) of these corrosion products based on the SEM images, it can be said, they are the type of atacamite and paratacamite. They have caused bronze disease in historical bronze works. The green inhibitor of Acacia fruit aqueous extract can play an effective role in inhibiting corrosion of bronze, but at higher concentrations, it became fungal, which can reduce the role of Acacia fruit aqueous extract and even ineffective. To get better performance of green inhibitors, more tests need to be done to improve and optimize.


Sign in / Sign up

Export Citation Format

Share Document