Interfacial energy between γ/γ′ phases of Ni–Al alloys extracted by using a new method

Investigations which require electron microscope examination of a few specific areas of non-homogeneous tissues make random sampling of small blocks an inefficient and unrewarding procedure. Therefore, several investigators have devised methods which allow obtaining sample blocks for electron microscopy from region of tissue previously identified by light microscopy of present here techniques which make possible: 1) sampling tissue for electron microscopy from selected areas previously identified by light microscopy of relatively large pieces of tissue; 2) dehydration and embedding large numbers of individually identified blocks while keeping each one separate; 3) a new method of maintaining specific orientation of blocks during embedding; 4) special light microscopic staining or fluorescent procedures and electron microscopy on immediately adjacent small areas of tissue.

Download Full-text

Observation of faint contrast at planar faults in alloys

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100108842 ◽

1978 ◽

Vol 36 (1) ◽

pp. 340-341

Author(s):

K. Kuroda ◽

Y. Tomokiyo ◽

T. Kumano ◽

T. Eguchi

Keyword(s):

Reciprocal Lattice ◽

Beam Theory ◽

Al Alloys ◽

Small Displacement ◽

Electron Microscopic ◽

Lattice Vector ◽

Fringe Contrast ◽

Planar Fault ◽

Lattice Displacement ◽

The Many

The contrast in electron microscopic images of planar faults in a crystal is characterized by a phase factor , where is the reciprocal lattice vector of the operating reflection, and the lattice displacement due to the fault under consideration. Within the two-beam theory a planar fault with an integer value of is invisible, but a detectable contrast is expected when the many-beam dynamical effect is not negligibly small. A weak fringe contrast is also expected when differs slightly from an integer owing to an additional small displacement of the lattice across the fault. These faint contrasts are termed as many-beam contrasts in the former case, and as ε fringe contrasts in the latter. In the present work stacking faults in Cu-Al alloys and antiphase boundaries (APB) in CuZn, FeCo and Fe-Al alloys were observed under such conditions as mentioned above, and the results were compared with the image profiles of the faults calculated in the systematic ten-beam approximation.

Download Full-text

Microstructure of an extruded rapidly solidified Al-8Fe-2Mo alloy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100144218 ◽

1986 ◽

Vol 44 ◽

pp. 548-549

Author(s):

W. T. Donlon ◽

J. E. Allison ◽

S. Shinozaki

Keyword(s):

Electron Microscopy ◽

Automotive Industry ◽

Fuel Economy ◽

High Strength ◽

Al Alloys ◽

Light Weight ◽

Thin Sections ◽

Strength And Durability ◽

Rapidly Solidified ◽

Whitney Aircraft

Light weight materials which possess high strength and durability are being utilized by the automotive industry to increase fuel economy. Rapidly solidified (RS) Al alloys are currently being extensively studied for this purpose. In this investigation the microstructure of an extruded Al-8Fe-2Mo alloy, produced by Pratt & Whitney Aircraft, Goverment Products Div. was examined in a JE0L 2000FX AEM. Both electropolished thin sections, and extraction replicas were examined to characterize this material. The consolidation procedure for producing this material included a 9:1 extrusion at 340°C followed by a 16:1 extrusion at 400°C, utilizing RS powders which have also been characterized utilizing electron microscopy.

Download Full-text