Insights on the origin of the structural phase transition in BaV10O15 from electronic structure calculations and the effect of Ti-doping on its structure and electrical transport properties

2004 ◽  
Vol 177 (12) ◽  
pp. 4516-4527 ◽  
Author(s):  
C.A. Bridges ◽  
J.E. Greedan ◽  
Holger Kleinke
Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 746
Author(s):  
Meiling Hong ◽  
Lidong Dai ◽  
Haiying Hu ◽  
Xinyu Zhang

A series of investigations on the structural, vibrational, and electrical transport characterizations for Ga2Se3 were conducted up to 40.2 GPa under different hydrostatic environments by virtue of Raman scattering, electrical conductivity, high-resolution transmission electron microscopy, and atomic force microscopy. Upon compression, Ga2Se3 underwent a phase transformation from the zinc-blende to NaCl-type structure at 10.6 GPa under non-hydrostatic conditions, which was manifested by the disappearance of an A mode and the noticeable discontinuities in the pressure-dependent Raman full width at half maximum (FWHMs) and electrical conductivity. Further increasing the pressure to 18.8 GPa, the semiconductor-to-metal phase transition occurred in Ga2Se3, which was evidenced by the high-pressure variable-temperature electrical conductivity measurements. However, the higher structural transition pressure point of 13.2 GPa was detected for Ga2Se3 under hydrostatic conditions, which was possibly related to the protective influence of the pressure medium. Upon decompression, the phase transformation and metallization were found to be reversible but existed in the large pressure hysteresis effect under different hydrostatic environments. Systematic research on the high-pressure structural and electrical transport properties for Ga2Se3 would be helpful to further explore the crystal structure evolution and electrical transport properties for other A2B3-type compounds.


Author(s):  
Christian Paulsen ◽  
Jutta Kösters ◽  
Stefan Seidel ◽  
Yoshiki Kuwata ◽  
Hisashi Kotegawa ◽  
...  

Abstract The equiatomic metal-rich phosphide NbCrP shows a structural phase transition around 125 K. The structures of the high- and low-temperature modifications were refined from single crystal X-ray diffractometer data of an un-twinned crystal: TiNiSi type, Pnma, a = 619.80(2), b = 353.74(4), c = 735.24(6) pm, wR = 0.0706, 288 F 2 values, 20 variables at 240 K and P121/c1, a = 630.59(3), b = 739.64(4), c = 933.09(5) pm, β = 132.491(6)°, wR = 0.0531, 1007 F 2 values, 57 variables at 90 K. The structural phase transition is of a classical Peierls type. The equidistant chromium chain in HT-NbCrP (353.7 pm Cr–Cr) splits pairwise into shorter (315.2 pm) and longer (373.2 pm) Cr–Cr distances. This goes along with a strengthening of Cr–P bonding. The superstructure formation is discussed on the basis of a group–subgroup scheme. Electronic structure calculations show a lifting of band degeneracy. Protection of the non-symmorphic symmetry of space group Pnma is crucial for the phase transition. The estimated charge modulation is consistent with the interpretation as Peierls transition.


2013 ◽  
Vol 114 (7) ◽  
pp. 073704 ◽  
Author(s):  
Vinod Kumar ◽  
Rajesh Kumar ◽  
D. K. Shukla ◽  
Sanjeev Gautam ◽  
Keun Hwa Chae ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document